What did a 1957 Chevy Corvette cost new?
$3,176 base price and $5,548 maximum price possible with options (but without taxes).
What can you do to fix a 1990 Chevy Corvette that runs very hot in temperature 230 plus?
You might start with a check of the simple things, such as radiator cap. Next make sure you're not getting coolant into the oil. (i.e. head gasket leakage) And as mentioned, make sure the radiator is clear of debris, and that the fans are working. Also, a low octane gasoline or "old" gas would cause this problem, as well as an engine that is out of ignition timing. If the car is an automatic, and the transmission is not functioning properly or requires a fluid change can also cause a hot temp.
AnswerCheck that both fans are running and that the radiator fins and A/C Condenser fins are clean and clear.Change your thermostat to a 160 .This will help alot & is cheap.
This is the proper temp for the thermostat is to turn the fan on at 230 and off at 220
How do you disable the alarm and starter cut off system in 1984 Corvette?
I need to know to same...somebody HELP!!!
Hi my name is jeff, on my 1985 corvette there is a little black box about the size of my hand with several wires going in2 it. this box is located on the passanger side by the ecm...i believe if you just unplug it that it will not effect anything else but the little light that says security when the door is open...on another note if you jiggle the key back and fourth really fast from the accesory on to start position wile the alarm is going of.. it starts!!!!!!!! that is on mine anyways lol
Where is 1 cylinder of distributor cap rotation 1990 4.3L GM motor?
http://autorepair.about.com/library/firing_orders/bl-fo-9673.htm
Where is the fuse or relay located for the horn on a 1997 Buick Riviera?
It is located in the fuse box under the hood on passenger side.
How do you replace c4 corvette water pump?
google it...youtube..it would be too hard to explain in words dude. something like that
Where is the wiper motor relay located on a 1969 corvette?
Under the center console between the ashtray and the radio
How do you connect horn relay for 1969 corvette?
Very simple, it is either near the brake booster or hanging under the dash near the fuse box. Disconnent your negative battery cable, carefully pull the old one out, put a little lube on the new one and insert it. Reconnect the negative battery cable. They are a standard relay found at most parts stores.
Will a 454 motor fit in a 1990 Corvette?
yes but there will be lots of mods such as stearing rack, headers, and hood. but it can be done. :)
How do you replace Corvette c3 battery?
If you are replacing the battery only and the cables are fine:
First things first... Disconnect the battery. Positive first and then negative.
Remove the retainer plate which is to the rear of the battery inside the car's battery cavity located behind the drivers seat. You will need a 9/16" (I believe) socket and an extension to remove the retainer.
The tricky part is that you cannot see the bolt but it is in the center of the battery body to the rear side. A little more tricky getting it back in than removing it initially.
Remove the bolt. The long bolt and retainer can then come out. Remove the old battery and replace with the new one. Attach the positive cable first (It is a side post and will be marked) and then the negative.
YOURE DONE! Total time... Less than 5 minutes...
How many gallons of gas does a 2015 Chevy corvette z06 take?
The 2015 Chevrolet Corvette Z06 has an enlarged 36-gallon fuel tank.
How fast can a 1990 Chevy Corvette ZR1 go?
The top speed of a Chevy Corvette ZR1 is 205 mph, or 330 km/hr.
How long is the 2001 Chevrolet Corvette?
The 2001 Chevrolet Corvette is 14 ft. 11.7 in. (179.7 in.) long.
Where is the tire jack location in a 1981 corvette?
Check behind passenger seat. Lift out compartment tray, it should be there
In the hot summer my 1993 corvette overheats?
mine too, i cleaned the radiator area of leaves and then used a power washer to wash all the bugs off the radiator itself. it seems to have helped. i have read they run pretty hot anyhow around 200-220.
How do you reset computer 1992 Corvette?
Sometimes the computer of a car can become messed up. To reset a computer, one must find a car dealership that has the device to reset the computer.
What valve do you add freon to in a 1976 corvette?
the valve connected to the low pressure side of the AC pump. generally, this will be the hose that is larger in diameter (looking at the metal part of the hose where it connects to the pump, not necessarily the rubber part, since it's outside diameter may be larger due to reinforcement for high pressure, while having an actually smaller diameter inside).
if you plan on putting R-134 in instead of the original R-12 (which is getting harder to find) & nobody has done the conversion yet, you can get a conversion kit from most auto stores that will include the necessary adapters, oil, and all of the R-134 needed to completely fill your system. you wont be able to put R-134 in without the conversion due to the different type of connection, if ones never been done on it yet.
How do you reset computer in Corvette?
The computer in a Corvette model is responsible for notifying the driver of several things. It can be reset by disconnecting the battery.
How do you fix a stuck ignition key tumbler on a 1974 corvette?
tumblers are merely brass pins. go to any hardware store & purchase a small tube of graphite lubricant. it is a dry lube - do not use oil as it will make your tumblers gum up over time. simply squirt a small amount of graphite into the lock, then insert and remove the key a few times. if this does not free the tumbler, using a very fine pick or perhaps another key with a different cut, attempt to push the tumbler further into it's hole. once some of the graphite works its way into the hole, the tumbler will pop up like normal.
Lt1 Corvette motor heater proublem?
I have 95 Trans Am with a LT1 corvette motor. The heater inside the car does not heat very well. I was told I could have some air in the system. Thermostat is new.Heater core hoses seem warm not hot . 90-110 using thermal gun on the out side of hoses.Back of heater core showed 115 deg. Should heater core be back flushed? Any ideas on how to get more heat to the driving area?