answersLogoWhite

0

🚗

Miscellaneous Vehicles

Miscellaneous vehicles may include a motorcycle or any similar vehicle, a motor home, a golf cart, or an all-terrain vehicle. Some of these are designed for personal use and should not be used on public roads.

3,638 Questions

What could be wrong if your snow blower burns belts?

If your snow blower is burning belts, it could be due to the belts being too tight, misaligned pulleys, worn out pulleys or idler arms, or excessive debris causing resistance. It's important to inspect and address these issues to prevent further damage to your snow blower.

What to do to make your snow blower throw more snow?

I don't think that's what it's suppossed to do

------

uh its in the name.... but i don't think there is a possible way to but i was thinking that leaf blowers might also work well XD

Why does Briggs and stratton 5.5hp snow blower engine only runs with choke on?

you need a new carburetor

OR you might want to take it off and clean it. It might just be in need of a good cleaning.

Somethin Else To Try

Before you take off the carburetor, you might want to check the setting. Sometimes, the vibration will cause the needle valve to vibrate open or closed. Here is the procedure for setting the caruretor:

The following procedure applies to all small engines

If the engine does not start:

(1) rotate the carburetor main jet needle valve clockwise (close) until it touches its stopping point - DO NOT FORCE OR GO BEYOND THE POINT OF TOUCHING as it may damage the tip.

(2) Rotate the needle valve counter-clockwise (open) 1-1/4 to 1-1/2 turns - this should be close enough to start the engine. Start the engine and let it warm up about five minutes.

(3) Rotate the needle valve clockwise (close) slowly until the engine starts to stall for lack of fuel, then rotate the needle valve counter-clockwise (open) slowly until the engine starts to stall from flooding (too much fuel).

(4) Set the needle valve to a midpoint between the two extremes for the best "purr" of the engine. If the engine "sputters" when a load is added, open the needle valve an extra 1/8 turn for a slightly richer mixture.

If the engine starts and you just want to adjust the carburetor, steps (1) and (2) are not necessary.

Are new craftsman snow blowers reliable?

Have a Sears snowblower that's about three years old used it hard in the snow storms we have had in 2010 and it work fine only thing is the gas tank is to small, needs to be refuled often. We had 40 inches of snow in two storms. it is a 5.5 Hp. and 24 inch wide model. Cal120

In Canada, the higher priced Craftsman snow blowers are built by Husqvarna and are very reliable. They are Husqvarna in red.

What will cause craftsman snow blower forward drive to stop?

If a wheel has been remove like to fix a flet, then a key. If not then the drive disc could be worn out or the belt is slipping.

* If that doesn't work check to see if the bolt connecting the drive belt to the axle snapped off.

Do you have Craftsman snow blower manual 536.886190?

I do not have access to specific manuals. However, you can try contacting the manufacturer directly or searching for the manual online through the manufacturer's website or other resources that provide manuals for various products.

What kind of engine oil for a master-craft snow blower?

Check the owner's manual for the recommended engine oil viscosity and type for your Master-craft snow blower. Typically, a multi-grade SAE 5W-30 oil is suitable for most small engines used in snow blowers. Be sure to use a high-quality oil that meets the manufacturer's specifications.

My snow blower starts but as soon as you take it off choke it stalls.?

It sounds like it was stored with gas in it. The symptom you list is normal for a carburetor that has begun to get clogged from gas that has turned to varnish. You may be able to buy a can of "SEA FOAM" at your local auto parts store. You can add it to your gas according to the instructions and within a tank or two it should clear up the problem.

What is an air cushion?

An air cushion is a device or structure filled with air that helps to absorb shocks or impacts. These cushions are commonly used in packaging to protect fragile items during transportation, as well as in medical devices like wheelchair seats to provide comfort and pressure relief.

Who designed the moon buggy?

Mieczyslaw G. Bekker and Eduardo San Juan, NASA Engineers.

What will happen to the astronaut when the jets produce these four forces?

The astronaut will experience acceleration in the direction of the net force produced by the jets. If the net force is greater than gravity, the astronaut will move in the direction of the force; if the net force is less than gravity, the astronaut will continue to float weightlessly. The astronaut may also experience changes in direction or rotation depending on how the forces are applied.

How much energy in joules does a regenerative brake produce when going from 60mph or 25 meter per second to zero?

You can use the formula for kinetic energy (1/2 x mass x velocity squared). However, I don't know how efficient those brakes are; that is, how much percent of the energy typically gets recovered.

What is the fastest tank?

The fastest tank in the world is the Soviet BT-7 "fast tank" from World War II, which could reach speeds of up to 53 mph (85 km/h) on roads. It was designed for rapid maneuverability and reconnaissance.

What is the fastest road?

The highest speed limits on public highways can be found on the German Autobahn, where some sections have no speed limit. However, there are also race tracks like the Nürburgring Nordschleife in Germany where cars can reach even higher speeds.

Why does the snow blower power slip in the drive system?

The snow blower power may slip in the drive system due to a worn or loose belt, lack of proper tension on the belt, or a faulty drive system component such as the pulley or clutch. Regular maintenance and proper adjustment of the drive system can help prevent slipping issues.

How do you replace a friction wheel on a MTD snow blower?

To replace the friction wheel on an MTD snow blower, you will need to disconnect the spark plug wire, remove the auger belt and pulley, then remove the wheel assembly. Install the new friction wheel by reversing the steps, making sure to adjust tension on the drive system properly. Refer to the snow blower's manual for detailed instructions.

What do most fuels contain?

The most common fossil fuels used to power cars are petroleum spirit (petrol / gasoline) and diesel.

It could also be argued that electric cars with rechargeable batteries may be powered ultimately by fossil fuels as the electricity they use is generated at a power station which inturn may use a fossil fuel such as coal or natural gas.

Explain whether or not a heat engine could be made 100 percent efficient by eliminating friction?

Even if the friction were totally eliminated, a heat engine still could not convert heat completely into work and be 100 percent efficient. Instead, the efficiency of an internal combustion engine depends on the difference in the temperature of the burning gases in the cylinder and the temperature of the burning gases in the cylinder and the temperature of the air outside the engine.

Is stepping on the brakes of a moving train an example of acceleration?

No, stepping on the brakes of a moving train is an example of deceleration, as it is the action of slowing down or reducing the speed of the train. Acceleration refers to an increase in speed or velocity.

What are the types of transportation in China?

Some common types of transportation in China include buses, high-speed trains, subways, taxis, and bicycles. China also has a growing network of domestic and international flights connecting major cities.

Snow blower auger won't turn?

why wont the blades/auger on my john deere snow blower turn?

first thing i would check is to make sure there isn't a piece of wood or something jammed between the blades and housing. i don't know if your blower is shaft or belt driven. if belt driven check the belt and pulleys. if it is shaft driven try to spin the blades by hand, if they turn free then the shear pin is broke. look for a small round steel pin in the same are the blower shaft attaches. it should go through the shaft all the way from side to side.

Why does your Snow blower auger leaves trail on side?

if it a 2 cycle, its probably a bad scrapper bar, this is underneath the unit & scrapes the driveway right behind the auger. or the rubber flights/spiral is worn out on the unit. if its 4 cycle check the skid shoes on the side of the snow blower housing, they wear out & drag. many people go through a set every season. if your going to be working by the auger, disconnect the spark plug wire first. put the unit on a flat place, set scrapper bar on an 1/8"-1/4" shim, install the new ones so they touch the ground. its like little skis for you blower!

What is the average pounds of carbon dioxide are emitted by a car annually?

It depends on the amount driven and the efficiency of the engine. Essentially 85% of the weight of fuel (gasoline or diesel) is carbon so about 750 g of carbon is emitted for each liter burnt.