answersLogoWhite

0

Buick Regal

This category covers questions about the Buick Regal, a full-sized luxury sedan manufactured by General Motors and sold through its Buick Division in the People's Republic of China. The Buick Century was renamed as the Buick Regal when it was sold in Asia as the Toyota Motor Corporation had already claimed rights to the name "Century."

1,721 Questions

What is an idler pully?

An idler pulley is a pulley that does not drive and is not connected to any device that is driven. It serves to either tension a belt or to route a belt to clear an obstacle.

How can you get your car to start now with the security light not letting you?

Turn key on and leave it on for ten minutes then it will go out and it will start. It thinks it is being stolen. Just did it to mine. Seems to reset the security system.

Can 24 inch rims fit a buick regal?

yes you can here's a website you can visit www.universalcarlifts.com

How do you replace the oil pump located on a 1993 Buick Regal?

That depends on which motor it has. Try this link autozone.com

i would go to my local parts house and buy a service manual for the particular car you have and go exactly by their directions. I would then replace your oil with a good synthetic oil such as AMSOIL 7500 SERIES oil and their special filter. this way you won't have to change oil but every 7500 miles and stop sinking money into do it yourself or walmart deals. Try this great site for more details: http://synthetic-oil-tech.com/1262196 Their oil and supplies are great!

My 1998 buick reagl wont let you take your key uot of the ignition and there is a security light on what do you do?

well i guess im ansewering my own question there is an access just under the ignition on the housing remove the little round cap and insert a small screwdriver and turn the key will come right out as far as the security light i still dont know

What if my low coolant light is on and I don't need coolant in my 2000 buick regal?

Take the coolant level sensor off the radiator & clean it out. The sensor is located passenger side under the radiator cap next to the battery. Best to pull the battery & headlight assembly. Metal retaining clip holds it into the radiator. I just took mine out for the same reason, found alot of "sludge" around the sensor probe. Cleaned it out with some sensor cleaner and soap, reinstalled, refilled the antifreeze and light is out.

What is the EPA city and highway mileage estimate for the 2001 Buick Regal?

The EPA mileage estimate for the 2001 Buick Regal is 17 mpg in the city, 28 mpg on the highway.

How much fuel pressure should your 96 Buick regal with a 3.8 have?

The fuel pressure should be between 40 and 70 psi on a 96 Buick Regal with a 3.8. If the fuel pressure is above 70, then it is to high and should be checked out by a trusted mechanic.

Where is the evaporator case on a 1999 Buick Regal LS?

on the passenger side ITS bolted 2 the firewall - behind the dash board.

Buick regal high beam not working?

Depending on the year, the Regal could have a relay to control the high beams. Check the distribution box under the hood to see if there is a bad headlight relay.

Do performance chips now work?

none i have found and no way on the mileage change

Where is the crankshaft position sensor located on a 92 Buick Regal 3.1 V6?

The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.

How do you replace a crankshaft sensor on a 1991 Buick Century?

Haynes repair manual available from www.amazon.com. Not hard. Locate sensor, unplug electrical connector, use socket of appropriate size, remove.

What is the oil capacity of a 1991 3800 Engine?

4.5 quarts without oil filter change, 4.75 quarts with oil filter change.

The fuel will not reach the engine of an 1985 buick regal what is wrong?

Is there a posibility that air is able to enter the fuel line between the tank and the pump stoping the pump from priming? it doesnt take much.

Code po 401 on 1998 buick regal 3.8 liter?

I had the same thing happen to my car that code means insufficent egr flow. You have to replace the egr valve.

Where is the crank shaft sensor on a 88 buick regal?

If it is the 3800 engine, it is located behind the harmonic balancer on the front of the engine. You may need a special puller to remove the balancer. If it is the 2.8L engine. It is in the engine block between the engine blocks rt bank and the transaxle. It is very hard to remove this sensor. It has a tendancy to crack and break off which will force you to remove the oil pan to remove the broken peices.