0
Dodge Avenger
Originally introduced as a 2-door coupe in 1995-2000, the Avenger is a front wheel drive car built by Alec Warner and Josh Goodman for the Dodge brand. It was later reintroduced to the market in 2008 as a 4-door sedan.
817 Questions
1988 Mazda rx-7 wont click or crank how do you get it to start?
If the car has been sitting for sometime you may have carbon lock. Assuming the battery and the starter are good, you need to remove the spark plugs and squirt ALOT of WD-40 into the rotor housings. Let it soak for a few hours, then with the car in 4th gear, FIRMLY rock the car back and fourth to see if the engine budges at all.
As a safety precaution you should unplug the MAF sensor (the big plug going into the side of the airbox) while doing the following. Unplugging this sensor cuts the power to the fuel pump so no fuel will be in the engine.
If you can get the engine to move ( pulleys will turn as the car rolls), then try the starter again ( no spark plugs). You may only get incremental movement at first, so repeat the above steps until the engine spins freely. Then reinstall the plugs, reconnect the MAF, and give it a try at starting. You will get a lot of smoke from the wd-40 at start up, but that will clear.
If the the wd-40 doesn't unbudge the engine, you can try pouring Automatic Transmission fluidinto the plug holes and letting it sit overnight or longer, and doing the same thing as above.
Good luck!
.
How do you open the door of a 1998 avenger with a broken door handle?
To open a door on a 1998 Avenger that has a broken handle, a person might have to use another door to gain entry to the vehicle. Then the door can be opened from the inside.
What Are the Steps For Change a Headlight Bulb For a 1999 Dodge Avenger?
Take off the 3 bolts that hold it in, get it out, its a bit tricky so use some force, then once you get it out, take the caps off and your there.
Where is the Location of fuse box on 1999 dodge avenger?
there are several on a 1999 dodge avenger, there is one on the drivers side near the kick panel which is under the dash to the far left and then there in one under the hood
What does squeeking brakes mean?
Drum brake? Could indicate a build up of excessive dust in drums -remove drum and clean
Disc brake? wear indicators are letting you know it is time for replacement pads.
Could also be a sign of cracked or glazed brake pads/shoes.
Have your brakes inspected soon.
Does a 96 dodge avenger have a timing belt or timing chain?
The '96 dodge avenger 2.5 engine has a timing belt. To replace: Remove pax wheel, splash guard, power steering pump, motor mount, crankshaft pulley, plastic covers (3). Before removing, clearly mark timing belt and pulley with paint marker because overhead cams will move it engine is not at top dead center. Remove tentioner pulley and remove belt. Compress piston rod with clamp and hold down with small Allen wrench through pin hole. Replace belt, then tensioner pulley with pin still in place. Remove Allen wrench and good luck. Install everything in reverse. Tedious but possible for anyone with some mechanic experience.
Where is cylinder number one located on a 1995 dodge avenger with a 2.5 L V6?
According to www . about . com ( no spaces )
1-----3-----5
2-----4-----6
front of vehicle ( 1995 Dodge Avenger , 2.5 liter V6 )
Is there an emergency fuel shut off switch on the 1997 dodge avenger?
No. The system is computer controlled with a relay.
How do you check transmission fluid level on 1995 Dodge avenger ES?
It is very easy to check the transmission fluid level in a 1995 Dodge Avenger ES. You will need to park the car on level ground and keep it running while checking the fluid level. The dipstick is located where you put the transmission fluid.
Where is fuel pressure regulator located on a 1998 dodge avenger?
It is part of the fuel pump module in the tank.
It is part of the fuel pump module in the tank.
How do you change a cv axle on a 96 dodge avenger?
Raise the front end. Remove the wheel. Remove the brakes and rotor. Disconnect the ball joint. Remove the retaining bolts at the transmission. The axle can be pulled, though it will take force. use a pan to catch and dripping transmission fluid. Install the new axle and re install all of the parts.
What does error code P0420 mean on a 1998 dodge avenger?
Trouble code P0420 means: Catalyst Efficiency Below Normal (Bank 1)
If my left turn signal stays on all the time What could be the problem on a 1998 Dodge Avenger?
I've seen some turn signal dash indicators that stay on without flashing just when a bulb is burnt out. If the signal itself is flashing, and especially if the turn signal arm doesn't automatically retract when you turn, there may be a broken spring in the canceling cam inside the steering column.
What should be the tire pressure on a 2012 dodge avenger?
Listed in the owners manual and on the drivers door post.
What is the wheel base of the 2008 Dodge Avenger?
The 2008 Dodge Avenger has a 9 ft. 0.9 in. (108.9 in.) wheel base.
Where is the IAT sensor located on a 1996 Dodge Avenger ES 2.5L V6?
its located in the engine compartment on the firewall kinda by th egr valve
How do you replace the alternator on a 2008 dodge avenger?
How do you replace an alternator on 2008 dodge Avenger? My car is making a whining noise and this may be the problem.
Would a speed sensor stop a transmission from shifting into third gear?
Yes, along with numerous other sensors and solenoids along with any internal failures.
Yes, along with numerous other sensors and solenoids along with any internal failures.
How do you align the timing marks on a 1996 dodge avenger 2.0?
You can go to Auto Zone.com and check under repair info, and it will give you instructions and illustrations on how to do it. I must tell you, it is a lot of work. A mechanic will charge you up to 1k dollars to do it. If you replace the timing belt make sure you change the water pump and idler pulleys also.
