How do you remove a wiper arm on a 1995 Chrysler Concorde?
I just did this on my car (same make/model/year). To remove the arm you will need to use a little force. You will notice first a hose with a join in the middle where the arm meets the cowel of the car (the plastic vent shaped piece right by the base of the wind shield). This hose is how the windshield solution is delivered to the wiper arm. You want to pull this hose apart right at the join, it should come apart.
Now you need to remove the arm itself. There is a metal mushroom shaped piece that comes out of the car, the wiper arm slips over the head of this mushroom. The metal tab which is attached to the wiper arm (that slipped on) simply slides under the bottom of the mushroom head to keep it from coming off. You need to pull this tab out to remove the arm from the mushroom head. This tab is not always easy to move.
I used a screw driver to gently pry the tab downward (toward the cowel) so it would come loose. Once loose I slid the tab out (it doesn't come out completely, just partially) until I saw a small hole in the tab piece. Then I pried the arm off the mushroom head using a fulcrom and a lever combined with a gentle twisting and pulling motion. It came off this way.
Good luck.
What is a P0340 code on a Chrysler Concorde?
P0340 No Camshaft Sensor Signals At PCM - With Automatic Transmission
Possible Causes Setting Conditions * CMP sensor connector is damaged (check pins for damage, and for moisture) * CMP sensor signal circuit is open or shorted to ground * CMP sensor signal circuit is shorted to voltage * CMP sensor ground circuit is open * CMP sensor has failed * PCM has failed Engine cranking; system voltage over 10.0v, and the PCM detected CKP pulses without detecting any CMP sensor pulses for 5 seconds during 2.5 complete engine revolutions.
This code sets in 1 Trip(s).
This code will turn on the MIL (Malfunction Indicator Lamp)
Where is the starter on a 1998 Chrysler Concorde?
It is on the driver side of the engine, just above the oil pan.
Where is the number one plug located on 1998 Chrysler Concorde 3.2?
Front passenger side.
Front passenger side.
How do you replace front struts on 2002 Chrysler Concorde?
Unless you have the knowledge and tools to handle it have it done. YOU COULD GET SERIOUSLY HURT
It probably hasn't fallen off the track. The part of the window regulator that attaches to the window is probably broken. Mine did the same thing. I took the window and regulator out of the car and epoxied the part back together and then reinstalled it. Been over a year now and still working fine.
Why does Peugeot 205 diesel engine run on when ignition turned off?
you need to replace the stop solenoid on the top of the fuel pump if it is a lucas pump. I had the same problem, but they are are fantastic price, ie £72 plus vat from main dealer, so shop around or get one from a breakers. mine started without having to bleed the system, but you might have to. do it quick and it should be ok, be careful not to get the threads crossed it is fiddly. Keith 1990 205 grd
Where is the thermostat on a 1999 Chrysler Concorde?
It is under the housing where the lower radiator hose hooks to the engine.
Where is the body control module on a 1998 Chrysler Concorde?
The body control module is on the back side of the under dash fuse box on the driver side.
How do you disconnect a Chrysler concord alarm?
You can't. The alarm is built into the bcm and can not removed.
Can i get to the fuel pump from under the back seat 1994 Chrysler Concorde?
No, the access panel is in the trunk.
Where is the thermostat on a Chrysler Concorde?
1993-1997 it is under the housing where the upper radiator hose attaches to the engine.
1998-2004 it is under the housing where the lower radiator hose attaches to the engine.
1993-1997 it is under the housing where the upper radiator hose attaches to the engine.
1998-2004 it is under the housing where the lower radiator hose attaches to the engine.
Where is the transmission drain plug for a 1994 Chrysler Concorde?
It doesn't have one, you have to remove the pan
It doesn't have one, you have to remove the pan
Where is the crankshaft sensor on 1998 Chrysler Concorde?
rear passenger side of engine, it sticks through the side of the bell housing.
Where is the ECM located in a 1994 Chrysler Concorde?
On almost all Concorde the ECM/PCM is located in the engine bay on the right hand side under the air filter box. The TCM is located in the engine bay on the left hand side near the battery.
Where is the kill switch on a 1998 Chrysler Concorde?
Chrysler does not use kill switches. The fuel system is computer controlled with relays.
Wire colors and wiring diagram printout for 2004 Chrysler Concorde 2.7 l?
stereo wiring diagram for 2004 Chrysler Concorde
Is there a trick to getting headlight housing out of 2004 Concorde?
very hard ,front clip above radiator needs to be removed ,after out remove two bolts at top of light and turn light different ways to get out
Is a 99'Concorde 3.2L an interference engine?
Yes the 3.2 for that model of Concorde is an interference engine.
How do you disable the door ajar sensor for a 1998 Chrysler Concorde?
The sensor is part of the door latch. You would have to remove the door pne and unplug the latch.
Why might a 2001 Kia Sportage not start?
Mine did the same thing. Took it it Kia service center, after three days of them putting in parts, such as new fuel pump and tank, starter etc. they found out that a little relay, buried somewhere but very important to running, was not working. They replaced that and ran good since. Thank God it was still under warrenty so I paid for no labor or the new parts that they left in. My 2001 Sportage also did not start. I tried everything and finally paid $80 to have a garage put it on a computer. They told me the ECM (electronic control module - THE BRAIN) was bad. They also told me that part is covered under warranty by some Federal thing and Kia replaced it FREE OF CHARGE! They also paid for the towing of the vehicle to the dealership. The car is 5 yrs. old and they still covered it.