Electronics Engineering

Capacitance in mosfet is of three types:

gate capacitance

diffusion capacitance

routing capacitance

Gate capacitance: limits the speed of the device t which it can be operated

Diffusion capacitance: It is the capacitance due to charge carriers between drain and source.

Routing capacitance: It is the capacitance of the metal which is deposited on the top of oxide layer.

first you demand the blowjob, then they supply it!

1. pass the inputs through an nand gate and again pass them through inverter,which is again formed by an nand gate

Light Emitting Diode or LED

Microwaves travel in a straight line making them easy to send and receive.

An isolation transformer (or more commonly, amplifier) reduces noise in the system from the power source. This is especially necessary in medical applications where the signals that are being read are very tiny and even a small amount of noise can disrupt a signal and make it unreadable.

its by an Indian singer imran khan

It is not possible to give an answer to this question without much more information. The information given (e.g. 1.5 volt weather radio) is unrelated to battery life.

The tools that are used to perform the process of PCB etching when done at home are things such as Muratic Acid, Hydrogen Peroxide, a laser printer, PCB drill bits, quality magazine pages, a one ounce copper clad, and lacquer thinner.

Because -- they are?

Or, more specifically, because the particles within cathode rays act exactly like electrons. They either ARE electrons or they do a REAL good job of imitating them.

preset is an asynchronus i/p for flipflop. so it is not depending on the clock signal. so if i keep preset high in any flipflip it will gives me the o/p as high. but when i use the normal i/p in the flipflop it will give the at the edge of the fliplop..

mech. engg is reqired 4 aeronotics...........chek the eligibilty criteria in coleges

It will be dissipating more power than a small signal diode.

In simplest terms it is a power reserve. It stores power and releases it very quickly when your amplifier needs it, such as to deal with a large/sudden amount of bass.

in passive circuit it depends on the type of load 1. if the load is purely resistive the voltage and current will be in phase 2.if the load is purely inductive the current lags the voltage by 90 dgree 3.if the load is purely capacitive the currents leads the voltage by 90 degree

yes

With quasi-integration, a firm internally produces less than half of its own requirements and buys the rest from outside suppliers.

True.

Some of these computers used hybrid integrated circuits (e.g. IBM System/360) and some used monolithic integrated circuits (e.g. Apollo Guidance Computer, Minuteman II Guidance Computer)

Direct current, as opposed to alternating current.

Electronic Communications Networks (ECNs) are alternative trading systems that function much like stock exchanges--collecting, displaying, and automatically executing customer orders.

Hitachi used to be made in Japan, but it is now made in China.

Air Condition, Heat, Air Vents, seat position, and steering wheel

A: BIG DIFFERENCE emitting is the study of electronics conduction is the study of current flow

the circuit might not operate properly. but shouldn't effect the circuits them self.

There is no such a thing as a thermocouple volt meter. A analogue or digital millivolt meter or volt meter is connected across a shunt or parallel with the shunt to measure the current through the resistor. Say the resistor value = 1 Ohm, then by using the Ohm law formula to calculate the current, say the voltage (voltage drop), read on the volt meter is 1.5 Volt that is R*V = A that is, 1Ω*1.5V = 1.5 Amp.

Any type of DC volt meter, analogue or digital can be used to measure the voltage across a capacitor if the value of the capacitor is large enough that reading will be true RMS. as long as the supply current (EMF Power) are larger than the load current.