0
Mazda
Founded in 1920 by Jujiro Matsuda as Toyo Cork Kogyo Co., Ltd, Mazda Motor Corporation is a Japan-based automotive manufacturer that sold over 1 million vehicles in 2007. Some of the popular vehicles manufactured by the company are Spiano, AZ-Wagon, MX-5/Roadster, RX-8 and BT-50.
1,848 Questions
Where is the abv in Mazda millenia?
pull off the plastic cover that says miller cycle. the abv will have a yellowish vacuum "hat" on it, right below about where the 'cycle' word is. if your miller cycle cover is missing, then the abv will be on the back(driver side) of the engine, right in the middle. at the very end of the intake. you will see the yellowish vacuum dashpot on the end of it. but, that valve never goes bad. if you are getting 1540 codes, it is most likely vacuum or vent circuit/solenoids(p1525/1526)
Tire size on the 2003 Mazda tribute?
It depends on your Trim Package.
If you have a "DX" model: P215/70R16 99T all-season radial mounted on16x6.5 six-spoke styled steel
If you have "LX" or "ES" Model: P235/70R16 104T all-season radial mounted on 16x7 five-spoke cast aluminum
Where is the OBD port located on a 2006 Mazda 3?
It's the small little "nook" above the lever that you pull to pop the hood.
Where is turn signal relay on a 1985 Mazda rx7?
The turn signal relay looks like a black rectangular box about 1"x1.5". It is located under the dash between the steering column and the clutch pedal. You have to lay on your back with your head down by the pedals, looking up, to see it. There is a single 10 or 12mm nut securing it. Remove the nut with a socket wrench, lower the unit, pull off the plug while holding down the small release. I would suggest finding one at a salvage since the new ones online go for over $80.
I just blew out my turn signals and couldn't figure out what was wrong. Checked the fuses, wires, and diagrams, and found no problems. I just happened to have a spare relay from an old harness, so I just tried it out and it worked.
How many miles per gallon does a Mazda CX-9 get?
The 2011-2013 Mazda CX-9 with Front Wheel Drive (FWD) is rated at 17mpg City and 24mpg Highway. AWD models are rated at 16mpg City and 22mpg Highway. 2008-2010 models were rated 16mpg City and 22mpg Highway for the FWD and 15mpg City and 21mpg Highway for AWD models.
Why does the engine rev up when you push in the clutch on a 1998 Mazda pickup b-3000?
I have this same problem with my B3000. The only results I have found is that the IAC (idle air control) sensor needs to be changed. Also, you could try cleaning the throtle body plate and sensor. This could be causing your truck to not realease the throtle body when engaging clutch.
Depends on the color. Black = Boy's car, Blue & White = Girl's
Can you fit a rotary engine in a 1997 Mazda rx7?
Yes. If you have an RX7, then it already has a rotary...and if it is a 1997 then you have a rare Japanese model.
Yes
They are all dependable fun to drive and have great performance compared to other models in their class. The late model Mazda 2 Mazda 3 and Mazda MX5 Miata's are all above average in reliabilty now.The Protege had rock solid reliabilty. RX7 was average in reliabiity. But none were below average in reliabilty that I know of.
Where is the fuel filter located for a 1995 Mazda mpv van?
if yours is like mine, then you will find it on the pasenger side frame toward the back of the engine bay. i have the 3.0 in a 94.
How do change the main 120 amp fuse in a 2003 Mazda 6?
Disconnect the negative battery terminal. Under the hood is the relay/fuse box. (On the right if you're looking under the hood.) Take the top off and you'll see the fuse up front with two battery cables held by 10mm bolts. Take them off. When you do you'll see a nice sized plastic tab running down between where you took off the battery cables. It's taped to the wiring harness. Use a screwdriver to cut the tape off the tab. Then you can push on four obvious tabs to pull the whole fuse/relay box out. Once you do you'll see one of the two 10mm bolts on the bottom that hold the fuse in.One you can get a socket on,the other requires patience with a box wrench. It snaps back together, put the terminals back on and you're good.
How much does it cost to replace the transaxle in 2005 Mazda 6?
for the 4 cylinder or v6? automatic or manual? these can be important details.
I understand that the OEM warranty covers 4.6 hours of labor for "complete assembly with transfer of parts" but 10.4 hours for overhaul/rebuild including replace and install transaxle. this is for the manual transaxle for the 4cyl. total cost would be shop labor rate multiplied by time spent, plus applicable taxes or other costs. i am unsure whether this covers replacement of fluids, so it may depend on the dealership or garage.
How do you adjust the valve lash on a 1990 Mazda b2200?
you don't the lash on a 90 model is not adjustable. the valves are hydrolic,unless they have been replaced with manual ones.
How do you change a bulb in center console of mazda6?
If you are trying to do this in a pre 2008 (facelift) Mazda6, I purchased my bulbs from:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=190510970759
and they can help you with a guide to remove it too.
Why does my Mazda bounty overheat going up hills and towing trailers or going over 100 km per hour?
sounds like you nee a new fan clutch, also known as a viscous, attaches your heat withdrawl fan to front of your block, its a liquid clutch and the liquid can dry up, ive just had same problem with mine
