0
Rover Mini
The Mini was a compact city car manufactured by the British Motor Corporation from 1959 to 2000. Designed by Sir Alec Issigonis, this two-door car was equipped with a front-engine, front-wheel drive (FF) layout and an inline-four engine.
21 Questions
Why has your 1992 spi cooper mini got an orange warning light on clock?
The orange warning light on your 1992 SPi Cooper Mini could indicate a few issues, most commonly related to the engine management system or low fluid levels. It may signify that the car's onboard diagnostics have detected a potential problem, such as an issue with the fuel injection system or emissions control. It's advisable to consult the owner's manual for specific information related to the warning light and to have the vehicle checked by a qualified mechanic for accurate diagnosis and resolution.
Position of the heater control valve on a 91 classic mini?
In a 1991 Classic Mini, the heater control valve is typically located on the engine bay side, near the bulkhead, close to the heater matrix. It is connected by hoses to the engine's cooling system and is usually mounted on the bulkhead or on a bracket attached to it. To access it, you may need to remove some components, depending on the specific setup of your Mini. Always ensure the engine is cool before attempting any work on the cooling system.
What tax band is a Rover MINI COOPER 1.3 1990?
The Rover MINI COOPER 1.3 from 1990 falls under the old UK tax band system, which is based on engine size and emissions. Typically, vehicles from this era are classified in the lower tax bands due to their smaller engine size and lower emissions compared to modern cars. However, specific tax band classification may vary slightly based on local regulations and updates, so it's best to check with the latest guidelines or the DVLA for the most accurate information.
What is the weight of a classic mini?
The weight of a classic Mini, specifically the original models produced between 1959 and 2000, typically ranges from about 600 to 800 kilograms (1,323 to 1,763 pounds), depending on the specific model and trim. The lighter models, like the Mini 850, are on the lower end of the scale, while the more equipped versions, such as the Mini Cooper, can weigh more. The compact design and lightweight construction were key features that contributed to the Mini's agility and performance.
Is it possible to fit reverse light switch to Mk1 classic mini engine?
Yes, it is possible to fit a reverse light switch to a Mk1 classic Mini engine, but it may require some modifications. The Mk1 Mini was not originally designed with a reverse light switch, so you would need to install one in the gearbox or use an alternative location. Additionally, wiring will need to be run to connect the switch to the reverse lights, ensuring proper functionality. It's advisable to consult a mechanic or a specialist familiar with classic Minis for the best results.
if you are looking for an ordinary 1.0l mini 2,3000 pound if you are looking for a cooper ive seen prices over 20,000 pound so whatever you want its your choice but remember to check for rust and also mantain the engine well as ive heard they can be quiet unreliable
Where is reverse gear on a 1969 Morris mini?
assuming that it is the same as my 1972 mini. it is down and to the right (towards the driver) also, the gear lever will have to be lifted or pulled up to allow access.
in order world to know and feel if any one wants to drive a car manufactured with minimum resources without compromising the reasonable expectation which drew the man kind to invent a naval mode of motion, it is the mini i.e. one can easily contended for a mini minor, if your 5 senses are well within your control
s.a.
if it is a classic mini it would weigh approx 980 kilos anew one is a bout 1,783 kilos
Where is the inertia switch in a mini one?
Yes, left side "under the Front-scren"/bonet in the engine compartment
Why do the windows and sunroof open automatically on my mini cooper?
my friend, when you open the car with the key control and you'r pressing the botton for more than 3 seconds, the mini cooper automatically opens the sunroof and windows, this just works with the open, if you try to close with the control the sunrooof and the windows stay it will in the same place.
How much does it cost to change a head gasket on a Mini?
assuming it is a classic mini. the head gasket it'self is not a big job to change, nor does the gasket it'self cost a fortune of money. therefore assuming the gasket costs £10.00 and takes a garage one hour to fit, at £100.00 an hour it would cost aprox. £110.00. however if you are confident enough and own a spanner set, a torque wrench and a haynes manual, the job can be completed in a morning for the price of £10.00
