Chevy Corvette

If it is a 350 V8 the firing order is 1-8-4-3-6-5-7-2 All V8 Chevrolet engines have the same firing order. 1,3,5,7 is on the left side and 2,4,6,8 is on the right with the distributor turning clockwise.

The Fuel pump is located inside the gas tank with the fuel level sending unit.

firing order is the same for all sbc (first gen)

The Sting Ray was produced 1963 through 1967. When the body style was changed for 1968, the Sting Ray emblems disappeared. In 1969, the Stingray returned to the car but this time spelled as one word, Stingray. The last Corvette to carry the Stingray emblem was the 1976 model.

1984, Corvette the fuel gauge stays at 1/2 full all the time. Plaese help.

Remove fuel filler door on back lid of your vette. Remove rubber boot. Remove 4 screws on hard plastic protecter plate you can then see the fuel pump removal plate. unhook fuel lines. take out all ten bolts on filler pump cover remove fuel pump and replace always replace screen on fuel pump and at front of your corvette under frame rail at location on outside of passengers feet area you will see fuel filter on fuel line rail always good to replace it too. Be safe keep fire suspression equiptment nearby this is a highly saturated fuel cell. re place in oppisite order Reccomend too unhook battery before you start this project

It is possible but you might want to wait a while for a baby like that

Check your fuses first and then check your relays. Then the bulbs and then the switch! If that doesn't work, scoot on over to Smokinvette.com and post this question in the C5 technical section. Good luck!

either a ruptured heater core or a bad hose/ connection on either end, either way u have to take it out.

Of course! As long as the clutch is depressed. It well start in any gear. You just won't have enough rpm's in the other gears to keep it running. Unless you the the engine before you release the clutch. I don't suggest doing so if you are an unexperienced driver.

I would expect $100-150.

It is in the tube going into the evaporator. You must disconnect the tube from the accumulator.

Vicky Vette was born in Stavanger, Norway in June of 1965. Vicky Vette is a popular pornographic actress and runs her own website called VNA network with other adult actresses.

They were built in a plant in St. Louis up until the middle of the 1981 model year. The 1981 Corvette was the only model built split between the St Louis plant and the Bowling Green plant. The last 'Vette built in St Louis were also the last cars painted with lacquer, at Bowling Green the cars were painted with two step enamels.

Yes

Remove the bottom hose from your 1995 Chevy Corvette radiator. Allow the coolant to drain out. Put a hose into the top of the radiator. Run water through the radiator until it runs clear.

1953, there were only 300 hand-build Corvettes made that year, making them the rarest & most value ones.

It is located on the drivers side of the radiator in the engine bay.

If not tight enough to seal it will leak.

THE LOWER THE NUMBER THE LOWER THE RPM'S. THUS BETTER MILLAGE. SO THE 2.56 WILL GIVE U LOWER RPM'S. THUS BETTER GAS MILAGE.

6 degrees BTDC.

1 8 6 3 4 5 7 2 good luck.

The front bumper is pretty easy to take off, as long as the bolts arent rust fast. The first bolts to take out are the ones holding the bumper guards in place they are down under the fiberglass felance. Then unbolt the two side bolts, then unbolt the two center bolts.

RJ Sottilewww.hobbycarcorvettes.net

It will be allot easier if you can get it on a lift. Second best will be a good jack and jack stands. Then there is a plug on the right side of the tranny that you can drain the fluid from. Once it's all drained out you can start to refill it. You know it's full when the fluid starts to drizzle out while your putting it in! If you need a little more help jump over to Smokinvette.com and you can find diagrams of the entire procedure! Good luck!

Mid-America Motorworks sells a tool for this.