How do I reset a Jeep Cherokee 2007 alarm?
It takes a special computer program that can plug into cars diag port and input to ECU. An auto locksmith can do it on a laptop in about 10 mins. Look under services on Craigs for one that is mobile, should be about 100.00 (approx)
Where is the external voltage regulator on a 1996 Jeep Grand Cherokee?
The engine computer, PCM, is the voltage regulator.
Will a soft top from a 1993 Jeep wrangler fit a 1997 Jeep wrangler?
No, the top will not fit. Years 87 thru 95 are YJ. Years 97 thru 06 are TJ.
How do you reset the perform service notification 2004 jeep grand cherokee?
Press the step button until zero miles to service is displayed. Press and hold reset.
How do you reset computer on a 2004 Jeep liberty?
To reset the computer on a 2004 Jeep Liberty, you can disconnect the negative battery cable and leave it disconnected for about 15 minutes. This allows the computer to reset and clears any stored error codes. After the time has passed, reconnect the negative cable and start the vehicle, allowing it to idle for a few minutes to help the computer recalibrate. Alternatively, you can use an OBD-II scanner to clear codes directly from the vehicle's computer.
What type of freon do you use in the air conditioner on a 1999 jeep wrangler?
A 1999 Jeep uses R134a.
How do I know if my starter on my 2005 jeep grand Cherokee is out?
You can test it with a jumper wire or screwdriver. Touch the batt terminal and s terminal on solenoid (carefully and quickly and insulate yourself) it should bump it. Check batt voltage first and ensure is at least 10V, usually that is the problem.
Engine light can be done with a code reader, for anti theft you need an auto locksmith
Where is the fuse box located in the jeep compass 2007?
The fuse box is under the hood on the driver side.
How do reset air bag light on a 2010 jeep wrangler?
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
How do you fix a tear in a bench seat on a 2007 Jeep Wrangler?
To fix a tear in a bench seat on a 2007 Jeep Wrangler, start by cleaning the area around the tear with a mild detergent and water to remove any dirt or grease. Use a fabric or vinyl repair kit that matches the seat material, applying adhesive or patch as directed. For larger tears, you may need to sew the fabric together before applying a patch. Finally, allow the repair to cure fully before using the seat again.
Where i will drop from jeep on paso de blas?
When traveling to Paso de Blas, you will typically drop off at the designated jeepney terminal or a popular landmark in the area, such as a local market or a well-known intersection. It's best to confirm with the jeepney driver or passengers regarding the most convenient drop-off point based on your specific destination within Paso de Blas. Always ensure you have a clear understanding of your location to avoid any confusion.