0
Chevy Camaro
This category covers general questions about the Chevrolet Camaro, a pony car manufactured by General Motors and sold through its Chevrolet division. The Camaro was designed to compete with the Ford Mustang. Production of the model began in 1966.
4,208 Questions
Where is the fan relay located on a 1988 Z28 305 Camaro?
if your standing in front of the car with the hood up, it's stuffed into the little space between the battery and the radiator. its bigger then a standard bosch relay. it is about 3/4" x 1 1/2".
Why does your 1990 Chevy Camaro rs redline then bog when you drive it?
Plugged fuel filter? Plugged air filter? Plugged catalytic converter?
Where are the turn signal and the 4-way or hazard flashers located on a 1997 Chevrolet Camaro?
The hazard flasher is normally located in the fuse block under the dash. The turn signal flasher is normally mounted on the backside of the dash. The flashers are round and has 2 prongs.
How to remove the headliner in a 1996 Chevy Camaro non t top?
Here is a site that gives step-by-step instructions and pics to help.
http://www.wlsheadliners.com/tutorials/camaro/OK, just finished this job on my 1994 Camaro (non T-top) Z28 and had to wing it. The following addresses the mistakes I made. This is the same as the process on the 1996 Camaro.
This is best done as a 2 man job!
Most important thing to note is that on the date of my post, Chevy only has 5 headliners left, and they are no longer manufacturing this part. Date: 1-19-2008
How to replace the headliner:
1) Remove all cabin lights and visors using a #2 Phillips head screwdriver. Note that you MUST use a #2 to remove and replace these screws as they will strip if you use a #1.
Note: When removing cabin lights, be sure to disconnect them, rather than letting them hang as they will probably be damaged.
2) Pull down on the front and back center (by the rearview mirror and rear cabin light you've just removed) of the headliner to remove it. Note: To minimize dust and fibers, be sure to slide the seatbelts through the precut slots rather than rip or force the original headliner out.
3) Using a flathead screwdriver, remove the interior door trim on the driver's site, from the uppermost point (just behind the driver side seat). You should encounter two (2). Continue down to the first clip of the windshield beam by gently pulling to your right to remove that clip. Note that you'll only have to slat this one back into position later.
NOTE: You should NOT need to remove the passenger side to install the new headliner, but if it makes you feel better to do so, feel free to repeat step 3 on the passenger side.
4) Lay both the driver and passenger seats all the way back and put the new headliner into the Camaro. From the driver side, it is best to maneuver the headliner in back-end first with the unfinished side to your left. Push it into the car at a 45 degree angle turning in into position over the seats.
5) While one person holds the headliner up, the other should pull down gently on the rear passenger side cosmetics and feed the seatbelt through the cut allowing the headliner to fall into position. DO NOT PUSH UP ON THE HEADLINER AT THIS POINT. The Velcro will attach and could be damaged when you have to remove it.
(It is best to push the headline further in than it will actually have to go, so you can clear the cosmetics on the driver side on the next step.)
Push the headliner into place between the frame and the passenger side door trim making sure the fabric goes in smoothly, all the way to the front of the car.
6) Feed the driver side seatbelt through the cut in the headliner and repeat step 5 on the driver side.
7) Reinstall the driver side door trim over the new headliner.
8) Reinstall visors and cabin lights.
YOU'RE DONE!
Hope this helps!!! :)
Where is the fuel pump fuse located on a 1992 Camaro?
It's probably under the hood. There may be a fuse box near the battery but that fuse is probably behind a cover behind the engine, near the top of the firewall.
How do you retrieve the check engine light in a 1981 Z28 Camaro?
The system you have on your Camaro is the one of the first system Chevy had where a computer was used. This system uses what was called the "CCC" (Computer Control Command) system. You should have a small flat 5 pin connector under the left side of the dash. This will hold trouble codes that are present when the check engine light is on. With this early system you cannot jump across terminals to read the codes like the later (OBD I) systems. If you have a Snap On MT2500 scanner or know a shop that has one, they will be able to use MULTI-1 connector to plug into the 5 pin block and read your codes.
Although this is old technology most any quality technician can read your codes for you. My experience is that when the check engine light comes on on those early models it's usually related to the EGR system in some way.
Good luck.
How much horsepower does a 1969 camaro ss have?
Depends on motor if it has a stock 350 small block probably about 290-320
Where is the cooling fan relay on a 1986 Camaro?
I have a 86 camaro with a 2.8 L . The cooling fan relay on mine is located above the brake master cylinder and is bolted onto the firewall with two 9/32" bolts. There are two relays beside each other and the one for the cooling fan is closest to the fender. If you disconnect the harness from the relay, you can use a wire to jump across the hot terminal to the others one at a time until the fan turns on the check that this is the correct relay for your car.
What is the difference between a LS Camaro and a 2LT Camaro?
LS is the base model (only manual available). 2LT is the highest V6 model you can get. It is available with leather interior and the RS package. Go to Chevrolet.com/camaro to learn more.
What is the firing order for a 1994 Chevy Camaro 3.4L?
1-6-5-4-3-2 Its 135 on pass 246 on driverside 123456
Are Chevy Camaro's reliable cars?
Yes and no, the new ones are not as reliable as the older ones were in their prime.
Can you take the catalytic converter off of your 3.8 Camaro?
No, it's illegal to remove the converter. Besides the engine will not run correctly with the converter removed.
How do you replace the turn signal switch located on a 1986 Chevy Camaro?
it's under the dash on the drivers side there are 2 under there one for the blinker and another for the emr. lights the one for the turn signals is cloest to the door i believe.
Can you put a crate engine that is a Chevy engine into a 2000 Camaro 3.8 V6?
Yes, I could.....but not having any idea who you are or your abilities, and apparently they are somewhat limited according to your question, I don't know if YOU can perform such a task.
Answeryou could put any Chevy engine into any camaro, that's what it was designed for, "big engine cheap box" was one of their original slogans pitched around, the problem comes in with lining up all the components, switching from a V6 to a V8 you would need to move motor mounts, beef up your suspension, get a bigger radiator, probably a different transmission to handle additional torque, probably new computer and wiring, new exhaust components, and probably 3 or 4 other things that I've forgotten, possible, but certainly not easyPrimer is a base coat that can accept all types of paint so no stripping is necessary and you can definitely primer over primer but remember to fill and sand before to eliminate blemishes and maintain a smooth finish.
How do you replace the blower motor in a 1993 Camaro?
Remove the wiring harness from the back of your 1993 Chevrolet Camaro blower motor. Remove the blower motor retaining nuts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
Theres bound to be changes but for the most part the only think it comes to mined Motor Mounts.
What is the fuel pressure on 1989 Camaro 350 tpi?
The 1989 Camaro didn't have a 350 TPI (not stock, anyway)
How do you turn off the governor 2010 Chevy Camaro?
You can't "turn off" the governor, it's computer controlled. Some performance chips may be able to override it but could void your warranty (among other things) - it's up to you if you feel it's worth the risk.
How much horsepower does a 2.8 liter V6 camaro engine have?
The 2.8 v-6 has 110 and the 2-5 inline has 85
