Where is the the tdc sensor in a renealt clio?
iv just bought ns /os drive shafts for clio 1200 from J&R Trading (uk) Ltd are they a good replacement to fit thanks for help
Where is crankshaft sensor on Renault clio mk 1?
On the right side, above the gear box. I is placed behind the pipes of the cooling system.
When should a cam belt be changed on a Renault clio 1.5 d?
At about 50 to 60 K mi, or per the owners manual.
What causes a car to stall when driving through a puddle of water?
if it is a big puddle the water when splashed might be hiting a sensor if it is a big puddle the water when splashed might be hiting a sensor
How do you remove serv indicator light on 2003 Renault clio 1.2 16 v?
turn the ignition off hold the round button on the end of the wiper stalk and turn the ignition on while holding until the dash starts flashing and resets may say mileage until next service or count from 10 to zero
Where is the outside air temperature sensor in a Renault clio?
Its on the underside of the nearside (passenger) wing mirror.
How do you change a fog light on a Renault Clio?
on a mk1 clio just unscrew the screws in the front of the lamp and pull it out, twist the plug at the back and it should all just come appart
Where is main fusebox on a clio?
In my clio it is on the passenger side of the dashboard, you need to open the door and look down the side of the dash.
How do you remove the side repeaters of a Renault clio mark 2?
prise with a small flat head screwdriver, will just pop out careful not to break plastic holding clips
Your central locking on your Renault clio isn't working?
central locking switch on the dash doesn`t work
How do you remove dashboard on a clio?
To remove a Clio dash:
1. Remove screws securing the steering columb UPPER shroud.
2. Remove the 2 x torx screws at the bottom of the instrument gauges.
3. Remove the 2 x plastic plugs at either side of the dash. (you would need to open the door to see these.
4. Gently ease out the 3 switch panel in the dash centre. DO NOT REMOVE THE STEREO PADDLE, THERE IS A SCREW IN IT THAT YOU WILL BREAK OFF FOR SURE.
5. Remove the 3 x torx screws securing the screen demist vents (1 either side and 1 in the middle.
6. Firmly grasp the dash and pull straight towards you, then upwards, you may not need to fully remove if fitting a stereo system wiring harness.
7. Be careful of the airbag on the passenger side.
8. Be warned that if fitting a new music system ISO wiring interface, you need both parts from Halfords. The instructions are not clear, do not remove any wiring from the speedo or rev counter. The new interface plugs into the back of the centre display. Remove this by depressing the small plastic retaining clip either side of the clock panel, slide rearwards to extract. Remove the long red plug by lifting the small black plastic clip on the plug and as you fold it over to the other side the plug will come out of the socket. Fitting is a reversal of removal.
9. Note that with the dash lifted, the car will not start as there is a safety switch to prevent you driving the car with the airbag exposed as it could take your head off!
10. To refit the dash, make sure it is about an inch rearwards, and fully lowered into its normal plane, and just slide it FORWARDS into place. DO NOT try sliding forwards if not fully lowered as you will damage the airbag catches and / or break the 2 plastic struts which sit around the air bag ends.
11. Then refit all the switches, screws etc.
12. Another word of warning - If you are fitting a new stereo system, the wiring at the rear of the stereo gets quite tight. If you just cram it in, then ram the stereo home in its cage, you will damage the wiring behind, guess what this is? Yes, its the wiring to the engine ECU, sensors etc etc, the next thing will be after a few miles, the car will begin cutting out and acting in an irrational manner. You have been warned, take your time when replacing the stereo system.
GOOD LUCK, Mick H
How do you put the radio code in a Renault clio?
Hi, The code you need to enter is a four digit code lets sayfrexample 2222. you enter the code as follows using the numbered buttons on radio. (pre-sets) button 1 press twice. button 2 " " " " button 3 " " " " button4 " " " " then hold in button 6 or 5 job done ejoy :-)
Where is the flasher unit on a 1992 Mazda Protege?
Not 100% sure but I think its the relay on top of the fuse box right over the pedals on the RHD models - for Mazda 323 diesel.
Casper
I replaced this on my 92 protoge and it is behind the radio
How often is cambelt change Renault clio?
Depends on the model - for diesels its every 72000 miles but I'd recommend changing it at 54000 as I've heard some horror stories of cambelts breaking at between 64 - 72k
How do you remove the dashboard for 1999 dodge ram b1500 van?
The 1999 Dodge Ram dashboard is held in place with six retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips. The dashboard will come off in two pieces.