0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
1998 Chevy K1500 front axle gear ratio?
There are four ways to find a ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
How do you remove the rear brake drum on a 2002 Chevrolet s10?
Once vehicle is supported on jack stand and wheel is off:
1: look at base of lug nut studs and see if there is a clip against the drum. If there is a clip, pry off with screw driver and discard. If no clip don't worry it was removed or fell off already.
2: Grab drum with both hands and pull evenly (slight back and forth or rocking motion may be used) on the drum. Hand positions 3 and 9 or 12 and 6. There is a small lip on back edge of drum to grab for extra grip but, Do Not pull on back plate. You can feel where drum stops and back plate begins but rotating drum slightly, since, the back plate will not move like the drum.
Drum should slide off wheel studs easily. Do Not use any oil on any of these parts you can damage the brakes and lug nuts might not stay tight once finished.
What is the Chevy big block main cap torque sequence?
Start in the middle, and work your way out, in a circular pattern. First, go half torque, then full, turning the crankshaft by hand after each cap.
How are cylinders are numbered small block Chevy?
Drivers side, front to rear, 1,3,5,7. Pass side, front to rear, 2,4,6,8.
How do you set timing on 292 Chevy 6-cylinder?
What year? Contact me through my board and I will try to help.
YES
Why does the heater blower only work on high in your 1996 suburban?
Sounds like your relay has failed. Near the blower motor (follow the wire back from the blower) there is a relay that controls this. It is fairly cheap and easy to replace. Need more help contact me through my board and I will try to help.
What is the average lifespan of a Chevy?
I don't know the average lifespan of a Chevy but i own a 1985 Chevy Capice Classic and it runs perfectly fine.
Where is the fuel pump located on a 1988 Chevrolet one ton truck with dual tanks?
If you have a fuel injected engine it is in the fuel tank. If you have a carb model it is located ( from the driver seat ) on the front right side of the engine at the bottom of the engine. There is a trick to holding the push rod up on these. There is a short bolt in the front of the engine near the fuel pump that you will remove, install a longer bolt in the hole to pinch the push rod tight, change out pump. remove long bolt and install short bolt. hole must have short bolt or it will leak oil excessively. The only purpose of this hole is to aid in fuel pump change.
Where is the o2 sensor on a Toyota mr2?
The O2 sensor is located on the downpipe of the MR2, although you were not specific to which MR2 generation/model you are referring to. Most are located there. The downpipe will be bolted to the exhaust manifold, which is bolted to the side of the motor closest to the firewall.
What does cast 10 20 on a small block Chevy motor mean?
The "10" means it has 1% tin and the "20" means it has 2% nickel - the tin allowed the metal to flow more efficiently into the mold which = fewer hot spots and the nickel added strength which = longer bore life.
Where is oil pressure switch on a 1993 1500 Chevy truck?
It is screewed into the top of the engine block right behind the distributor.
