0
Geo Metro
The Geo Metro was a small economy car produced between 1989 and 2001. The first generation model was available as 3-door and 5-door hatchback, as well as 4-door notchback sedan. It came in three trim levels: XFi, Base and LSi.
1,033 Questions
Where is the fuse panel located in a 1998 Chevy Metro?
why not awnser? there are 3 fuse clusters. 2 under the hood on the drivers side and one under the drivers side dash board tucked up high on the left.
What does the 'doors locked' light mean on a 1992 Geo Metro?
It tells you the doors are not locked. The light goes out when you lock the doors. It's just a friendly reminder to lock your doors.
How do you replace the headlight bulb located on a 1996 Geo Metro?
If you have the sealed beam type (headlight sunk in and surrounded by black plastic trim) you remove the screws surrounding the headlight, disconnect the electrical connector, and put in a new one.
If you have the composite type (headlight and marker light in one unit and more aerodynamic) then you get to have fun. There are two ways to go about this. Either you can reach behind the headlight assembly and try to unplug the electrical connector to get to the bulb socket (you have to squeeze the two tabs and turn counterclockwise and then pull out) or you can remove the entire assembly. That takes two bolts and makes things much easier if you can't reach the plug in back to remove the bulb socket. Then once you have the bulb socket out and you have the bulb in front of you, put the new bulb into the socket and put it back in the assembly. (Don't Touch The Glass!!!)
Wal-Mart and other oil change shops will help you install headlight bulbs, but if your whole assembly is broken, do as stated above and remove the bolts holding it to the radiator support core, take out the bulb socket, and reverse to install.
New answer HeadlineThe electrical plug must be unplugged from the bulb on the back.On the back of the light there is a ring that is about 3inches in diameter that must be twisted and removed. Then you must remove the rubber cover that seals the bulb. Then there is a retaining wire that must be unclipped to release the bulb. Battery must be removed on the drivers side to access the bulb.What causes a Geo Metro to die when you stop at a light unless you hold the brake and gas together?
Your idle may need to be set up a little I had the same problem with my 1992 Geo Metro 3 cylinder 1 Liter, when i stopped at a stop light the car would die. Check your compression on all cylinders, most likely the problem is with some burned exhaust valves. I overhauled my motor, new piston rings and replaced all exhaust valves, now it idles just fine. Answer--- You may have a flithy air filter which will starve the car. Or it could be dirty injectors and a fuel filter that needs changing. A whole lot cheaper to try these before you do a rebuild.
Where is the oxygen sensor on a 95 Geo Metro?
It will be screwed into the exhaust pipe somewhere between the exhaust manifold and the catalytic converter. Most likely on the front of the engine on the bottom, sticking out fron the pipe with a wire coming out of it. some were after the cat converter. my 94 is before the cat converter, but the 94 is also a split year I think. I dont know which way they were moving them (before or after). Mine sticks straight out of the exaust pipe about 6 inches below where it mounts to the manifold. If it were after the converter it would definatly be under the car on the exaust pipe.
Where on a 1992 Geo Metro is the IAT sensor?
on a 3 cyl.metro,the iat sensor is found on the air cleaner housing towards the rear of the assembly
How do you test a Geo Metro 1995 ignition coil?
A 1995 Geo Metro ignition coil is tested by measuring the resistance across the coil. If it exceeds the manufacturer's recommendation, it must be replaced.
