Chrysler 300 Series

The 2014 Chrysler 300 has a 10 ft. 0.2 in. (120.2 in.) wheel base.

Yes. The Hemi needs 5W20 for the MDS system. The V6's need 5w30.

At the top of the 300 lineup is the SRT8 version, which is intended for serious performance enthusiasts. The 300C SRT8 comes equipped with a 425-hp, 6.1-liter V-8 that allows the SRT8 to run from 0 to 60 in under five seconds. Larger wheels and brakes and a firmer chassis give the SRT8 model a track-ready demeanor that we find quite appealing.

The state of Arizona now has an interactive website where you can run the plates (I assume that's just for AZ, but could be wrong) and the VIN on a car. Go here:

See the related link below.

You can also call your local PD and they will run it for you. You don't need to pay for CarFax or any of those services just to check to see if the vehicle is stolen; you will if you want a total vehicle history report. Good luck.

Red, five year, hoat type.

The IAC motor is held in place with 2 small screws on the side of the throttle body. Remove the 2 screws the electrical connector and clean the port thoroughly before installing the new one.

in the trunk,where you would find the spare tire

V6, it is under the housing where the lower radiator hose attaches to the engine.

V8, it is under the housing where the upper radiator hose attaches to the engine.

A stall occurs when the cycle of an engine is slowed down temporarily, or more commonly, to a complete stop. In terms of automobiles, a stall can happen with both manual and automatic transmissions. In the common case of a person releasing the clutch to quickly, a large load is applied to the engine from the crankshaft when the clutch is released. The transmission must rotate in the same direction and at relatively the same speed in order to reduce the load, thus keeping the engine running.

I have a 1999 Chrysler 300M. It gets about 22mpg with our around town/highway driving mix of about 70/30.

The Enhanced Warning System (BeltAlert) can be enabled

or disabled by your authorized dealer or by

following these steps:

NOTE: The following steps must occur within the first

60 seconds of the ignition switch being turned to the ON

or START position. DaimlerChrysler does not recommend

deactivating the Enhanced Warning System

(BeltAlert).

1. Turn the ignition switch to the OFF position and

buckle the driver's seat belt.

2. Start the engine and wait for the Seat Belt Warning

Light to turn off.

3. Within 60 seconds of starting the vehicle, unbuckle

and then re-buckle the driver's seat belt at least three

times within 10 seconds, ending with the seat belt

buckled.

NOTE: Watch for the Seat BeltWarning Light to turn on

while unbuckling and off while re-buckling the seat belt.

It may be necessary to retract the seat belt.

Timing belt.

SwatchBattery has a lot of coin type batteries. http://swatchbattery.com/ . My 2002 300M remote uses a CR2016 (3volt) battery which they carry.

I have a 1993 Lebaron with 3.0 Liter and Automatic. I get between 23-26 mpg.

there are 2 sensors. if your speedometer is inop replace the output speed sensor in trans drivers side. both look the same output is the one towards the rear.

3.5 has a belt. All others have chains.

Trouble code P0441 means:Evaporative emission control system incorrect purge flow

Could be,E-Brake slightly applied,

Sticky E-Brake cables,

E-Brake out of adjustment,

Brake fluid reservoir low,

Brake system in need of maintenance,

The Enhanced Warning System (BeltAlert) can be enabled

or disabled by your authorized dealer or by

following these steps:

NOTE: The following steps must occur within the first

60 seconds of the ignition switch being turned to the ON

or START position. DaimlerChrysler does not recommend

deactivating the Enhanced Warning System

(BeltAlert).

1. Turn the ignition switch to the OFF position and

buckle the driver's seat belt.

2. Start the engine and wait for the Seat Belt Warning

Light to turn off.

3. Within 60 seconds of starting the vehicle, unbuckle

and then re-buckle the driver's seat belt at least three

times within 10 seconds, ending with the seat belt

buckled.

NOTE: Watch for the Seat BeltWarning Light to turn on

while unbuckling and off while re-buckling the seat belt.

It may be necessary to retract the seat belt.

Trouble code P1789 means: Hydraulic Pressure Switch: OD/2-4

There are plenty of websites that have the information you need to determine this. One site is rimhelp.com. You need to compare bolt pattern, hub diameter and backspace. The bolt pattern and hub diameter will tell you if it will physically fit. If the hub diameter is smaller it won't fit and if it is bigger you probably need a spacer. The wheelsize and the tire size you choose should match or at least be close to the OEM size so it doesn't mess up your speedometer.

Gates ( they make timing belts etc. ) lists a TIMING BELT for the 3.5 L - V6 engine in

a 2004 Chrysler 300M

Yes.

Yes.

Break a window fooo

Great fun! Start car, turn steering wheel fully to the right Open hood, disconnect remote battery terminals, remove air intake filter box, remove vented panel inside front of right wheel well, disconnect exposed battery terminal, slide battery aft until other terminal is exposed, disconnect the other terminal, slide battery aft and out into wheel well. reverse order to install