answersLogoWhite

0

Mitsubishi Endeavor

The Mitsubishi Endeavor is a mid-size crossover sport utility vehicle produced from 2004 to the present. Based on the Mitsubishi PS platform, the car features a 3.8 L SOHC 24v V6 engine and a 4-speed semi-automatic transmission.

308 Questions

Why does 2004 Mitsubishi Endeavor air conditioner leak water inside the car?

the water is probably condensation from the ac evaporator. there should be a drain hose on the firewall, it could be kinked or plugged.

This is the for the Lancer, it may well apply to yours too.

I believe I might have a good for this. This came out of Alldata. You need to install the new Wiper Pivot Shaft Grommets, part numbers MN154877 and MN154878 for the drivers side. These will keep water from entering the blower motor. Water entry can cause blower motor failure. This problem affects 2002-2003 lancers. The technical service bulletin is 0351001.

  • Remove the wiper arms.
  • place the new grommets on each wiper pivot shaft
  • using a flat screwdriver, press the new grommet downward under the front deck
  • reinstall the wiper arms

What can you do to fix your tire pressure monitor it is blinking and all the tires have correct pressure?

Chances are you have a sensor in one of the tires that is broken if you take it in they can attempt to program it. If that fails they can tell you what tire is not working and you can replace the sensor in it. They are not cheap 70-90$ and from what I understand the system is mandatory now so you can not even disable it.

Where is the transmission dipstick located on a 2006 endeavor?

Look directly behind the radiator...slightly to the right of center of the vehicle and then down. Get a flashlight and look for a small yellow pull that is the top of the dipstick. It is wedged in between the battery pedestal (right) and another item (left).

How do you program a remote key in a Mitsubishi endeavor?

Try this at your own risk:

You need 2 valid keys for your vehicle.

Insert the first key an turn it to "on" position for about 4-6 seconds, turn it 'off' and remove the first key then insert the second key of your vehicle right away and turn it to "on". Wait until the immobilizer light turns blinking then turn the second key to "off"right away and remove it. Insert the 'new blank key' and turn it to "on" and you're done. Do this procedure as fast as you could. .

If you have only one key... or if the above procedure don't work, you have to go to the dealer.

Where is fuel inertia switch location to reset?

The fuel cutout inertia switch is located under the kick panel in the passenger side footwell. There will be a red button to press.

How do you open the back gate on the 2004 Mitsubishi Endeavor when the handle does not work?

From the inside, there is a small door (just like a battery door) open it and inside you can see the mechanism to open the hatch. All new cars has this safety feature so that you can get out of the trunk even if someone closed it from the outside.

Remove tire from Mitsubishi endeavor?

I'm assuming you mean any tire other than the spare, which is self-explanatory. A 21 millimeter socket is required for loosening the lug nuts, then find the jacking reinforcement on either side frame rail located in line with the rear half of the front doors. This is a good balance point for the jack. Don't be alarmed if both front and rear wheels clear the ground, it's normal. Makes it great for DIY tire rotations. There are other reinforced areas of the frame rails in the front and rear that you can use also, just avoid jacking under soft spots like the bumpers or rocker panels etc.

How often should you replace timing belt on 2004 Mitsubishi endeavor?

i have a 2004 Mitsubishi endeavor . i was wondering how often you would sugest replacing the timing belt .

How to install a CD player in a Mitsubishi endeavor?

Google the model car and the wire diagram follow cd player diagram and fix wires together

How do you remove heater fan from a Mitsubishi endeavor?

The blower motor is the same for heating and cooling. The fan motor is located on the passenger side underneath the glove compartment. The blower assembly is round and has three sheet metal screws that holds it in place. Make sure you disconnect the negative black cable from the battery before you start working on anyting electrical on the vehicle. Second, remove the electrical plug that powers the blower motor. Remove the three screws and the motor should drown down right into your hand, you may have to pull slightly on it to break it loose. Replace if need in the same manor you removed it, it will only go in one way.

Why would the service engine soon light come on in a 2004 Mitsubishi Endeavor?

I HAVE A 2004 MITSUBISHI ENDEAVOR, AND THE ONLY TIME MY CHECK ENGINE LIGHT CAME ON IS WHEN I FAILED TO CLOSE MY GAS CAP TIGHTLY. THE LONGEST THE LIGHT STAYED ON WAS FOR 3 DAYS AND THEN IT WENT OFF.

Where is the MP3 connection for 2005 Mitsubishi Endeavor stereo?

I've got the base model 2005 and I don't believe there is one anywhere in the vehicle.

How to change tail light in Mitsubishi endeavor?

Open the hatch, remove the screws holding the light housing, then, pull straight backwards gently to disengage the clips, remove the light socket by gently turning counterclockwise to remove the bulb. Other lights can be removed by pushing on it first before turning whatever the case may be.

Where is tire jack on 05 Mitsubishi endeavor?

It's well hidden under a floor panel under the right side of the rear seat. Tilt the seatback forward to find the floor panel easier.

Can you put an after market CD player in your 2004 Mitsubishi Endeavor?

Yes, you can. It's recommended that you find a professional to do it.

Is there a tire key for tire removal on a Mitsubishi endeavor?

Yes theres a key usaully tire shops have them see if you can buy or borrow one from them.