0
Plymouth Duster
The Plymouth Duster was an economy vehicle manufactured by Chrysler Corporation. Numerous versions of this car were offered including the Gold Duster, Feather Duster, Space Duster, Duster Twister, Silver Duster, 340 Duster and 360 Duster.
133 Questions
What would be the new size of your Plymouth 318 if were bored 060 over?
It would probably be close to a 340 as the 340 is the same engine block as the 318. The stock 318ci has a 3.910 in. bore with a 3.31 in. stroke the very same stroke as a 340ci. The stock 340ci has a 4.04 in. bore. The .060 in. over bore would result in a 328ci engine. The formula for this is, 1/2 bore x 1/2 bore x 3.14 x stroke x number of cylinders.
Where is the fuel filter on 1974 a Plymouth duster?
It's in the fuel line going from fuel pump to the carb. Passenger side below cylinder head.
Will bumpers for a 1972 Plymouth duster fit a 1973 Plymouth duster?
The bumpers for a 1972 Plymouth will fit a 1973 Plymouth duster with a little fabrication.
How do you install an alternator in a 1971 Plymouth duster with a slant six?
first unhook the battery cables and then take the alternator belt loose and then take the 3 bolts out that hold the alternator on and take the wiring harness out of the alternator and the red battery cable off and it's out.
The first thing to check is that you are getting spark at the plug and if your not try changing the ballast resistor on the firewall, it's the white porceloin thing with wires running to it.
What direction to turn radiator petcock on mopar v-8 radiators?
if your looking down on the petcock from the top of the radiator turn the petcock to the right to loosen it and to the left to tighten.
What are the Timing gear marks for a 74 340 duster?
on the cam gear the mark should be at 6:00 or in other words the mark will be at the bottom of the gear when installed, on the crank gear the mark should be at 12:00 or at the top of the gear when installed, both marks will line up with each other.
This is most likely a blown head gasket. You may also find that your oil is a milky color. This is caused by water getting into the oil from the defective head gasket. This is a major engine repair. Seek professional help from a reputable service facility.
How do you get to the bolts to remove the front seat on a 1973 Plymouth Duster?
there are 4 nuts under the car...
Where is 1 on dist cap for 318?
#1 on distributor cap faces to the front ( inline with the middle of the engine ) according to the picture in my Chilton repair manual
Where is the fuel pump on a 93 Plymouth sundance?
It's in the gas tank, the tank has to come down to change it.
What rear end gears came in a 1973 340 Duster?
back then you could order 2.76, 2.92, 3.23, 3.55, 3.90, or 4.10's, most came with 3.23 or 3.55's.
