0
GMC Suburban
Also known as GMC Yukon XL, the GMC Suburban is a full-size sport utility vehicle manufactured by General Motors Company from 1935 to the present. It has been one of General Motors’ most profitable vehicles.
904 Questions
What is fluid capacity for ac compressor in a suburban?
The Chevrolet suburban air conditioning compressor fluid capacity is dependent upon the year of the automobile. In general, the air conditioning system will hold approximately 6 pounds of Freon.
it is possible that it is the ignition coil but im not sure, that's what happened to my 93 1500 silverado and the coil was the problem. it might be an idea to check it but im not sure on newer gm models
What is the difference between a K1500 and a C1500 suburban?
K is for 4 wheel drive
C is for 2 wheel drive
How do you change a pick up coil on a 1993 gmc suburban?
well if you truck have a coil pack you would have to replace the hold pack but if they a indviseual you can replace each one if thay are seprate it will cost a bout 100 apiece
How do you replace the alternator on a 1994 Chevy Suburban?
There is a belt tightener on the alternator which must be loosened to take the belt off. After the belt is loose, remove the bottom mounting bolt and the alternator is off. you will also need to remove the wiring.
What does a airbag do in a car?
The airbag is there for protection and life safety. Although, children today see airbags as standard equipment most of us grew up with only seat belts for protection. And come to think of it most of us did not where our seat belts until it became a law in most states. Today, the SRS system or supplemental restraint system works together with the seat belts to reduce injuries you might otherwise sustain in a car accident.
The relays have nothing to do with the whining noise, they just complete the circuit and make things work. The whining noise is the fuel pump and that is a common problem with Chevy That noise will not hurt anything, but I would change the fuel filter and that may quite the pump a little. A stoped up fuel filter will burn a fuel pump up.
What is the position of the number eight spark plug wire on the Chevrolet 5.7 liter engine?
Rear plug on the left bank or passenger side. Driver's side 1-3-5-7- and passenger side 2-4-6-8-
First thing to do-- check if the wiper is attached to the motor at all. My Suburban loosened both bolts and thus, no connection means no movement. The bolt is found by lifting the hood and checking the bottom of the arm. If there is no nut (my problem- luckily the bolt was in the engine, visible) or a loose nut, (find) tighten it and see if that works.
What is the starter bolt size for an 1986 suburban 6.2L diesel?
I just changed the solenoid on my 88 GMC 6.2l Diesel. I think the bolts holding the starter in were 17mm. I know the bolts holding the wires on were 8mm. I didn't have anything metric on hand. To remove the wires you'll either need a closed end wrench or a deep socket.
Where is fuel injector relay on 1999 Chevy Suburban 1500 5.7 liter?
Under the hood on the drivers side with the fuses.
Why does your 6.2L diesel start then die?
Fuel starvation, replace diesel filters first, then check lift pump for proper operation and fuel pressure.
Also check for leaks in the fuel lines, and return lines...common problems on diesel engines.
How many quarts of oil does a 1996 gmc suburban with a 454 take?
my 97 gmc suburban k2500 454 takes 7 qts of oil during oil change.
How do you remove a radiator cap on a 1999 GMC 2500 Suburban?
Push down on it , then turn it counter clock wise.
MAKE SURE THE ENGINE IS COLD
How do you clear out the check engine light on a 1993 GMC Suburban?
Disconnect the Battery. Negative prefered. Wait a couple minutes and reconnect. This will clear codes on 1994 and older. If the light comes back on, check the trouble codes and a repair may be needed.
How do you replace the thermostat located on a 1994 GMC Suburban?
If it's the same as my 93' then you just un-bolt the temp. houseing on your motor (in front of your air cleaner), be careful of the wire attached, when I did mine the temp. wire end broke, not a major thing but is a pain with not much wire to work with. Pull the old therm. out (keep in mind of the way it was in there for reference), put a rag in the hole to keep junk out. Scrape off old gasket or seal. Clean and replace gasket and use a little sealant to secure it. Put therm. back in but make sure it's the correct position and direction as the old one. Bolt back on, your done. Make sure to top off the fluid in needed.
Is a gmc suburban 1500 a half ton or three quarter ton?
it is half ton and 3/4 ton is for 2500...there is only 2 models for Suburbans.
Where is the daytime running light control module located in a 1999 GMC Suburban?
I have never seen one. If you want them off you have to press on the emergency brake a little.
How do you clear out the check engine light on a 1997 GMC 1500 Suburban?
First repair the problem that caused the light to come on, otherwise it will just come back on. You can try disconnecting the battery for 15 minutes and it may or may not reset the light. If this does not reset the light, you will need to access an OBD2 scan tool to be able to reset it.
Is it true or not that on all small block Chevy's motors 1 piston is the furthest head forward?
yes, it's true.
Oil change on 99 GMC suburban?
What do you want to know about its oul changes? When, how, the cost...?
