Electronics Engineering

5 A

yes

becuase electrons are always motion in outer orbital

I submit there are always losses except on a perpetual moving machine which does not exists

A specific brand of microcontrollers.

Atmel = company

microcontroller = small device capable of processing, i.e. making calculations, make logic decisions and communicate to external devices.

Applied Electronics and Instrumentation are subjects for applied engineering. It is a combination of Electronics and Instrumentation Engineering. The course has a great scope and is offered by many universities.

This question has a lot of answers (thanks to the urban dictionary - google it), with the official concise dictionary answer being:

A Miller is a person who own or uses a mill to crush grain, in order to make flour.

Q not cu. A circuit can detect frequency increasing or decreasing when it reaches its design center maximum power transfer can be transferred . "Q" IS JUST THAT POINT. It can be designed as very sharp or broad

If all your fuses appeared to have constant power, I'd have to say that your ignition was not in a fully "off" position. Possibly turned backward to the accesories setting?

the coercivity is test by drawing B-H curve.Coericivity is defined as without giving any magnitising force it will produce magnetic field intensity.

It is an electronic device on board a geostat satellite to receive uplink data and picture bits,amplifying it before converting it to a downlink freqency bit stream and sending it down to earth.

A: Its purpose is to correct the power factor of the line.

You unplug it and plug it back in

voltmeter

yes, parasitic. there is also parasitic inductance.

Resistors come under passive electronic components and are extensively used in electronic circuits. So important are these components that it may be virtually impossible to build an amplifier circuit without involving resistors. Basically the function of a resistor is always to oppose the flow of current through it and the strength of this opposition is termed as its resistance.

When resistors of the same value are wired in parallel, the total equivalent resistance (ie the value of one resistor that acts identically to the group of parallel resistors) is equal to the value of the resistors divided by the number of resistors.

For example, two 10 ohm resistors in parallel give an equivalent resistance of 10/2=5Ohms. Three 60 ohm resistors in parallel give a total equivalent resistance of 60/3 = 20Ohms.

In your case, four 200 Ohm resistors in parallel give 200/4 = 50 Ohms total.

A voltage regulator used on older aircraft electrical system. It is comprised of three units, hence the name. The first unit is a breaker point assembly, followed by a current limiter, and finally a reverse current relay.

It's highly possible. The difference in amperage might be minuscule but it all depends on the gauge of the wiring, the resistors, and the capacity of the board.

56H is a NEMA frame size. See related links below.

EPBX(Electronic private branch exchange) are Phone systems, which traditionally run on proprietary special purpose computers, can run on ordinary servers and workstations, allowing telephones to work just like any other computer application.

Multiplexes are a bundle of TV services that has been compressed into a data stream. These are combined data in a single channel.

* == 1st generation vacuum tube look like as a parallel electric bulb. _____

----_____)

An ohmmeter is used to check continuity and resistance. An unfavorable use would be to connect the meter to any power. Unless the meter has a safety feature, connecting it to any type of power will damage the meter.

Its slows down energy when it passes thought the light depntent resistor.