answersLogoWhite

0

Chevy Corvette

Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.

4,587 Questions

Headlights wont go up on 1980 Corvette?

Check your headlight switch, canisters, and vaccum lines. It has to be one of those three things. RJ Sottile www.hobbycarcorvettes.net

What are the disadvantages of run-flat tires?

Shorter Life Span, often as low as 10,000 miles (comaped to around 40,000 for a normal tyre)

Higher repair costs, from $350 to $900 compared to a typical family cars tires which cost $150 to repair on average.

There is a shortage of both replacement tires and trained repair facilities.

On my car, a new set of factory replacements, mounted and balanced w/ disposal fee runs right at $2700.00 and I get about 15-16,000 miles from them before they need replacing. 18 cents per mile, is what is costs to run these tires.

Where is the ECM in a 1982 Corvette?

Behind driver seat in with battery , have to remove battery first to take it out. Check 20 amp fuse next to battery first it is for the ECM (computer).

Where can you find a wiring diagram for a 1991 Corvette?

Try PAINLESSWIRING.COM. They will help you with the wiring if you have any problem.

How do you remove the power antenna on a Hyundai accent 1998?

Answer

1998 MY (model year) Accent vehicle do not have a power antenna. Antenna mast should simply unscrew from mount.

Step 1

Activate the antenna switch to the up position.(turn on radio)

Step 2

Using the wrench or needle-nose pliers, loosen and remove the original retaining nut on the base of the antenna mast.

Step 3

Gain access to the underside of the area where the antenna is located.

Step 4

Remove the bracket or brace that is below the hole and holding the antenna in place.

Step 5

Remove the mast.

Step 6

Find the motor that controls the antenna mast. Generally, power antennas will have a constant 12-volt lead and a ground lead. The ground lead will be grounded to the panel next to the motor.

Step 7

Remove the ground lead from the panel.

Step 8

Pull out the antenna coaxial cable.

Step 9

Unplug the coaxial from the extension coaxial cable.

Step 10

Remove the original antenna coaxial cable. Note the route the cable follows.

Hope it helps

Why would there be no heat in a 1989 Corvette if the blower works and the heater hoses are warm?

Check and make sure your not low on coolant. The last place in your cooling system will be the heater core so if you are low on coolant then you will have no no heat even if your operating temp is normal and everything is operating properly. If you have AC, you will also have a heater control valve that turns off the water flow when the AC is working so it won't have to compete with the heater. These valves use vacuum and if it is corroded inside, it may not open to allow the hot water to enter the heater hence no heat.

Why does the floor board of your 1995 Corvette get soaking wet after a rain when there are no leaks on the window or door gaskets?

== == There are any number of ways you can get water in the car after a rain. You did not say the location of the water. Driver side front, pass. side front, rear cargo area, in the storeage bin area? With out knowing where your water is, it will be impossible to give you a confirmed answer. The water could be running under the top and then coming in under the trim and finally onto the floor. Water could be leaking from around the windshield and hidding in the moulding and kick panels finally on the floor. The rear hatch window has no drain holes and the weather seal is the only thing stopping the water. If the glue has seperated and there is a gap, once again, the water can sneak in under trim and flow down to the floor and storage areas unseen. Take your car to a good body shop and they should be able to find the leak. Be warned, it may be costly.

Where was your 1981 Corvette built?

The 1981 Corvette was built in St. Louis, Missouri, but half way through the model year Chevrolet moved production to Bowling Green, Kentucky.

Where should I consider looking at used corvettes for sale?

Usedcorvettesforsale.com is a very good website for looking up used Corvettes. If you would like to look at Corvettes in person, many Chevy dealers also have used Corvettes for sale.

Where could one buy a 1959 Corvette for a low price?

One may buy a 1959 Corvette for a low price by using the services of sites such as Craigslist, Kijiji and Auto Trader. One may also visit local auctions or online auto auction sites to buy these cars.

What is the newest model of Corvette?

The newest Chevy Corvette (model year 2013) has 8 different models ranging in price from $49,600 to $110,000+. The least expensive is the Coupe and the most expensive is the Stingray.

How do you reset the display on a Renault modus after oil change?

The same lever to the right of the steering wheel that you use to toggle through the on dash journey stats, it has a forward and a back button. When you are on the message that reminds you that you have a service in 'x' miles/kilometers, then just press in and hold one on the buttons on that lever until the display flashes and resets itself.

How do to Jack up a 1998 Corvette?

The owner's manual will show you the points to place the jack. I suggest a floor jack and jack stands if you will be climbing under the car.

What Corvette is the rarest?

The rarest production Corvette ever built was the 1983 L83 coupe. Officially, there is only ONE of these cars in existence, and it resides in the Corvette Museum in Bowling Green, KY. Other production rarities include the legendary RPO ZL1 optioned 427 aluminum big block in 1969, and the RPO NO3 36 gallon fuel tank coupe in 1967. Both of these options were installed on only two production cars in their respective years. For a complete list of years, options, codes, costs, and production numbers, M.F. Dobbins Corvette Black Book is an invaluable source.

How much does a 383 stroker engine have?

How much what? Horsepower, torque, ??? What do you want to know? It all really depends on your setup.