Electrical Engineering

To limit the rate at which the charge is put into the battery in order to prevent overheating, boil-out of the water in the acid electrolyte, and eventually ruining the battery.

This is far too complicated a subject to be answered in this forum. I suggest you do some research on the internet, or obtain an appropriate textbook on the subject.

in 4 point starter we use a protactive rasistance to control the speed of motar in 3point starter speed is uncontolled

Yes, you can change the diode configuration. a diode will only let electricity flow in one direction. See also Delta- Y, and whetstone bridge.

If the amperage is very low, the effect is "shocking". It won't cause any serious harm to a person, but might make them jump.

This can cause damage to electronic equipment, though; this is why it is important to ground yourself (using wrist straps oftentimes) when working on electronic equipment.

If you want to find it on your own, apply an increasing reverse voltage to the diode until a large current flows. If you do this, put some sort of resistor in series to prevent overload. This will ruin the diode.

Or you can check the data sheet. a good search for the particular diode you are using should help, or you can go to the company who sold you the diode and they should have a data sheet readily available. There should be a graph showing reverse current vs. voltage. There should also be a line in the data sheet that says peak reverse voltage which may be easier for you to follow and understand.

Alternating current is better than direct current for transmission.

910 cranking amps 700 cold cranking amps

Yes, when using a step down transformer the amperage is affected.

silicon

generally generator is used to generate power whether it is AC or DC . to generate energy it is necessary to rotate armature at constant speed . it can be achieved by motor or any engine.

Voltage Security changes the data protection paradigm by delivering data-centric security to protect data as it is used and moved across an enterprise, throught the cloud, over mobilde devices, and within big data environments.

The only place I remember a self reseting circuit breaker on my 67 is the line the feeds the power convertible top. But in general, most parts stores have circuit breakers like that, you simply need to know how large (how many amps) you want to buy.

A depletion mode MOSFET is a FET that is on with no gate bias, and requires a negative bias (with respect to the source) to stop conducting. The channel is normally conductive and with a negative gate bias the channel becomes "depleted" of charge carriers, hence the name depletion mode MOSFET.

This is contrary to enhancement type MOSFET's that are non conductive with zero volts gate bias and become conductive when there is a positive bias on their gate.

Accirding to the vast majority of the studies, the short answer is "No". A small number of studies show some indications of relationship. It is extremely difficult in science reports to say that you are sure 100% (not 99,99%) that "something" DOES NOT cause "something other".

Because they get very hot, they can scorch fabric, burn hands, and create a fire hazard. The electric steam iron has similar disadvantages but can operate at a lower temperature.

Try E-lance.com

Online freelance company. They're supposedly good at keeping your inventions confidential I've heard. Check into it

turbidity is pollution, thus runoffs and fertilizer and anything that makes up pollution is turbidity.

discomfort in the operated ear and the throat (from the breathing tube inserted during surgery), which can be controlled by such analgesic medications as meperidine