Acura RSX

The Acura RSX fan switch sensor is typically located near the radiator or on the engine's coolant outlet. It is designed to monitor the coolant temperature and activate the radiator fan when necessary. To access it, you may need to remove some components for better visibility, depending on the specific model year. Always refer to the vehicle's service manual for precise information and guidance.

To program a 2003 Acura RSX keyless remote, start by sitting in the vehicle and closing all doors. Insert the key into the ignition and turn it to the "On" position (not starting the engine) and then back to "Off" twice, ending in the "Off" position. Press the "Lock" button on the remote within five seconds, and the doors should lock and unlock, indicating successful programming. If you have additional remotes, repeat the process for each one within 10 seconds.

On a 2002 Acura RSX, the fuel filter is located along the fuel line, typically mounted on the driver's side of the vehicle, near the rear axle. It is usually positioned under the car, just in front of the fuel tank. To access it, you may need to lift the vehicle and remove any protective covers. Always ensure the car is securely supported before attempting any maintenance.

In a 2003 Acura RSX, the starter is located on the engine block, near the transmission. Specifically, it can be found on the lower side of the engine, towards the passenger side. To access it, you may need to remove some components or covers, depending on the specific layout of the engine bay.

The air filter on a 2002 Acura RSX is located in the engine bay, specifically within the air cleaner assembly. To access it, you'll need to remove the air intake duct connected to the throttle body and then unclip the air cleaner cover. Once the cover is removed, you can take out the old air filter and replace it with a new one.

The starter on a 2003 Acura RSX is located on the driver's side of the engine, near the transmission. It is positioned at the bottom of the engine bay, making it somewhat challenging to access. To replace or service the starter, it may be necessary to remove some components for better visibility and access.

The average cost to replace the exhaust system in a 1995 Toyota Camry typically ranges from $500 to $1,200, depending on factors like the type of parts used (aftermarket vs. OEM), labor costs in your area, and any additional repairs needed. If you choose to replace the entire system, including the catalytic converter and muffler, costs may be on the higher end. It's advisable to get multiple quotes from local mechanics for a more accurate estimate.

To shut off the alarm horn in your Acura RSX, you can typically use the key fob to unlock the doors or press the panic button. If that doesn’t work, you can insert the key into the driver's door and turn it to unlock while holding it in the unlock position for a few seconds. If the alarm continues to sound, disconnecting the car battery for a short period can also reset the alarm system. Always refer to your owner's manual for specific instructions related to your vehicle model.

To change the battery in a 2004 Acura RSX, first, ensure the vehicle is turned off and parked on a level surface. Open the hood and locate the battery; disconnect the negative terminal (black) first, followed by the positive terminal (red). Remove the battery hold-down clamp, then lift out the old battery. Place the new battery in the tray, reconnect the positive terminal first, followed by the negative terminal, and secure the hold-down clamp.

In the Acura RSX, the remote wire in the wiring harness is typically the solid blue wire. This wire is used to turn on an external amplifier when the car's audio system is activated. It's essential to verify with a wiring diagram specific to your vehicle model and year, as wire colors can sometimes vary. Always ensure proper connections to avoid electrical issues.

To remove the gauge cluster on a 2003 Acura RSX, first, disconnect the negative battery terminal to ensure safety. Next, pry off the plastic trim surrounding the cluster, then remove the screws securing the gauge cluster in place. Carefully pull the cluster out, disconnect the wiring harnesses at the back, and you can then fully remove the cluster. Reinstalling is simply the reverse process.

To change the timing belt on a 2002 Acura TL, first ensure the engine is cool, then disconnect the battery and remove the engine covers. Next, drain the coolant and remove the drive belts, crankshaft pulley, and timing belt covers to access the timing belt. Align the crankshaft and camshaft timing marks, remove the old belt, and install the new timing belt while ensuring proper tension. Finally, reassemble all components, refill coolant, and reconnect the battery.

Disconnect the battery. Take out the centre console and the cover from the gear lever. Remove the ashtray and cup holders. 2 screws hold in the stereo from underneath. they are inserted vertically. Once these are removed the unit slides out.

The sensors are located on the catalytic converter. There are two of em; one closer to the downpipe and the other in the middle driver side of the cat. They are a pain to get off with the heat shield in the way. Best tool to use is a 22mm open ended heavy wrench. *Do not replace with universal o2 sensors* I know oe sensors are expensive, but you're just gonna have to bite the cost. Universal sensors do not work.

10w - 30 base model 5w-30 type s

The radio code is shown in a card inside a black case that holds the owner's manual. If it is not there, you should contact your nearest Acura dealer for the radio code.

It is always best to have the manufacturer's suggested grade of gas. The Type-S requires 91 octane (premium at most places)

yes

6 seconds

It depends on the intake that you get. There are short ram air and cold air intakes. Cold air intakes are preferred amongst rsx enthusiasts because of the cold air that is being sucked into the motor. On average, about 3-14 HP can be obtained from an intake. The quality and type of intake is what makes the difference between a lot and a little HP.

Bout 1-15 HP sad isn't it? It does give better gas mileage BTW or depend on how you drive your car.

so basically however you install it correctly or not, it range from 1 HP to 15 HP, sometimes it doesnt matter it could range to 0 and waste alot of gas on your car.

If your asking this question then you need a mechanic. Not being rude but this is one of the simplest things to do and if you have to ask the question then there is no telling what you could do to your car.

5x114.3