0
Jaguar X Type
The Jaguar X-Type was a compact executive car produced from 2001 to 2009. This was the smallest of the Jaguar model range and was offered in 4-door saloon and 5-door estate body styles.
572 Questions
How do you change the headlights to European dipping on an x type?
X - Type Oners Manual, page 96, ----- "a leaver, within the main beam headlight, is used to dippped beam adjustment for touring. This lever flattens the dipped beam to avoid dazzling oncoming drivers.
Open the bonet and remove the round cover from the main beam headlight.
Move the lever in the left-hand headlight DOWN and move the lever in the right-hand headlight UP, to flatten the beam for driving on the right side of the road.
Remember to place the lever back in the original position when you return to country of origin.
How do I set up a phone in a 2003 Jaguar X type?
you would either have to buy a parrot if your phone is not the jaguar one. If you buy the proper jaguar phone it just plugs in under the arm rest.
Where do you install freon on a 2003 jaguar x-type?
fish is there main food in the rain forest fish is there main food in the rain forest
How do you install brake pads on a 2002 jaguar s type?
on the front its straightforward , just remove caliper remove old pads, push back pistons then fit new pads and refit caliper, rears are harder as you need a piston rewind tool,, without one its quite difficult to do,, basically the tool pushes back the piston and turns it clockwise at the same time , this is because the handbrake uses a ratchet which has to be wound back,, hope this helps,,
Why does the battery light stay on in the 2004 jaguar x-type?
According to the owners Manual, this is an indication of an alternator failure.
How do you change spark plugs on a Jaguar X type?
I have not done the job yet but this is what I am going to do. Remove plastic cover over the engine ( three screws) You then have access to the front three spark plugs ( cylinders 1,3,5) remove the nut which holds down the independent coils and remove the spark plugs, fit new spark plugs and fit coils on the three front cylinders.
Now it gets a little tricky, you will only be able to access number 2 back cylinder so you have to remove the induction manifold (12 bolts I think) to access the back three cylinders (2,3,6,) properly. Then proceed as with the front three spark plugs, refit manifold and plastic cover, job done.
Removing the inlet manifold on Jaguar X-Type
After disconnecting all the plugs and hoses to the inlet manifold (I left the throttle body on the manifold, disconnected the two small heater hoses) remove the two bolts holding the cable harness at the rear, then the single bolt just below the cable harness. This bolt is located lower and to the right hand side (looking at the engine) difficult, DON'T DROP IT)) remove the bolt securing the inlet manifold to the support bracket. (R/H side.) undo the SIX BOLTS (WARNING. These bolts are of various lengths NUMBER THEM SO THEY GO BACK CORRECTLY) remove manifold. (Make sure just tighten the first time round, once all are fitted and tightened then torque them down)
It is advised to change the upper inlet manifold gaskets, there are SIX of them.
To change the Plugs at the front it is necessary to remove the air cleaner box, after removing the two bolts and bracket at top remove the air filter, you will see two screws inside the bottom of the box, remove these, then pull the box in an upward direction.
Refitting is a reversal
Inlet Manifold Bolts. Tighten to 10nm
Where is the head light sensor located on a 2002 jaguar x-type?
Check the back of your rear view mirror.
Would x type jaguar wheels fit on an xj jaguar?
They would fit on the newer xj's, after 2003. But wouldn't fit on the older ones, XJ8 (x308) or XJ6 (300). The older xj's stud pattern is 5X120.65, while the newer, including the x type and s type, jags are 5X108. The older jags are hard cars to find mags for, as standard euro 5 studs are 5X120, not 5X120.65, and will not fit on a jag.
How do you reset service light on 2003 jaguar x-type?
The best way is to use a code scanner ( handheld computer that plugs into the car ecu)
------
The location of the ecu/ecm module is located under the hood on the passenger side (Near the area where you add freon).
A picture of the location can be found below
How do you check transmission fluid in 2002 jaguar x- type?
Checking the transmission fluid is an important part of owning a car. A person pulls out the dipstick while the car is warm, wipes it off, dips it into the car and looks at the level of the fluid on the stick.
Gear oil check usually means on the differential or standard transmission. It pretty much has the same method. there should be a plug about half way up the unit. Remove the plug, add the right oil (usually 80w/90) until it runs out. while your there, remove the plug on the bottom first and replace all the fluid with fresh oil. good luck.
How much to insure rsx type s?
i am 20 years old and with full coverage and a few DD discounts and Student discounts pay 240 monthly with nationwide.. by far the CHEAPEST i found!!
Where is the air conditioning low pressure port on a 2002 Jaguar x Type?
It's located right on top of the ac piping on the left side of vehicle. It's dry tricky. You will have to cut away some of the covering around pipe, but trust me it's there.
How do you Replace the washer nozzle on a jaguar X-Type?
If you are looking to replace the washer nozzle cover (the painted part) all you have to do is carefully pull out the nozzle with a pair of needle-nose pliers and hold onto it while installing the new plate. You should be able to let go of the nozzle after installed the new plate and it will retract itself into the bumper.
How much is it to replace wheel bearings?
Between $250 and $350, it also depends on whether they have to align the wheels.
Yes and No.
If we are talking about the front wheel bearing you can do it yourself with a minimum of tools and time. Pick up a copy of haynes or chilton repair for the year of your vehicle the step by step instructions are very good. The rear wheel bearings are even easier to replace, but this depends on your vehicle make and model. In the case of the rear wheels if you can change a tire you can change the bearings, however this isn't the case for all cars.
Bearings cost from $40 to $400 and higher. Some cars require the entire hub assembly to be changed which could be even more expensive.
Labor will be about an hour for each bearing (about $70-$150) each.
Ans 2 - With so many of today's cars being front wheel drive, many amateurs can NOT replace front wheel bearings easily ! In these cases it's necessary to separate the main ball joint and remove the CV joint - NOT easy for an amateur
The cost to repair wheel bearings varies based on the exact part(s) being replaced, and the person doing the repair. It can run from $30 to $300+ just based on those variables alone.
