answersLogoWhite

0

📱

Consumer Electronics

Ask questions here about the electronics you use every day: from phones and computers to kitchen appliances and radios.

4,952 Questions

What is coarse mixture?

a coarse mixture is a mixture of substances which when you mix all substaNces you can see the ingredients or substances that are mixed it is not dissolved.. a perfect example of it is a halo-halo a coarse mixture is a mixture of substances which when you mix all substaNces you can see the ingredients or substances that are mixed it is not dissolved.. a perfect example of it is a halo-halo

Who invented a generator?

Mike Farady actually did help invent the first electical generator

How do you rock the baby on imagine babyz?

You have to make sure the that when the balls hit the green area, of one side, Tap the opposite green light. keep doing that until the timer runs out.

What is a resoluition?

There are two main definitions for resolution:

1- a decision to do a certain thing is a resolution; "I made a new years resolution to be a better person"

2- the amount of graphic material/detail that can be shown on a computer screen; "My computer monitor has a resolution of 1280 x 960"

What is the difference between adapter and charger?

An Adapter usually convert AC current into DC current with low output voltage for a device like camera, speaker, tape etc which uses to operate 3, 6, 9, 12 volts or whatever.

but a Charger is used to charging batteries (any type) like laptop, mobile, camcorder batteries etc. It also convert AC current into DC current with low voltage but with high charging power.

What to do when car doesn't stArt?

Well..i saw my dad do this when my uncles car didnt start- you can get someone you know that has a good running car and boost yours with those things with the clipperz at the ends lol...but...yeah- hope you can find out more info about this from what I've said lol.

-Kalin

Is a solar panel dangerous?

Small solar panels up to about 1 square foot are not dangerous but the larger ones tend to operate at dangerous voltages when direct sunlight falls on them.

How do you correct convergence problems on a JVC av48wp30?

I'm in the process of repairing my red convergence failure on my JVC AV48WP30. The red convergence failure shows as a red "sag" or bow in the upper left corner of my screen, but could be blue or green in other parts of your screen depending on which convergence IC malfunctioned.

I'm not an expert, but from what I can tell if you have the sag of any color, one of two convergence IC's failed on the convergence board located in the front right cabinet portion of your TV (don't open the back of the TV).

The failure could have been caused by a faulty resister nearby. Look for smoked or burnt resisters near the 804 or 805 convergence IC's. The IC's themselves might be clearly labeled STK392-110, but you could upgrade to 150's or 180's for better heat tolerance. You may have to replace one or more resistors as well. Unplug the TV, open the front cabinet, desolder the existing IC's and replace. You could just swap IC's, resolder and power the TV on. If you notice a sag of a different color, now you've determined it was definitely a convergence IC failure. The IC's themselves ran me about $15 each from a TV repair shop. Call first to make sure they have them in stock.

Bit depth does not affect file size?

Actually, Bit depth will affect file size. For example:

1-bit=2kb 4-bit=21kb 24-bit=24kb

Why am you losing half the voltage when rectifying secondary side of center-tapped transformer to DC via two 1n4007 diodes?

I think the answer is: if you input voltage to a grounded center-tapped secondary transformer winding, only 1/2 the voltage is applied to each rectifier at a time (sine wave), therefore the rectified voltage measured would be 1/2 that of the total voltage. The peak voltage would be 1.4 x RMS. Hope this helps.