Daewoo Lanos

There is NO TRANSMISSION DIPSTICK on the Daewoo Lanos

Try using the wiring diagram from a Pontiac Lemans. From the 70's to present GM and Daewoo have a partnership that gives us today the Chevy Spark.

I had same problem i emailed daewoous and they responded: Following are fifteen (15) individual, 4-digit codes:

4316, 2152, 4513, 4362, 1156, 2145, 3451, 6361, 5624, 5241, 3346, 1165, 3241, 4524, 5436

Using the station preset buttons, input each of these individual 4-digit security codes into your audio unit ONE 4-digit code at a time. ONE of these security codes should work for you.

IF NONE OF THESE SECURITY CODES WORK FOR YOUR AUDIO UNIT, you will need to do the following:

1.Using a suitable trim removal tool, carefully remove the frame / trimplate that surrounds the audio unit.

2.Remove the audio unit retaining screws.

3.Slide the audio unit forward and look on TOP OF THE UNIT in the lower right hand corner. There, you will see a label with 10 numbers on it.

Example: 1234567890

4. E-mail us with this number and we will provide your code. customerse​rvice@daewo​ous.com

You cannot adjust the belt tension on the alternator, it is automatically adjusted by the automatic tensioner located by the A/C compressor, if it's squealing check the tensioner for sticking, the belt for wear and the pullys for bearing noise.

I don't know about that, like most all cars, you can tighten/loosen the belt by moving the alternator back and forth.

You can adjust the serpentine belt in about 5 mins. get a socket wrench preferably one with a swivel, and losen the top bolt of the alternator located on the back-top of the alternator, dont loosen too much, hard to tighten back up when TB is in the way. take a large prybar, find a solid point to put base of prybar up against, push top of prybar towards rear of vehicle till belt is at desired tension"may take a try or two" hold prybar in place till you can get bolt on alternator tightened. should be all set.

Robert Cravens_Robert@yahoo.com

You need to unscrew the plastic of the door and remove the plastic handle then get the window low you will see 2 plastic screw, unscrew and then you have to pull up the window with your hands. It's very easy.... :)

18 lb/ft +70, +70, +30 Degrees using angle gauge,

http://wiki.answers.com/Q/What_are_the_cylinder_head_torque_specs_for_daewoo_lanos_98 wwwstlouisparking.com .to Answering "Need timing specs for a 2000 daewoo lanos with the 1.6 dohc engine also need the torque specs for the head too

The valve timing markings for the Daewoo Cielo 1500 typically involve aligning the timing marks on the camshaft and crankshaft to ensure proper engine timing. When installing or adjusting the timing belt, these marks should be aligned according to the manufacturer's specifications, usually found in the service manual. It's crucial to ensure that the engine is at the correct position (usually at top dead center) when making these adjustments to avoid engine damage. Always double-check with the specific service manual for your vehicle's year and engine type for precise information.

To reset the airbag light on a 2000 Daewoo Lanos, first, ensure that the vehicle is turned off. Disconnect the negative battery terminal and wait for about 10 minutes to allow the system to reset. Reconnect the battery, then turn the ignition on without starting the engine. If the airbag light remains on, it may indicate a persistent issue that requires diagnostic troubleshooting.

To remove the sump plug on a 1999 Daewoo Lanos, you typically need a 14mm socket. It's advisable to check the condition of the plug and use a ratchet with an extension if needed for better access. Make sure to have a drain pan ready to catch the oil during the process.

In the Daewoo Lanos, the heater light typically refers to the indicator for the heater, which is part of the climate control panel. To replace it, you will need to remove the dashboard panel and the climate control unit. Once the unit is accessible, locate the bulb for the heater indicator, remove it, and replace it with a new one. After replacement, reassemble the dashboard to complete the process.

Daewoo cars were originally manufactured in South Korea. The brand was established in 1937 and became well-known for producing a range of vehicles. However, after financial difficulties, Daewoo's automotive division was acquired by General Motors in 2002, leading to the production of vehicles under the Chevrolet brand in various global locations, including South Korea, India, and Eastern Europe. Today, the Daewoo brand itself is largely defunct, but some models continue to be produced under different names.

Yes, the fuel flap on a 1.6 Daewoo Lanos is the same as the one on a 1.4 Daewoo Lanos. Both models share similar body designs and components, including the fuel flap. Therefore, they are interchangeable. However, it's always a good idea to confirm with a parts supplier or service manual for specific compatibility.

A number 4 cylinder misfire occurs when the engine's fourth cylinder fails to ignite the air-fuel mixture properly, leading to uneven engine performance. Common causes include faulty spark plugs, ignition coils, fuel injectors, or a vacuum leak. Symptoms may include rough idling, reduced power, and increased exhaust emissions. Diagnosing the issue typically involves checking ignition components and fuel delivery to ensure proper operation.

To adjust the idle speed of a Daewoo Lanos 1.2, locate the idle speed adjustment screw on the throttle body. Start the engine and let it warm up to operating temperature. Use a screwdriver to turn the screw clockwise to increase the idle speed or counterclockwise to decrease it, while monitoring the RPMs with a tachometer. Ensure the idle speed is set according to the manufacturer’s specifications, typically around 800-900 RPM.