Lexus RX

No if the service has been done these are excellent cars until long after 100K have you not seen the Toyota commercial with the little pickups? some had way over 200K and still working like champs. Lexus are Toyota products and we can expect the same from them. My RX 300 has over 104K and BB was still like 8K I call that value!

The Rx400h oil filter is on the front of the engine behind the radiator. You might be able to reach it from the top but it probably too difficult to remove and replace from the top. Remove the debris shield from the bottom. It has about six or so screws and two trim buttons which should be removed to free the shield. With that removed, you can see the filter about the middle oriented for and aft.

First remove the felt covered piece on the interior of the tailgate. After that, removed the large plastic piece in order to get inside to the bulb.

Most likely you need an oil change. That light comes on every 5000 or 7500 miles.

Center mount brake light bulb replacement procedure for a 1999 Lexus RX300

1. Open the rear hatch/door that contains the center mount brake light.

2. Locate the trim piece that is directly behind the center mount brake light. This would be the horizontal trim piece at the top of the hatch.

3. The trim piece is attached to the door via 4 clips. Grab the trim piece with both hands, getting your fingers and thumb behind the top and bottom of the trim piece, and give it a good pull straight towards you. Trust me you will not break anything if you pull it straight out. Mine came off on the first pull but I have fairly strong hands and fingers. The clip on the far left (drivers side) attaches differently than the other 3 so you might have to move the trim piece towards the glass AFTER the other 3 clips are loose.

4. Once you have the trim piece off, the back of the brake light fixture is visible. Just turn the bulb holder until it will pull out. Then remove burnt out bulb and replace with a new one ($1.99 at your local auto parts store). Once the new bulb is in, insert the bulb holder back into the fixture and turn it until it locks. Have someone hit the brake pedal to make sure it lights.

5. Now you have to replace the trim piece. I have found that this task is very easy if you remove the metal clips from the door and attach them to the trim piece instead of trying to line everything up with the clips in the door. Use needle nose pliers to remove the clips from the door being carefull not to scratch any painted metal. You may have to squeeze them a little to get them out. Once out, place them on the plastic tabs on the trim piece. The tabs line up with the clip holes in the door. As you now can see, the left clip is different. It hooks over the door rather that going into a hole in the door. When all four clips are installed on the trim piece, you are ready to put it back on. Start by hooking the left clip on the door and line up the other 3 clips with their respective holes in the door. Once everything is lined up, give the trim piece a good pop with your hand directly over where the clips are. 4 pops and your done. Test the brake light again just in case something came loose.

Written by Davidb 1999 Lexus RX300 AWD

There are clips at each end of the support that you need to remove, then they come right off. It is good to have a helper to hold the hood while you do this, or at least prop the hood up with a stick or something.

how do i remove rear spoiler on rx330 2004 model for repainting or recoating clear coat

Fuel injection system, fuel trim to lean (bank 1)

it run out of frion.

Refined Cross Country

The rubbing alcohol smell can indicate a Freon leak. The smell can also indicate a plugged drain tube. There is natural condensation that needs to drain away from the air conditioning compressor.

Remove your battery. Remove the battery tray. Remove the air filter housing and air intake duct. Remove the starter motor mounting bolts. Pull the starter away from the engine a bit. Detach the electrical connector from the starter solenoid. Remove the nut and disconnect the battery starter cable. Remove the starter and put in your new one.

power tail gate on 2004 Lexus RX 330 will not open when hot from sitting in the sun.

2003 Lexus RX300 daytime running light (DRL) bulb replacement: Purchase the correct replacement daytime running light (DRL) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the daytime running light (DRL) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

The 1994 dodge Caravan has the most common hook-end wiper arms on both front and rear. See the Sources and Related Links section below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.

It holds 5.1 quarts.

Ask your question again, i don't understand it... please double check your question...?

Are you asking how many cylinders in a Lexus rx300, it's V6 so it's 6 cylinder engibe...

I hope I answered your question... if not, kindly re-ask.... have a great day..

the headlamp glass is a non serviceable item, you can not disassemble the plastic exterior from the headlamp module. if your exterior lens is foggy from uv discoloration you may find after market products to clean and restore the clear lens.

With your key in the OFF position, push in and hold the odometer button. Turn the key to the ON position, the odometer will display 000000 after a couple of seconds. at this time, the maintenance light has been reset. This light comes on approximately every 5000 miles to indicate time for an oil change. If you change the oil yourself, just remember to reset the light even if it is not coming on.

Navigation DVD player is found in the rear liftback floor on the right side. Access the right rear floor at the liftback, open the compartment closest to the right rear seat. On the right side of the compartment there is a plastic cover you open this to give access to DVD unit. On the DVD unit there is a switch labelled open close. With the vehicle running press open and the DVD will open put your new disk in and press close, unit will run a diagnostic on disk then load data. Hope this helps.

I would need to know which bulb. They are all easy enough for anyone to do but you will need more specific instructions. as it will take forever if you are not familiar with the sequence. VBD

For Lexus RX300 - if you try to spray the wate and can't hear the motor/pump working, then most likely the pump is out of order. Need to order another pump.

1. Pull back the fender on the right hand side, right under the container (don't even have to open any nut)

2. You should find the pump attached to the container - just unplug the power source

3. Pull the pump out of the container (make sure to have a bucket to catch all the fluid) and unplug two pipes connected to it.

4. Install the new pump, and plug the power cable back in.

Its under the the front passenger seat

Vehicle Scid Control