0
Chrysler Sebring
The Chrysler Sebring is a range of middle-sized cars manufactured by American carmaker Chrysler between 1995 and 2010. It is one of the few practically priced automobiles available in sedan and convertible body styles.
2,284 Questions
Why would there be no spark or no fuel getting to engine on 1997 Chrysler sebring?
Possibly the crank sensor or the coil pack is dead. But with a dead crank sensor you also get no spark, no crank. No crank equals no fuel delivery.
How do you change the air filter on a 2003 Chrysler Sebring?
This one's a snap... well, about 4 snaps... At the unit that houses the filter, there are 4 snaps that hold the case together. Simply raise them up - one at a time - until the top comes off... From that point, replace the filter and reverse the process to put it back.
If you've not done this in awhile, you won't BELIEVE how dirty the old one is!
Tom Pay It Forward
What causes a squeaky front end on a 2001 Sebring when the wheels are turned either right or left?
my 97 sebring had the same noise that you say, there in a factory recall on 95-01 01 sebrings for the front ball joints call the dealer and they will replace them for free this solved my problem and i get better gas mileage too!
Where is the oil filter located on a 2003 Chrysler Sebring?
It is located at the passenger side behind the oil pan. You need to be under the vehicle to watch it .
Where is the pcv valve on a 1999 Chrysler Sebring V6 non-turbo fuel injected engine?
It's on the left (passengers) side of the front valve cover. There's a black hose going into it. It should just pull right out. When it's out it just looks like a nipple thing that rattles unless it's clogged.
What are the three buttons for on a 1999 crysler sebring lxi sun visor?
The three buttons on the sun visor of a 1999 Chrysler Sebring Lxi are for opening garage doors.
Brake light staying on a 2004 sebring?
Brake switch is bad. It should be at the top of the brake pedal under the dash.
How do you lower convertible top in sebring?
Pretty straightforward, actually.
# STOP THE CAR, make sure you have clearance (not in a garage, for instance). # Lower both visors. # Unlatch both top latches that were hidden under the visors, the top may spring open a bit, which is fine. # Use the control button (located at the front of the armrest center console, under your wrist if you lay your arm down in a driving position) to open the top. The windows may roll down slightly before the top begins to retract. Let the top retract fully. (you may also at this point put the retract-cover on if need be - check your trunk for it)
# Enjoy. # To put it back up, do the reverse - button to get the top up, latch both top latches, roll up windows, move both visors up. make sure your parking brake is always on going up or down also.
Do fog lights come on automatic when the headlights come on a 2000 Chrysler sebring convertible?
No, the fog lights have a switch.
No, the fog lights have a switch.
What causes lights to flicker inside a 2002 sebring lxi?
The primary causes for the lights to flicker inside on a 2002 Chrysler Sebring LXI is a loose bulb or wire. This can occur when the vehicle has experienced rough road conditions and excessive vibration.
What type of transmission fluid is used on a 1997 Chrysler Sebring convertible auto 4 speed?
Molar ATF+4
Where is the thermostat located on a 1997 Chrysler Sebring?
2.4L On the engine end of the upper rad hose. When replacing it make sure the spring goes toward the engine
2.5L it is under the housing that the lower radiator hose hooks to on the engine.
Signs that there is a problem with the electronic relay in a 2002 Chrysler Sebring?
i just put a new computer in my 2002 sebring and now I am having a problem starting the car
Where is the neutral safety switch on a 1997 Chrysler sebring?
It is inside the transmission, on the valve body, it is called a TRS (transmission range sensor).
Why did your sebring start blowing air from the defroster after you jump started it?
Your battery went dead sometime and it messed up the computer. Disconnect the ground for 5 or more minutes. Reconnect and it should work. Please see the related question below.
Compass Calibration
The Automatic Compass Calibration feature eliminates
the need for the operator intervention under normal
conditions. If the CAL indicator is lit, the compass needs
to be calibrated. A good calibration requires a level
surface and an environment free of large metal objects
such as large buildings, bridges, underground cables,
railroad tracks, etc.
Manual Compass Calibration
Compass calibration can also be requested. To manually
calibrate the compass, use the STEP button to step to the
compass/ temperature display and then hold down both
the STEP and US/M buttons simultaneously until the
CAL symbol is displayed. Release the buttons once the
CAL symbol appears. Manual compass calibration has
been initiated at this point. Drive the vehicle in circles in
an area free from large metal objects until the CAL
symbol is extinguished.
When the CAL indicator goes off, the compass is calibrated
and should display correct headings. Verify
proper calibration by checking North (N), South (S), East
(E), and West (W). If the compass does not appear
accurate, repeat the calibration procedure in another area.
Compass Variance
Variance is the difference between magnetic North and
geographic North. For proper compass function, the
correct variance zone must be set.
Setting the Compass Variance
Refer to the variance map for the correct compass variance
zone. To check the variance zone, the ignition must
be on and the compass / temperature displayed. Hold
down both the US / M and STEP buttons simultaneously
until the VAR symbol is lit and then immediately release
both buttons. The current variance zone will now be
displayed. To change the zone, press the STEP button
until the correct zone is displayed. Wait for about 5
seconds. The trip computer will store this variance in
memory and the compass will resume normal operation.
Is there a manual release for the fuel door for the 1998 Chrysler Sebring?
yes there is- its called walking back to the fuel door and opening it like any other car.
If this is the terminal mounted on the window, clear silicone is best.
What is involved in changing a voltage regulator on a 2004 Chrysler Sebring?
The regulator is part of the engine computer. To replace the engine computer a scan tool is required to program the vin, and chip key info if equipped.
