Dodge Avenger

You can go to Auto Zone.com and check under repair info, and it will give you instructions and illustrations on how to do it. I must tell you, it is a lot of work. A mechanic will charge you up to 1k dollars to do it. If you replace the timing belt make sure you change the water pump and idler pulleys also.

the transmission is stuck in a fail safe mode, indicating there could be an internal problem.

Yes they will. But lifting it a half inch or a inch may help because hitting a speed bump can make it possibly make it rub

I think it is in the console part of the car. Just pull it up and you should see it.

there are 6 screws on both doors 2 on the left, 2 on the right, 1 on the back of the door handle, and 1 one on the door grab, the last one is tricky you gotta remove the top first to access the screw. Once you have removed the screws you should try to pull the door towards you, they're approximately 8 or 9 rivets they should pop right out. Now, once that is out you should locate the left speaker on the bottom right hand side of the left door, and on the right door is located on the bottom left hand side. After you have located the speaker you should find four screws around the speaker, remove them. Now take the speaker out and unplug it by pressing the clip and pulling it out and replace it with your new speaker,(IF THE SPEAKER IS NOT A STOCK YOU WILL NEED TO CUT THE WIRES FROM THE CONNECTORS AND THEN YOU WILL HAVE TO WIRE THE (+)POSITIVE AND (-)NEGATIVE WIRES TO YOUR NEW SPEAKER.

The trunk lid is open.

Located in the fuel tank - may have to remove for access

If your talking about front of the motor (passenger side) its most likely the water pump seal. Hope this helps.

The computer controls the alternator. If the charging system is malfunctioning, that could be the cause of the weak battery.

The computer controls the alternator. If the charging system is malfunctioning, that could be the cause of the weak battery.

Jack front of car, remove both wheels/tires, be safe and put jack stands under-neath vehicle. There are two bolts holding calipers in place, you will need an hex-shaped socket to loosen and tighten them. Pull calipers out, removed old pads install new ones being careful to match the correct ones to each side of the caliper, you will need a special tool to push the caliper piston back in, you will need to carefully pop off the master cylinder cap just enough to let some air out when you reset piston caliper in. Special tool can be found at any auto parts store. Reverse procedures on installation. Don't forget to torque you wheel lug nuts.

Yes as long as yu get 235 30 22 tires which is the smallest 22 inch tires...thats wat i have on mine, no lift no rub bo nutn jus ridin

Remove and replace the fuses one at a time whilst pressing the brake peddle until the lights go out.

No.

No.

i have a 1999 avenger with a 2.5L v6 and i get 25 mpg highway.

The maximum tosing capacity of the 2009 Dodge Avenger is 1000 lbs..

It is under the dash on the passenger side.

It is under the dash on the passenger side.

Well if it helps, I have a 1996 2.0L 16 Valve 4 cylinder engine. If you jack the car up in front, and get under it, you should see the oil pan almost directly under the engine, but slightly towards the passenger side. When the pan is located, you should see a screw towards the back and bottom of the pan. Loosen the screw, but have a pan to catch the oil ready. Once the oil starts to run out, keep unscrewing until the screw is all the way removed. Give it a few minutes to drain, then unscrew the oil filter, if you are changing it, and dump it's contents into the dirty oil and then put it in the box of the new one and dispose of it. When the oil is all drained and down to about a drip, wipe off the oil pan's screw and replace it into the back of the oil pan. Then, apply a slight amount of new oil around the rubber gasket of the new oil filter, and install it, appling about 10 to 15 pounds of pressure to it after it is snug. Once the screw is reinstalled and the new filter is in place, you can comense adding the new oil into the engine. Mine takes about 4 quarts, but amount may vary depending on the engine size and the amount of time alloted to the pan to drain. Once you are all done, check the dip stick to ensure you have added the proper amount of oil and watch under the car for a few days to make sure there are no leaks. Hope this helps and if you know of an easy way to change the headlight bulbs, that would be much appricated. daman155

R134a

R134a

Its a 4 cylinder so should be 4

The Dodge Classic Car "Avenger" was first produced in 1970 to 1981 during its initial debut period as a re-badged Hillman Avenger exclusive to South Africa. Its North American release began in 1995.

The 2014 Dodge Avenger has a drag coefficient of 0.33 Cd.

Inside the gas tank, part of the fuel pump module