Is Mitsubishi endeavor awd good in snow?
Short answer (IMHO) - YES! I am terribly impressed how my AWD Endeavor walks through snow and slush. It may be no different from any other AWD SUV but even when it snows 10" - I'm the guy who not only makes it into work, but into work early!
Location of sparkplugs on 04 Mitsubishi endeavor?
what is the warning light on the lowest right hand corner of a mistsubishi endeavor ? it looks like an upsidedown half circle with an exclamation point in the middle and a jagged line as the bottom of the half circle.
What power steering fluid for 2004 Mitsubishi endeavor?
Genuine Mitsubishi Power Steering Fluid (Capacity is about 1.3 quarts)
What does the low tire pressure light look like on a Mitsubishi?
Like a horse shoe "(_)" with a "!" in the center
Where is sunroof drainage for Mitsubishi eclipse 1998?
It is up in the front corners of the moonroof it might be a hidden by the moonroof track. If you take a look you should see a pen size hole and it drains into your wheel wel.
How much gas mileage does a Mitsubishi Endeavor get?
I own an 04 Endeavor with front wheel drive. I rarely get less than 20 mpg in city driving and consistently get 23-24 on extended highway driving. I have also used nothing but sythentic oil, and change it every 5,000 miles.
How many miles can you get on a 2005 Mitsubishi endeavor?
I have an 04 with 116K. great running car. have changed out timing belt and plugs at 95k. On my second oxygen sensor (there are 4). Run synthetic oil and premium gas. so far only repairs i have ever done...
Where are the trailer towing wires on a 2004 endeavor?
They are tucked up and behind the rear bumper assembly. They are there you just have to dig for them. Should be able to reach with your hands.
Are replacement wipers available for the Mitsubishi endeavor?
Yes, replacement windshield wipers are available from your dealer or aftermarket (at the store/online) for all years of the Mitsubishi Endeavor - both front and rear.
Step 1 is be sure to get the correct replacement wiper blades: The 2004-2010 Mitsubishi Endeavors take a 26" driver side, 21" passenger side and a special 14" rear replacement wiper blade. See sources and related links below for more information. Since there are currently over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
Auto Zone has a Trico Brand 14 inch replace blade that fits the rear wind perfectly. It cost about ten bucks. It has easy directions and the entire new assembly snaps in. It takes less than a minute after reading the intructions.
What does TCL button do on a 2010 Mitsubishi Endeavour?
Its The traction control Lock .. The switch turns it on and off... In the on mode it protects you engine and transmission from over revving and blowing up if your tires are spinning.. EX:ice, or mud
On the driver's side underneath there are some brake lines that come down and then turn aft. Just to the outboard side of those lines there is a hole (about 5/8" diameter). With a light and an inspection mirror you can see the hose inside. Use an air compressor and an air gun with a long flexible or curved end and blow into that hose. I cannot guarantee that it will work, but it worked for me. Now I gotta buy a new blower motor.
Reset srs warning light on Mitsubishi challenger 3.0 v6?
the srs system needs to go through a self check then the codes will be able to be cleared.this will only be reset if the relevant parts have been replaced .there are many reasons why the lamp may be on,all the codes and details will be retained in the srs ecu for ever.this information will be used in the event of an accident .There fore it is not in anyones intrest to try and switch the srs light out unless the faults have been repaired in a professional manner
Why won't my 2005 Mitsubishi Endeavor start?
lots of causes:
-battery might be dead... try to jump start it... if it starts... change the battery(most common problem)
-no more gasoline
-dead fuel pump
-clogged fuel line
-dead starter
etc...
Where is the ac blower motor resistor on a 2004 Mitsubishi endeavor?
If I'm reading the Mitsubishi 2004 Endeavor repair service manual correctly, it is in the drivers fuse panel and has the markings OMRON, MR515993, 12 vdc, 24z200. I found the blower relay at rockauto.com. Their part number was 1r1645. It is a module (black, rectangular with 4 prongs), not a fuse.
I should have added this is the location of the "relay". I guess it's the same as a resistor.
*** This the location of the RELAY. It is NOT the resistor.
How can I get a duplicate key for Mitsubishi endeavor?
You can buy it at the dealer about $100 i think...
Or buy a blank Mitsubishi endeavor key (Transponder) about $20.00 from the internet and have it cut (copy the original) at ace hardware and program the key yourself. Instruction to program is somewhere else here at answers.com
Be sure you have two original transponder keys before you buy so you can program it to your car. If only one...you have no choice bu go to the dealer.
Where is oil plug on 2004 Mitsubishi Endeavor?
Look under the passenger side of the engine, it is on the posterior-inferior portion of the oil pan.
What are non bio degradable e-wastes?
The Chemical substance which is found in circuits of electronic, which is very harmfull and toxic is Non-Biodegradable E-Wastes.
What transmission fluids are compatible with Mitsubishi eneavor?
Local transmission shop said it is best to get from the dealer for this one. Bought the fluid last week at $6 a quart.
When do you replace timing belt Mitsubishi eclipse 2003?
"75000 miles" That's incorrect. From the Mitsubishi Service Manual for a 2003 Eclipse Spyder sporting the 6G72 V6 engine - which, by the way, is an INTERFERENCE ENGINE* - the recommended replacement FIRST interval is 60,000 miles - and again at 100,000 miles. Furthermore, it also states: *1: For California, Massachusetts, Vermont and Maine, this maintenance is recommended but not required *2: Not required if belt was previously changed *those caveats apply to *1 the 60,000-mile interval, and *2 the 100,000-mile interval. However, PLEASE keep in mind that the 6G72 engine is an interference engine, which means that proper valve train/piston head clearance is only maintained as long as the proper timing between those engine components exists. If the belt slips a tooth, or fails (due to extended operation beyond recommended service life, for example), it is more than probable that pistons will contact valves - resulting in bent valves, damaged pistons, or worse - a completely trashed engine. In my humble estimation, it's not worth the risk. Your choice, of course.
Cheers
HO2S Heater Control Circuit Low Bank 1 Sensor2
symptoms
Other than the MIL light illuminating you may not notice any performance issues.
cause
A short in the O2 sensor heater circuit or the sensor itself
A faulty O2 sensor heater
Wiring or connectors are broken or frayed to the sensor or relay
Bad PCM or ECM
The fix
Correct wiring short or loose connector found in inspection.
and/or
Replace the bank 1 sensor 2, O2 sensor
Replace PCM if circuit has failed and no wiring issues present, good O2 sensor