You'd have to change the entire gauge cluster. IE the tachometer and speedometer. The light bulb is a white light, and the gauges are colored red so in order to change the color of the gauges youd have to buy a custom made cluster. You'd have to change the entire gauge cluster. IE the tachometer and speedometer. The light bulb is a white light, and the gauges are colored red so in order to change the color of the gauges youd have to buy a custom made cluster.
How do you remove the oil pan off a 2003 rsx type s?
Remove the Subframe. Subframe should be removed but it can be done by lowering Subframe down. I recommend removing the Subframe. Do not pry in oil pan with a screwdriver, get a rubber mallet, it is glued in place.
Will a prelude type sh transmission fit in base prelude car both are h22a?
how to make base prelude h22a engine on type sh 5 speed trans
^^^???
to answer the question. yes a sh transmission with "atts" unit will fit a base prelude (if a h22 motor is used)
is it worth it? absolutely not
Is the 2002 Acura RSX a stick shift or automatic?
The 2002-2004 as well as 2005-2006 Acura rsx base models come in 5spd manual, or automatic. while the Type S models only come in 6spd manual
2006 Acura RSX wants to turn off on stops?
Check your egr system.
It might be your throttle body that not breathing correctly while the car is on.
Take carw of the problem asap before it cost more to fix.
Can you install a cold air intake and a short ram intake in the same car?
no, you only have one intake therefore you can only modify it one way. the short ram intake will most likely be a shorter edition of the cold air intake.
Is the Acura rsx a sports car?
Base coupe is a sports car but its not as fast. The RSX Type-S is a sports car and its way faster than the base coupe.
To disable an rsx ecu immobilizer?
Unless it is an automatic ecu you can buy an immobilizer by pass unit from K-Tuned or Hybrid Racing. Google this ""k-tuned immobilizer bypass" and the little box wires into the engine harness that connects to the ecu and will work fine. I have it on my 98 Civic because I put an RSX-S engine into it.
What makes 03 Acura RSX steering wheel wiggles?
If your saying it shakes when driving it may be your wheel alignment may be off
Where is the oil filter located on a 2003 Acura RSX?
It is located at the back of the motor closer to the passenger side.
What is the curb weight of a Acura rsx?
2002 - 2006 Base RSX curb weight is 2716 lbs.
2002 - 2006 Type-S RSX curb weight is 2775 lbs.
How do you get to the drivers side headlight to change it?
take out the battery first. if you still cant do it, take out the bumper then the headlights and that's only your last resort.
How do you remove the center wheel cap on an rsx?
HAVE YOU EVEN TRIED? JUST REMOVE THE TIRE FROM THE HUB, TAKE A SCREWDRIVER AND PUSH IT OUT. STUPID QUESTION
How do you reset engine light in 2002 rsx?
switch ignition to on and press and hold the odometer reset button until the engine lights goes off.
A 2.0 liter engine means that the total volume of all the cylinders is 2.0 liters, or a different way to put it, a 4 cylinder that is a 2.0 liter has 0.5 liters of volume from when the piston is at the top of the cylinder to when it's at the bottom of the cylinder.
Brake lights on my 2002 Acura RSX dont work. Any body have a solution?
Check the bulbs - they are double filamented with the smaller for the stop lights Check the stop light fuse Check the operation and adjustment of the stoplight switch
Can I install in my Acura RSX?
can i turbo charge my automatic rsx? Is it safe, would the engine be as potent a the type S? If so how much power can i produce" what do i need to be able to drive my car with out worring about my transmission giving away? do i need a high performance transmission. Or can i convert the manual transmission instead? would that be expensive? or just for get about the whole topic of turbo charging my engine?
How do you fix check engine code p0172 on 2004 Acura RSX type s?
I have a 2004 Acura rsx type s check engine light is on has code po172 how do I fix it n what r the possible causes
How can you reset the SRS light to Acura RSX 2002?
Our cars are known to have problems with the SRS lights, well basically all Honda/Acura because the system sometimes "hiccups" and causing codes to trip the SRS light.
DISCLAIMER: Please do this at your own risk, i am not responsible for any damages that you may cause by doing this SRS DIY reset. If you do not trust yourself, please take the car to Acura Dealership and have them reset it for you, Warranty will normally cover for reset at FREE of charge. Try this DIY at your own risk.
Note: If your airbag deployed or seats has been removed or anything that may have triggered the SRS, this DIY will not work for you. All you will get is two flashes or more and the light will remain on.
Tools Material Needed:
- Standard Paperclip (or wire)
- Maybe flash light (night job)
Time:
- 1 to 5 minutes
First make sure your key is out of the ignition.
Step 1:
You can use two options in this step to use to make two contact connect together:
Paper Clip, you can use the paperclip and bend it out to where both ends are next to each other so it can be put in to two pins.[img]http://www.dc5nation.com/DIY/SRSDSC02850.JPG[/img]
- or -
Regular wires, this is actually the best way to use to complete a circuit.
[img]http://www.dc5nation.com/DIY/SRSDSC07465.JPG[/img]
Step 2:
Remove the bottom panel under the dash, two twist clips which can be easily taken off. (turn counter-clockwise)
[img]http://www.dc5nation.com/DIY/SRSDSC02851%20copy.jpg[/img]
Step 3:
After the bottom panel is exposed, locate the fuse box (see drawing for location)
[img]http://www.dc5nation.com/DIY/SRSDSC02852%20copy.jpg[/img]
Step 4:
Locate the SRS plug above the fuses in the fuse box panel, you will see a yellow clip in the middle left side. It is also the ONLY plug that's yellow in the fuse box panel.
[img]http://www.dc5nation.com/DIY/SRSDSC02853%20copy.jpg[/img]
Step 5:
Unplug the clip. You should see two pin holes that you will be completing the circuit with using the paper clip or wires
[img]http://www.dc5nation.com/DIY/SRSDSC02857.JPG[/img]
Step 6:
plug the paperclip in to the 2-pin clip.
[img]http://www.dc5nation.com/DIY/SRSDSC02859.JPG[/img]
After all the Prep Work is done, here comes the steps you need to take to complete actually reset the light. TIMING MUST BE PERFECT, if the light comes back on, remove the key and repeat steps again. Read these steps first before attempting the reset.
Step 7:
With the paperclip or wires in the pins, place the key in and click to the Ingition On position II and leave it alone throughout the whole step.
[img]http://www.dc5nation.com/DIY/SRSDSC02865.JPG[/img]
Step 8:
You should hear beeps for 3 seconds, and when the beep is gone, the SRS should turn OFF.
[img]http://www.dc5nation.com/DIY/SRSDSC02864.JPG[/img]
Step 9:
QUICKLY, Take the paperclip/wires out and the light should come back on.
[img]http://www.dc5nation.com/DIY/SRSDSC02861.JPG[/img]
Step 10:
When the light comes on, QUICKLY plug the paperclip back in to complete the curcuit again, in a second or so, the SRS light should TURN off
Step 11:
At the final step here, you will remove the paperclip/wire and the light will quickly flash twice and turn off. You should wait a second or two to see if the light comes back, if so, YOU WILL NEED TO REPEAT steps 7-11 again. If not, read step 12
Step 12:
At this point, take the key out of the ignition and put the 2-pin clip back in to the proper place (same place where you took it out). Secure the bottom dash back in to place. Test out the SRS again with the Ignition Position II. It should beep then the SRS should turn off.
Quick Read DIY without pictures:
1. connect clip to yellow clip, turn key to position II
2. wait for the light to go off and remove the paper clip/wire.
3. As soon as the light turns back on, quickly connect the circuit again.
4. The light should turn back off. Remove the paperclip/wire again.
5. The light will wait a second or two before it tells you the follow word.
6. Final word is, 2 quick flashes and SRS light turns off completely.
6-A. two quick flashes and the light remains, you may be too slow or you have a short in your SRS somewhere.
7. turn off ignition and put back the clip.
Congratulations, you have successfully reset your SRS light.
Troubleshoot:
Most of the errors can cause by removing items such as steering wheel, seats, seatbelts and airbags. Its very rare for a sensor in the front to go bad but if you have been in to an accident and your airbag didn't deploy but the seatbelt locked, YOU MUST replace the SRS module.
If you have aftermarket steering wheel or seats, there is a resistor that you can purchase from Radio Shack where you stick in between those where the airbag or seats suppose to be and act to complete the circuit.
How do you remove an Acura RSX door panel?
First, there are 3 or 4 screws holding it, as I remember, and all of them located in the traditional locations. 2 of them on the inner door handle, the one U grab on to, and 1 or 2 smaller screws are on the little handle (the locking mechanism). And before removing a door panel, U must remove a little plastic triangle in the top front corner of the whole door. Use a clip removing tool, and carefuly start from the top part of it. When U got all the screws from the door panel, and got the "triangle" off the door, U should take a look at the "door-lock handle" mechanism, whether U can just disconnect the rod and keep it on the door panel, or it has to be removed by sliding it sideways and having it out and then disconnect the metal rod. This is it. Now the door panel is only holding by clips all the way around. Using the clip removing tool (trim tool), and carefully find where exactly is the clip and stick the tool right to it, or as closer to it as possible. The reason is because this clips and a plastic the one is holding that clips in, they are breaking pretty easy. After the panel is free U make sure U got all the plugs disconnected, and there U go, just take it out.
Can you put a Acura RSX type S supercharger on a base rsx?
no is not possible i do not think that an automatic transmission can handle all the added power plus you need to modify the ecu in order for the supercharger to work correctly.
How can I reset the clock on a 2002 Acura RSX?
Are you talking about the clock on the radio? If that is what you are talking about then turn the radio off and you will see that under the FM button it says "clock" hold that button in and use the "4" button for the hour change and the "5" button for the minute change. Hope this helps. and if it is from disconnecting the battery, you will need to put in the securety code, you can find that in the owner manual, and if not, you can call an acura dealer and give them the vin and serial number of the radio and they can get the code to you
How to get my Acura RSX radio code?
I had the same problem when my battery died. I took it to the dealership fearing that it may cost money to find the code in their database. To my surprise, the code for my RSX was stickered to the outside of the glove compartment box. Siiting in the drivers seat, open the glove compartment, and look on the outside of the "inner" compartment. should be a white factory sticker
Where is the trip meter button for Acura RSX?
right under where it shows you the mileage. press it once to see the trip, then hold it in to reset.