Where can one rent snowmobiles for the weekend?
One might consider renting a snowmobile for the weekend from one of their local snow mobile offices. For instance if you are in Aspen, Colorado their are many lodges that will allow you to rent a snowmobile.
What is the Yamaha snowmobile clutch torque specs?
99 600cc Vmax, 120nm, 85 ft lbs for primary sheave 200 nm for spider and sliding sheave secondary sheave 64nm 6nm for bolt on weights and 3 nm for nuts on weights Yamaha suggests nuts and bolts be tightened in 2 stages.
How do you set up suspension on a polaris snowmobile?
Use your spark plug wrench to adjust your rear suspension
How old must you be to get your snowmobile license?
it all depends on which province or state you live in. I think in Canada you have to be 16
Change oilin 2002 polaris snowmobile chain case?
there is a drain bolt on the back side then fill it up to the full mark
How do you change light switch on 2000 polaris 700xc snowmobile?
4 torx bolts on the back of the switch, keep track all different lengths. one is under the park break lever. two wire harness plug into switch pull them out and replace or rebuild switch.
it varies a lot on the snowmobile so any where from 60 to about 150mph
How do you change a drive belt on ski doo snowmobile?
Could you tell me the year of the sled? You can do this through my message board and I will try to help.
There may be to much gas or the crank case might have to much gas. Some snowmobiles have a drain on the lower end. If yours dose drain it put fresh plugs in and try starting with the gas off.
If it has variable exhaust ( the round dome type things on the front of the engine ), those could be extremely dirty and are unable to move. If this is it, buy the new gaskets for it, take them out, and clean them up. When you say compression is good, it must be at least 100psi in each cylinder ( 125psi per cylinder means perfect compression for that sled ). In most cases, under 100 psi in the cylinders means time for a rebuild, and if one of the cylinders is significantly lower than the other side ( even if your compression numbers are still high ), it's time to take the motor apart and take a look.
What arctic cat snowmobile does the cdi box stamped cu7211 go to?
tha CU7211 fits a 2000 ZRT 800. For more info 315-964-2577
What is the horsepower of a Yamaha enticer 340 snowmobile?
The engine that comes standard with every Enticer 340 is a two-stroke, fan-cooled twin engine designed for this snowmobile. It reaches a maximum horsepower of 32 at 6,500 rpm, and a maximum torque of 25 foot-pounds at 6,000 rpm. With an engine size of 440-cubic centimeters, the Enticer can reach a maximum speed of 55 mph on the snow.
How good is a 1980 polaris txl 340?
That was an awesome sled in its time. I have one. It had a powerful and light 340cc liquid cooled Fuji motor. It was the first year Polaris made available modern front suspensions, starting a revolution. It was an option on the 1980 TXL , called TXL INDY. My TXL is the old school, leaf spring model.
Where is the choke control knob located on a 1989 Yamaha phazer snowmobile?
there should be a flat switch beside the cover for the gas cap, and the ignition switch. That is your choke. Sticking up is full choke, down is choke off.