Hand Tools

i went to jail for 3.4 years for doing that so i would recommend not doing it

Basically, coated with a type of hard wearing Teflon.

So it can sit squarely on the nut, but you won't skin your knuckles turning it.

I believe that is a 7mm Allen.

A 4 mm drill bit is equivalent to 5/32 inch.

Locking pliers are used mainly in aircraft maintenance, and mostly in the military. Many nuts that may be subject to loosening under vibration have small holes drilled in 3 places on the outer edge. A thin stainless steel wire is threaded through one of these holes when the nut is torqued up, and then the ends of the wire are gripped in the locking pliers and twisted till they reach an anchoring point nearby, threaded through it,and gripped and twisted again. In this way the nut can be held immobile.

Hexagon

Depends on the vehicle. -When I do this on a strange vehicle, I get under with a few wrenches nearby, a 1/2, 9/16, 12 mm, 13mm, 15 mm and crescent.

magnisum

You will certainly get hurt if you throw a hammer at your foot and the hammer hits your foot - unless it is a very light hammer or you are wearing substantial foot protection.

A saw is not a wedge, it's a cutting tool.

A large oblong block of steel with 2 flat heads and a handle 24-36 in. long.

To cut cable.

"cheapest" and "most reliable" seldom occur in one tool, don't get your hopes up.

Fine-nosed pliers, also known as needle-nose pliers, are a type of hand tool characterized by their long, thin jaws that taper to a point. They are designed for gripping, bending, and manipulating small objects in tight spaces, making them ideal for tasks like jewelry making, electronics work, and detailed craft projects. The precision tip allows for intricate work, while the gripping surface ensures a secure hold on small components.

Allen wrenches are used to tighten and loosen Allen screws.

You need a 7 m Allen key for that year Cougar. -Of course that key is not commonly in Allen sets, so be prepared to buy one on it's own at a good tool store.

It is a light carpenters hammer.

I've never seen one in many years of working with all kinds of tools - a screwdriver is JUST that.

If they are self tapping screws, the drill bit is as thick as the solid barrel of the screw. If you want the screw to go through easily to have a nut on the other side, then the drill bit is slightly larger than thread size.

All bolts in any vehicle have specific torque ratings. -There are usually at least 35-50 specified torques for all the bolts. -You haven't said WHICH bolts you want the torque value for, so we can't answer. -Your best bet is to buy the specific manual for your car where all the torques will be written in one page.

You need to know clearance to adjust tappets accurately.

It depends on the qeuality of the equipment. Novelty store cuffs can be bought for a few dollars. Professional-grade handcuffs can cost upwards of a hundred dollars.

It's a small hammer used in upholstery (before they had electric staplers ) One head is a round flat surface, about 3/4 " diameter and the other is the 'peen'.This is a flat short surface about 1/8 wide and 1/2" long meant for hitting small nails while you hold them.