0
Honda Passport LX
Produced from 1998 to 2002, the Passport LX was the second generation model of the Honda Passport. This model was one of the two trim levels of the Passport, along with the upscale EX.
386 Questions
Where is the PCV Valve located on a 1995 Honda Passport?
where is the pcv valve locate on 95 Honda passport
this just happened to me i have a 2001 Honda passport the problem with mine was a broken transmission cable. we just had this fixed but until we did i had to push the button on the gear shift and lift up a little and i could put the car into gear ... good luck
Is the thermostat bad if the heater puts out hot air while in motion and cool air when idling?
May have an answer already, but be sure that the radiator is full of coolant.
Why would the power drive light be on in my 1998 Honda Passport?
because you have the power button turned on,push the button again to turn it off
How do you remove front rotors on a 2000 Honda Passport?
Remove wheels Remove caliper ( 2 mounting bolts) Slide caliper off rotor Rotor should slide off hub
Where is the map sensor on a 1989 through 2002 Honda Passport?
On 89 thru 97 3.2L Passports, Rodeos, and Amigos the MAP or Manifold absolute pressure sensor is located on the right side of the intake manifold. On 98 and later it is on the right rear upper corner of the intake manifold, and on the 2.2L it is on the upper side of the intake manifold between the throttle body and the cylinder head
29s here, yes there a release button and it is located on the shifter housing directly across from the traction control button (tcs). pop the cover up with a smell flat head screwdriver and then stick that screwdriver down into that opening and press it down. that will disingauge the neutral safety switch so you should be able to shift. if problem persists check trans fluid and linkage located below the intake hose.
Where is the EGR vavle located in a 1989 corvette?
The EGR valve is usually located on the top of the valve cover...it is usually a plastic part that connects to the valve cover with a rubber seal...there is an emissions hose leading away from it...the PCV valve is also located on the valve cover in a similar fashion, though it is a lot smaller...
