0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
How much does it cost to build a Corvette?
Well, I remember hearing a while ago that a C6 corvette cost 20,000 of materials to build, however that is not counting the machinery, the design process, and much others, which cost tens, if not, hundreds of millions of dollars.
Where is the ignition module located 1984 corvette?
The ignition module is located in the distributor under the rotor, it plugs in.
What is the top speed of a Corvette zr1?
The top speed of a Corvette ZR1 WAS 205mph.
On July 27th, 2009, a new top speed test was done, and a new top speed of 210mph was achieved.
The Corvette ZR1 is expected to go faster even than that.
It is electronically limited at 225mph.
Why would brake light fuse keep blowing after stepping on the brakes a few times on a 1991 corvette?
It is possible that one of the bulbs is shorting out. Try replacing the brake light bulbs, if that doesn't work, troubleshoot the brake light switch.
Where is the knock sensor on a 1990 Corvette?
It is on the passenger side of the engine just in front of the starter. It is round and has an electric wire pluged in the end of it. It is screewed into the water jacket in the side of the block.
How do you install a steering wheel on a 95 Corolla?
If the car has an airbag in the steering wheel then take it to a professional mechanic to have it done. If you try to do it yourself then it may come out and cause serious damage. Trust me.
How do you open the hood for a olds cutlass supreme with a hood latch that is stuck?
Find someone with a big strong hand. Pull hood release handle. If this does not open hood about one inch to allow opening it then on the front edge of the hood just left of center line rap hard on hood one time with your hand. This usually will cause the hood to pop up that one inch allowing you to open. If this doesn't work the first time try again. If you hit it too hard the hood may relock and you will have to pull the hood release handle again. Then, after opening the hood it's now time to lubricate the latch hinge and any metal part involved in opening the hood so you won't have this problem for a long while.
Dealer explained release cable can break. Guide tube has to be cut to replace release cable.
How do you replace the fuel pump on a 1978 Chevy Corvette?
1. Disconnect the fuel lines. 2. Remove the bolt on the front right face of the engine block which is opposite (just forward of)the front (forward) fuel pump mounting bolt. 3. Replace this bolt with one that is 2 in. or longer and snug it down. This will hold the fuel pump pushrod in place. 4. Remove the fuel pump mounting bolts and remove the fuel pump. 5. Replace the fuel pump, replace the longer bolt on the front of the block with the original and connect the fuel lines.
What is the proper tire pressure PSI for a 1977 Chevy Corvette?
It should be labeled on the side of the tire in very small print close to the rim. Normally around 32 PSI.
You have a 94 corvette it runs hot you recently saw it reach 231 what needs to been done?
I had the same problem and had the water pump replaced and I still had a 230 temperature. We found that the problem was the radiator was plugged up at the outside bottom with sand and debris. We cleaned that and no more extreme heat. Remember that the analog guage is not all that accurate, always rely on the computer based temperature read out on your electronic cluster..Edward F.
How do you set roller rockers for 1979 350 v8?
solid or hydraulic cam/lifters? If it is hydraulic, and the lifters are pumped up, you need to tighten the rocker nut until it *just* starts to grasp the pushrod (spin the pushrod while tightening the nut to feel it) Now, tighten the nut from the 12 o'clock position to the 4 o'clock position. Do this with each rocker with each cylinder at TDC of the compression stroke. Cams have cross duration, so the cylinder must be TDC on compressions stroke before adjusting the valves of that cylinder.
What are some good replacements for OE run-flat tires?
Well considering you don't have a spare tire, it would seem you need a run-flat. www.tirerack.com might be of help. I put Cooper Zenon tires on mine and carry a 12 volt compressor and cans of fix-o-flat. Car is extremely quiet and tires were under $800. You also can carry a small jack in the middle rear storage compartment
What is the fix for ASR and ABS in Mercedes E420?
It could be your Brake Light Switch. My 2001 E430 wouldn't go into gear from parking and the ABS ASR light was lit. The switch cost about $24.00. It is located behind your brake pedal.
How do you change a 2001 Corvette Thermostat?
Drain the water from your 2001 Chevy Corvette cooling system. Remove the water supply hose from the top of the thermostat housing. Remove the thermostat housing retaining bolts. Remove the old thermostat. Reverse the process to install the new thermostat.
Where is the horn relay located in a 1995 corvette?
The 1995 Chevrolet Corvette on relay switch can be found in the fuse box. The horn relay switch will be in the third column, second from the top.
What year steering columns will fit a 1977 corvette?
A 77 has a 1 year only steering column, it's has the old style dash but the newer style tilt column and it's the only year with a column mounted wiper switch. Withoud modifications only 77 columns fit
Does a 1979 corvette 350 have hydraulic lifters?
YES, Unless someone has installed a solid lift cam sometime are another.
How to set timing in a 1988 Corvette?
Figure out your engine type, then ask how to set timing on a 1988 corvette ***** engine. That should help you a great deal.
Where is the ground on a C5 Corvette?
What are you looking to do? Well there are atleast a dozen good grounds on the C5 let alone any Corvette. CorvetteDon, as he is well known at Smokinvette.com has a animated picture of all the grounds on a C5. Jump over there and hit him up!
