0
Chrysler Concorde
Chrysler Concorde was a four-door, front wheel drive vehicle manufactured from 1993-2004 by Chrysler. The vehicle was designed with short overhangs and low slung windshield. Its wheels were effectively placed to the side of the vehicle to create a bigger passenger cabin than its competitors.
815 Questions
1998 Chrysler concord 2.7 just ran for 20 minute's - bs.
Where is the control module on a 1995 chrysler Concorde?
Engine, transmission, ABS are under the hood.
Body, airbag, cluster, HVAC, RKE, are inside the dash.
Where are the subframe bushings located on a 1997 Chrysler concord?
They bushing are located under the car about 1-2' behind wheels, where the rear and front frames come together. There will be what looks like a rubber washer under a big bolt inset about an inch.
Why would cruise control quit working on a 1998 concord?
Check your fuses first; you may have a bad fuse.
Where is the battery on a 1998-2004 Chrysler Concorde?
== == it is behind the front passenger wheel fender The battery is buried within the front section of the passenger side front fender. Disconnect the neg battery cable close to the firewall. Remove the bolts holding the air cleaner assembly in place. (Removing the air feed tube from the air cleaner assembly helps) Once this is removed, you should be able to see the battery hold-down bolts. Remove these and remove the hold-down assembly. If you are removing the battery, remove the 1st battery cable. Depending upon what battery you have, you may be able to slide the battery back toward the wheel and disconnect the 2nd cable. Jack the vehicle up, put on jack stands and remove the passenger side wheel. On the front side of the wheel well there is an access panel that needs to be removed in order to access the battery. There are 6-8 1/4" screws to remove. Then manipulate the cover until you can remove it, bending it slightly. If you were unable to disconnect the 2nd battery cable earlier, you can now move the battery further towards the rear of the car. Remove the 2nd cable clamp from under the hood. Slide the battery all the way out. It is heavy! Reverse the instructions for reassembly. Hope this helps.....
What does the cam position sensor control on a 2000 Chrysler Concorde 2.7l?
It sends a signal to the engine computer to tell it the rotational position and speed of the camshafts. The computer uses that information for fuel and spark timing.
It sends a signal to the engine computer to tell it the rotational position and speed of the camshafts. The computer uses that information for fuel and spark timing.
The 2.7L is an interference engine.
What do you do if your 97 Concorde LX has a code that says egr valve circuit?
It means that the On Board Diagnostics computer is receiving information from the sensor array that indicates a condition that suggests a problem with the EGR (Exhaust Gas Recirculation) circuit. The EGR valve on that model consists of two parts - a vacuum manifold and a valve body. The hoses between the valve body and vacuum manifold could be leaking or disconnected, the gasket between the EGR valve and intake manifold could be bad or the valve itself could be stuck open or closed. If you have a handheld vacuum pump, you could attach it to the vaccum port and see if the valve will pull in when vacuum is applied. If you're not handy, it will be necessary to either find someone who is or take it to a trusted mechanic. The part costs about $100 from automotive parts suppliers.
Where is the radiator temperature sensor of 1997 Chrysler 3.5 liter engine?
The coolant temperature is measured by the sensor that is screwed in to the engine next to where the upper radiator hose attaches.
When do you change the timing belt on a 1994 chrysler concorde?
Every 100,000 miles
Every 100,000 miles
Where is the fuse for power windows located on a 1999 Chrysler Concorde?
Open front passenger door and you will see fuse box labeled on dash board. Between door and dash board.
Where is the fuel filter on a 2000 Chrysler Concorde?
Under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module.
How do you replace the tie-rods for a 1994 Chrysler Concorde?
Jaybird1980 outer tie rod get the parts first verify they are the same (length and style) 1 loosen jam nut to outer tie rod (the nut that is threaded on the inner tie rod just behind the outer tie rod.) 2 (remove cotter pin) loosen castle nut or if it has a locking nut just remove the nut. air tools make life easier in this situation. 3 take a tie rod separator tool (pickle fork) and separate the tie rod from the spindle (takes a few blows) If you don't have this tool you can just use a hammer but be accurate and careful when swinging. 4after separation you should be able to unthread the outer tie rod from the inner tie rod. (leave the jam nut on or if new tie rod comes with a new jam nut take off the old by first marking a reference point where the old nut is. either count threads or take a paint marker or even tape. This keeps the toe align angle roughly where it should be. 5 reverse procedure with new part (tip use anti seize compound on the inner tie rod threads so when aligned it does not seize up long time down the road) 6 torque nuts to manufacture spec and replace cotter pin every time if it has a castle nut.
How do you replace the battery in a 2001 Chrysler Concorde?
Remove Air box assembly, and Right front wheel. There is an access panel into the battery compartment, remove using 6mm socket. Battery is held down by a bracket 10mm and a long extension. Remove battery cables 1 at a time and pull battery through access panel in fender well.
Where is the engine oil drain plug on a 1999 Chrysler Concorde 3.2L engine?
It is on the bottom of the oil pan.
Why doesn't your transmission change gears?
my 1998 ford escort has had this problem for a couple days and I went to Shucks and borrowed their fail code sensor for free. when I hooked up the code sensor, it said that our shift solenoid was failing. So, your shift solenoid may have gone out if you have an automatic transmission.
Chrysler Concorde check engine light?
The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to AutoZone or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.
Where is the battery located on a 2002 Chrysler Concorde 3.5?
In front of the passenger side front tire. Remove the fender liner to access.
In front of the passenger side front tire. Remove the fender liner to access.
Where is the coil pack in a Chrysler Concorde?
The coil pack in a Chrysler Concorde can be found under the hood. The exact location is on the right side cylinder head.
Depends on the type of car some by vacuum others by electric motors.
Johnny Texas.
Chrysler Concorde engine why overheat cause?
Could be several things, is there coolant in the overflow tank? **Don't open cap when hot** does your heat work? your heater core might be clogged? do your fans turn on to cool the engine? Do you have oil? & what does it smell like ? burnt ? or just like old oil
I had this problem on a 98 Jeep, it was a clogged heater core, & rusty coolant
....
Matt
How do you repair a 99 Chrysler Condore driver's side power window that has come off the track?
The problem may not be that the window has come off the track. I have a '98 Chrysler Concorde and the driver's side window wasn't operating correctly so I took the interior door panel off and found that one of the brackets that anchor the window to the track had broken. I tried to repair it with JB Weld but it didn't hold. I'm going to have to buy a new window.
