Dishwashers

Probably. It will depend both on the plastic the bottle is made from and its intended purpose.

Because it's overloading the circuit it's on when it starts up. A dishwasher heats up the water it uses like a mini water heater. It takes a lot of current to do this. Most circuit breakers trip at 20 amps. If you already have 15-18 amps of equipment operating on that circuit, when you turn on the dishwasher, it will trip the breaker. Check to see what circuit your dishwasher's on, then check to see what other big-load equipment you have on that circuit ( e.g. washer, dryer, freezer, water heater, heat pump, etc.). You'll have to turn something off to get the total circuit load down below 20 amps while you're washing dishes. Alternatively, you can have an electrician install a bigger breaker and modify your service to safely carry the load you're asking it to carry.

I know very early examples of the automatic dishwasher go back to the 1920's, if not earlier, but it did not "break out" as a must-have home appliance until after World War II.

yes, they are dishwasher safe but perfer handwashing so you dont ruin the wires

being a dishwasher is very hard work, especially in a busy restaurant

The electricity. -Turn the breaker OFF first.

Yes she did.

Where are kitchen aid double draw dishwashers made

If the dryer has a button that says "Push to Start", and you push it and nothing happens, the centrifugal start switch is bad. If you can get to it, and it is an "assembled" switch (as opposed to molded or sonically welded), you can disassemble it and clean it with electrical contact cleaner (available at the large retailers). That will fix it for awhile - possible a long while. But it is not terribly expensive, and to order the factory specified replacement switch for it online is a permanent fix.

Usually the dishwasher is located near a sink. If you run the hot water at the sink, that will flush the cold water from the hot water line, so the dishwasher will end up getting more hot water during its fill, and allowing the water to reach higher temperatures. Use the "Heated Wash" option to ensure maximum temperature increase. Dishwasher detergent works best around 145 degrees, so the hotter the water going in, the better it will clean.

No, rust is not harmful. However, it's not helpful, either. And, if your dishwasher's racks are the source of the rust, they may need replacing, or you may want to consider replacing the dishwasher entirely (racks tend to cost around $100-150 each). Consider a model with nylon racks if replacing the entire dishwasher.

Maybe, but definitely if you can't come up with other ideas for breaking it although I think an easier way to break it is to just slam it on the ground a few times. =）
No

Possibly at your local appliance parts store, or online.

In centre of the base.

The door seal is broken. It's replacable, but can be picky to fit.

It may melt, then you will have real problems.

Yes, they do.

energy star

One that fits under the countertop and is hard wired.

It would of cost around £1000 and were invented in the 60s or 70s I think but not sure on invention time

give her a shovel

Yes because your dishwasher is connected under your kitchen sink in most cases. You also need a 2" drain line and trap and 1/2 cold/hot water lines.

No it isn't! Just mix the dishwasher gel with a certain amount of water and thats it!

140 f