What is the firing order for a 1972 Chevelle?
All V8 engines have the same firing order. 1,3,5,7 is the left bank, 2,4,6,8 is the right bank and the distributor rotates clockwise. 1,8,4,3,6,5,7,2
How do you change the rear main seal on a 283?
The oil pan has to come off for this. Remove the oil pan. then remove the oil pump and pump drive rod. Remove the rear main cap. You will have to use a screwdriver or something to push the seal through enough to pull it the rest of the way out with pliers... Be careful not to scratch the crankshaft. Lube the new seal with oil and work it in to the block. On the cap itself, pull off the old one and slide on the new one. This takes care and patience because the half that goes into the block will most likely NOT move very easily! I't NOT a fun or easy job, which is why people usually don't replace them unless they have then engine out of the car AND the crankshaft removed.
How do you change front brakes on 1972 Chevy Chevelle?
get a chiltons repair manual for chevelles and read up.
Will a rear from a 71 Chevelle fit your 70 skylark?
It should as they are both the same frame and are A-bodies.
Will a 1967 Buick Skylark frame fit a 1967 Chevelle 2 door?
should be the same identical frame as they are both A bodies.
Spark plug gap for 1975 Chevy Chevelle 400 small block?
that should have the HEI distributor so the plugs should be set at .045
Will a 1964 Chevelle 4 door frame fit under a 1964 Chevelle 2 door body?
measure the two wheelbases to find out, if they match then yes, if no you can extend or shorten the frame.
1964 Chevelle, 2 door or 4 door, hardtop or sedan frames interchange. Convertible will fit but the 2 door or 4 door, hardtop or sedan will not fit the convertible.
Where do you put the power steering fluid in a 1970 Chevelle 454 SS?
the fluid reservoir is right in the pump itself. In the front look down just to the right of center or so. The power steering pump is connected to the pulleys and belts, the pump has a cap you unsrew and fill at the neck.
the fluid reservoir is right in the pump itself. In the front look down just to the right of center or so. The power steering pump is connected to the pulleys and belts, the pump has a cap you unsrew and fill at the neck.
How do you change shocks on a 65 Chevelle?
undo top bolts on the shock and then undo the bottom bolts and remove, just reverse installing. Make sure you support the A-arms and/or axle when changing the shocks. The shocks themselves are used to limit the suspension travel.
Is 70 Chevelle frame the same as 70 Monte Carlo?
Yes... Sort of anyway. The Monte Carlo uses a 4 door Chevelle frame even though the Monte Carlo is a 2 door car. The 4 door frame is longer than the 2 door Chevelle frame. and the wheelbase is 4 inches longer. So if you have a Monte Carlo, a 4 door Chevelle frame will work. If you have a 4 door Chevelle, a Monte Carlo frame will work. If you have a 2 door Chevelle, then you will need to use a frame from ANY 2 door GM A body except for the Monte Carlo.... The Tempest/Lemans/GTO, Cutlass, Skylark, and Chevelle all used the same frames and are completely interchangeable.
How do you remove the glove box lock assembly from a 1971 Chevelle without the key?
If no key, you'll have to destroy the cardboard glove box and to access the lock bracket....remove the upper bracket that the lock grabs onto located at the mid-top of the opening...may need to do a little prying....or remove the lock from the backside.
Which is better a Chevrolet or a ford?
A Chevy may appear better at times but later on down the road it's really not . All that it really is, is that fords are made with better parts and quality parts at that,which makes them run longer,and better.Basically fords are better hands down.
Is there such thing as a 1970 Chevy Chevelle SS 454?
Oh yes!!! There were two engine options for the 1970 Chevelle SS454. The LS5 was a mild, hydraulic lifter engine rated at 360 HP. The LS6 was a solid lifter fire breather rated at 450 HP.
Where is the oil sending unit on 66 Chevelle 396 four speed?
In the engine block right above the oil filter.
Where is THE ignition coil resister located on a 1967 Chevelle?
look for the small braded wire coming out of the fusebox under the hood and that is the resistor wire.
What does the wiring diagram for a 1966 Chevelle look like?
get a chiltons repair manual at the library for your vehicle.
Will a front end from a 1979 camaro fit a 77 Chevelle?
No. COMPLETELY different body shape. While I'm sure it's possible, it would take a LOT of modification to the front end AND the Chevelle body. And I mean a LOT of modification.
How to set distributor on Chevy Chevelle?
You need to pull out number one spark plug put finger over hole when you fell compression that will be top dead center timing mark on damper wheel should be on timing mark . Install distributor with rotor pointing at number one plug on cap. May have to use long screwdriver in hole to line up oil pump to distributor.
How do you remove the ignition rotor screw on a 1995 Nissan Pathfinder?
the d6p84-01 v6, and the d4p84-04 four cylinder engine distributors on 1986 and newer pathfinders cannot be rebuilt. if there is a problem then the whole assembly must be replaced.
junkyard from the south, E-bay, or craigslist, or a local swap meet.
How rare is 1971 Chevy chevelle?
it depends on what color or engine you have in it. if it is a 454 with colors that you wont usually see on a 1970's chevelle without a paint job just a factory color, then you might have a rare 1971 chevelle
Are Chevelle ss rims and regal rims the same?
No, but they are close. The spokes are slightly different. The center caps are different. Regal rims are usually chrome plated and charcoal gray or black. Chevelle SS wheels are painted argent and charcoal gray. Regal rims usually don't have trim rings and Chevelle SS wheels do. Not huge differences, but you can easily tell the difference even when they are installed on the car. Chevy only used the magnum 500 style SS wheels in 1969 and 1970. They DID use them on Novas, Camaros, and Chevelles though.