0
Mitsubishi Lancer
The Lancer is a compact car manufactured by Mitsubishi. It has been sold in different countries as the Colt Lancer, Chrysler Valiant Lancer, Hindustan Lancer, Dodge/Plymouth Colt, Chrysler Lancer, Eagle Summit, Soueast Lioncel, Mitsubishi Mirage and Mitsubishi Carisma.
938 Questions
What type of oil does a 2005 Mitsubishi Lancer use?
15w-20 is the going rate for Mitsu 4-cylinder engines. You can get away with 10w-30 in most climates, but I tend to stick to what the manufacturer tells me.
2005 Lancer ES 2.0L, 4G94 Engine The ONLY two oil grades that are to be used with this engine are 5W30, 5W20 (colder temperatures: 100 degrees F and colder) and 10W30 (warmer temperatures: 0 degrees F and warmer).
How much oil does a 03 Mitsubishi lancer 1.8l gli hold doing oil change.?
I can find no specifications on a 1.8 L engine. Just drain the oil, and replace the filter with a new one. Pour in 3.5 quarts of the correct weight oil. Start the engine and let it run for 2 minutes. Shut down and wait 30 minutes. Check the oil level and then add as necessary to reach the full mark on the dipstick. You now know the capacity. Do not overfill.
How do you remove lancer radio face plate?
Pull knobs off for air and fan control. Remove 2 screws. Gently work cover off. To remove radio: remove 4 screws then pull radio straight out. Unclip radio wiring harness and antenna wire.
Where is the starter relay on your 2000 Mitsubishi eclipse gs manual?
For 1998 GST Spyder M/T is behind-underneath the radio (left one is the starter relay)
How do you change a Mitsubishi evolution lancer 6 clutch?
You must remove the battery, battery tray, upper intercooler pipe, clutch slave cylinder, transmission cables and clear all the wires from the top of the transmission. remove the cross bars, then the front to back sub assembly bar. Remove the wheels, and axle nuts, drain the transmission and remove the axles. remove the lower under-tray, then the steering rack/lower suspension arm assembly unbolt the transfer case, slide it to the side and rest on a jack-stand. support the engine and remove the transmission mounts. unbolt the transmission from the engine and lower the transmission. R&R the clutch, resurface the flywheel, and install everything. The job is a 4-15 hour job depending on tools and experience.
How often should you change a timing belt on a Mitsubishi lancer?
I have a 2005 Mitsubishi Lancer, and my mechanic said it should be replaced every 50,000 to 60,000 miles.
What is the front track of the 2012 Mitsubishi Lancer-Sportback?
The front track of the 2012 Mitsubishi Lancer-Sportback is 5 ft. 0.2 in. (60.2 in.).
Is there a fuse box in the 2004 Mitsubishi lancer engine bay?
Yes. On the driver side of the engine bay, covered by a rectangular piece of plastic. The cover is approximately 10x8 inches.
Where is the 02 sensor box for 1991 dodge with Mitsubishi engine?
No such thing as a O2 Sensor Box. The O2 sensor is located somewhere on the exhaust system. Looks similar to a spark plug with a wire connected. May be more than one. The o2 sensor on my 1990 Mitsubishi Mirage 1.5L (same engine as the colt i believe) is on the exhaust between the manifold and the catalytic converter
How do you remove the dash board on a 2002-2004 Mitsubishi Eclipse?
remove the screws. make sure you don
Car shakes when coming off a hill and stopping at a light in a 2003 a Mitsubishi lancer?
Commonly called hot spots in the rotors. The rotors have been heated quickly because of heavy braking and have actually warped. Consequently, as the rotor turn thru the caliper, the brake friction increases and decreases causing the tire to flex and bounce. The bounce is the shake that you feel. Take the car to a brake shop and have the rotors turned.
What is the purpose of the speed sensor on a Mitsubishi Lancer?
to calculate the true speed of the car taking wind speed and direction into account, like a light aircraft (TAS - true air speed)
Where is the input turbine speed sensor located on a 2002 Mitsubishi lancer?
remove the air intake box and look on top of the transmission, there are 2 sensors in the top case. the one closer to the bell housing is the input turbine speed sensor, the other is the output turbine speed sensor
Can a Lancer Evo Engine fit in a 2003 Mitsubishi Eclipse GT?
i suppose you could but i dont believe its a direct fit ,you would also have to switch the entire wiring harness for the motor if you can sort them out from the under hood harness and the the pcm and maybe the trans and poss the fuel pump? have custom exhaust made, and so on
How do you change the rear brake shoes on a 2004 Mitsubishi Lancer?
Is there a special tool that is needed to remove and replace the brake shoes?
How many miles can a Mitsubishi lancer do before there are to many?
My 2002 Mitsubushi Lancer has 103,500 miles and it is still working pretty well although I have had the breaks replaced a few times.
Where is the blower motor resistor located on a lancer?
The blower motor resister is under the passenger side of the dash. It is located in the bottom of the blower housing.
What kind of power steering fluid for 2003 Mitsubishi Lancer?
I have been looking myself and found that the 2003 lancer needs Mitsubishi Diamond ATF SP lll
Where is the transmission dipstick located on a 2002 Mitsubishi lancer?
The Dipstick is located to the left of the battery (if facing car while looking under the hood) It is hidden , but white and has the letters ATF on it.
Where do you put transmission fluid in 2002 lancer manual transmission?
under the car directly in gear box
