0
Ford 500
The Five Hundred is a full-size four-door sedan manufactured by Ford from July 2004 to April 2007. Based on a Ford D3 platform, the car is equipped with a 3.0-liter Duratec 30 V6 engine and a 112.9-inch (2,868 millimeter) wheelbase.
329 Questions
Where is the number 3 cylinder on a 2006 ford 500 duratec engine?
On a 2006 Ford Five Hundred , 3.0 liter " Duratec " V6 engine :
firewall
1-----2-----3
4-----5-----6
front of vehicle > driver
How do you remove the panel to get to the fuel reset button on a 2005 ford 500?
The Owner Guide shows " the fuel shut off switch is in the front passenger
footwell area , in the right upper corner " it doesn't state anything about it
being behind a panel
How do you change the brake light on a 2006 Ford 500?
Changing the brake light on a 2005 Ford 500 requires first exposing the light fixture. Locate the housing panel and uncover. Push and twist to remove the necessary light bulb socket for replacement.
What size are wiper blades for a 2005-2007 ford 500?
The 2005-2007 Ford Five Hundred takes 24" driver side and 20" passenger side replacement windshield wiper blades.
Where is the keyless entry code located on a 2005 ford 500?
Should be located behind the driver's door panel on control box
You need a special tool, which is pretty commonly available. It is a disk with a 3/8" square hole in the center, and two pegs on one side. The pegs fit into corresponding slots on the piston, and you ratchet the pistons back into their seats. I can't remember which direction they turn, but I think it is clockwise.
Ford 500 all wheel drive problems?
how hard is it to change the oil pump in the transfer case in a 2006 ford 500 awd
Does the Ford 500 have a fuel reset button?
Yes, it is located behind a panel on the lower passenger side floor/side panel. It snaps
in place and removing it reveals the re-set button up approximately 8'' off the floor behind the side panel.
How do you replace ford fivehundred rear wheel bearing hub?
Jack up car and remove wheel. Remove the two anchor bracket bolts for the caliper (this method does not require unbolting the caliper). Remove the one bolt that holds the brake disk on the hub assy. Hang the caliper/bracket, pads, disk out of the way. Remove the dust shield. Get some rust remover and wire brush to clean off the ends of the 4 bolts that secure the hub assembly. They protrude 1/4" through the threaded holes on the hub assembly, work them out carefully. After the 4 bolts are out, pry out the hub assembly, be aware of where the ABS sensor is, dont damage it prying the hub out.
Clean off all mounting surfaces, scrape out the corrosion in the hub assy pocket. Insert new hub, draw it in square alternating bolt tightening. install dust shield, brake disk, caliper/bracket, wheel and your done.
Need a T40 torx for the brake disk. need a box end wrench for all 6 of the bolts you have to remove (15mm?) 6 point would be best. It took me an hour and a half per side because I didnt want to damage the hub mounting bolts (due to the rusted ends) and took my time.
What are pros and cons of directional tires?
"directional tires" refers to tire with eitherasymmetrical or rotational tread patterns.
Pros of rotational tires:
1) generally better resistance to hydroplaning than traditional tread patterns
2) generally better stopping than traditional tread patterns
3) generally better heat dispersal than traditional tread patterns
4) typically look pretty nifty
Cons of rotational tires:
1) cannot "cross" during tire rotation
2) if used for a full-size spare, likely to lose benefits in "pros"
3) Are more likely to be "performance tires" (check with your tire seller) with a shorter expected tread life than some other tires. This is not always so.
Pros of asymmetrical tires:
1) Typically better cornering stability
2) Allows for multi-compound tread for reduced shoulder wear (longer tread life at the edges) and better temperature control
Cons of asymmetrical tires:
1) must be replaced exclusively in pairs (axle sets) to prevent 'tire pull'
How do i find the keyless code for a 2005 Ford Five Hundred?
The code is on the computer module under the dash on the drivers side. Look for a small black box. You will probably need a mirror to see the 5 digit code on the back of the box.
What is th oil capacity of a Ford 6.0 diesel?
ford diesels take 14 liters doesn't matter if its 6.0 liters or 6.4 most diesels take 14 liters some of the older diesels take about 10 liters
How do you reset the oil change light on a 2007 ford five hundred?
IF you have the black buttons on the steering wheel, on the RIGHT side, I believe the RESET button gives you the option to do the System Check. When the Oil life appears on the screen hit the RESET button again. A screen will then show up asking if you want to reset the oil life to NEW, if so select RESET again. The timing is very hard. It took me 3 tries my 1st time.
http://wiki.answers.com/How_do_you_do_Oil_reset_on_a_2005_ford_500#ixzz18Fm9GgtM
What is the bolt pattern for a 2005 ford five hundred have?
5 x 114.3 Offset: 34-50mm
Center Bore: 63.3
Hardware: 12 x 1.50
Why doesn't my 2006 ford 500 driver side seat heater work?
TSB 06-2-11 deals with this. You have to replace the seat cushion heater pad, and re-route the harness for it.
TSB 06-2-11
02/06/06
HEATED SEATS INOPERATIVE
FORD:
2005-2006 Five Hundred, Freestyle
MERCURY:
2005-2006 Montego
ISSUE
Some 2005-2006 Freestyle, Five Hundred, and Montego vehicles built through 11/22/2005 may exhibit a non-functioning heated driver's seat. This may be due to seat cushion heater harness becoming trapped between the track torsion bar and the cushion when the seat is in the rear tilt full down position. This may cause the solder joint at the seat heating pad to separate.
ACTION
Replace seat pad with new part and reposition harness. Refer to the Service Procedure.
SERVICE PROCEDURE
1. Refer to Workshop Manual, Section 501-10 Front Seat Cushion Cover for removal and installation instructions.
This image has been resized. Click this bar to view the full image. The original image is sized %1%2.
2. During installation route heater harness away from torsion bar function zone and fastened to 11 way harness near finger bracket. (Figure 1)
OPERATION DESCRIPTION TIME
060211A 2005-2006 Freestyle/Five 1.4 Hrs.
Hundred/Montego: Replace
Drivers Heated Seat Pad
(Do Not Use With 62900A,
64416A, 14056D Or
63222A)
DEALER CODING
CONDITION
BASIC PART NO. CODE
14D696 43
How do you wire up a starter for a 1995 ford truck?
Starter
Removal & Installation1. Disconnect the negative battery cable.
2. Raise and safely support the vehicle.
3. Remove the starter terminal cover.
4. Remove the terminal nut and separate the battery starter cable from the starter motor.
5. Disconnect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
Ø To disconnect the hard-shell connector from the solenoid (S) terminal, grasp the plastic shell and pull off; do not pull on the wire. Pull straight off to prevent damage to the connector and (S) terminal.
6. Remove the starter motor retaining bolts.
7. Remove the starter motor from the vehicle.
To Install:
8. Place the starter motor in position and install the starter motor retaining bolts. Tighten the bolts to 15-20 ft. lbs. (20-27 Nm).
9. Install the battery starter cable and a terminal nut to the starter motor. Tighten the terminal nuts to 79 inch lbs. (9 Nm).
10. Connect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
11. Install the starter solenoid safety cap. If equipped.
12. Lower the vehicle.
13. Connect the negative battery cable.
14. Start the engine several times to check starter motor operation.
How much is a 1964 Ford 427 SOHC How much is it worth?
the last COMPLETE one i saw listed in HEMMINGS MOTOR NEWS was 30K, complete,rebuilt,and ready to go.there is one on e bay right now, for 12K, i think, not complete. hope this helps.
Where is the transmission stick located on a 2005 ford 500?
For the ( 6 ) speed automatic transmission it is by the engine air filter housing
according to the picture in the Owner Guide
Where is the auxiliary audio input jack in a 2005 Mercury Montego?
There is no auxiliary jack for any Montego or 500 for that matter. I was told by the dealer that "it has one somewhere". I bought the car and looked and researched, and found that it does not have one! You can buy a "Trip Tunes" accessory from your Ford dealer (this has no ipod control) or aftermarket. I bought an Axxess ipod interface made by Metra. It has ipod control and it works great for me. They do have an aux. only input interface as well. You retain your radio and steering wheel controls.
