Dodge Avenger

Red, 5 year, HOAT type.

I believe if you remove the battery, you'll have better access to the fluid bottle. Probably just reach down, pull the old hose off, press a new hose on. If removing the battery doesn't give you access, perhaps coming up from underneath the car.

The red brake light on the dash means that the brake fluid is low or the parking brake is on.

Will 22's fit on my dodge avenger with no lift kit?

The gas tank on the 2013 Dodge Avenger holds 16.9 gal..

The ground clearance of the 2013 Dodge Avenger is 0 ft. 6 in. (6 in.).

Charge it, replace it,test the alternator,

Charge it, replace it,test the alternator,

worn out tierods

It is located all the way to the left side of the car just behind the headlight.

i had the same problem and it turned out to be a valve body in the transmission that was sticking. what ever that means idk to much about cars but i put some transmission cleaner in it and it hasn't giving me a problem for a little but now.

The 2008 Dodge Avenger runs on regular unleaded.

if the door is not popping open when you pull the release inside the car then there are two possible reasons... the first to check is the cable. to do this have one person pull the release while another checks at the fuel door to see if the stopper goes in when the release lever is pulled. if it doesnt then you know the problem is the cable. first check the connections at both the release lever and the door stopper. to access the stopper you must remove the interior panel from that side of the trunk. if both connections are in tact and the stopper isn't moving then the cable itself if broken and should be replaced. the other reason it may not be popping open is the spring located in the hing. without this spring the door latch will release but the door wont pop open because there is no spring to put pressure on the stopper. if this is the case then you need a new spring.

Find a Star Tip Bit screwdriver and remove the 6 screws from under the sunroof, carefully removing the glass.

Then just replace the tracks back to it's place. Finally, carefully replace the glass and screws.

i can get about 6 seconds with my 4 cylinder

The 2012 Dodge Avenger has a 2.4 L base engine size.

without looking at vehicle, control module may be a good place to start checking. honestly though, you need a engine diagnostic specialist to examine your problem.

The EPA mileage estimate for the 2008 Dodge Avenger is 21 mpg in the city, 30 mpg on the highway.

Mask of the Avenger was created on 1951-06-27.

The 2013 Dodge Avenger has 42.4 in. of front leg room.

The 2008 Dodge Avenger includes 3 yr./ 36000 mi. of roadside assistance.

In the fuel tank. There should be an access panel in the rear seat, you should remove the bottom rear seat and you should see a round panel with about 4 screws holding it in place.

sounds to me as if you have a connection prob with ur batt cables or sum connection problem mabye with a ground?? so replace ur cables first then let me know thanks If all the electric power in the system is gone, including that in the battery, then the battery is discharged. If the battery is new, having had a full charge when installed, then either the alternator is bad, or something is draining the battery other than the alternator. If the alternator is not charging the battery, then the running of the engine is drawing power from the battery. If the battery is found to be discharged after the vehicle has been sitting without having been run, then something in the electrical system which is wired independent of the ignition is either being left 'on', or a short-circuit exists in the electrical system somewhere. Many times, a misadjusted brake light switch will cause this and go unnoticed; after all: The brake lights are on the REAR of the vehicle; and, most people get out of the car and walk away from it toward the FRONT--- never seeing the rear. Other culprits are often found to be add-on components which are wired directly AROUND the key, such as stereo amplifiers. When the key is turned off, these are still 'ON'; and, since the receiver itself quits producing music once the key is turned off, these aren't given a second thought. Other possible causes are misadjusted trunk lights and lights in the glove box. The possibility also exists that the battery is only PERCEIVED to be discharged due to bad connections at the battery terminals, engine ground, oe starter post; or corrosion exists in the main cables to the battery. Usually, when a sizable drain upon the battery exists, a spark is noticed when the cables are hooked up to it as it is installed. If this is the case, leaving the battery hooked up will drain it. If such a condition exists, the problem with the system can be isolated with a test light and a charged battery as follows: Install the charged battery, and only hook up the system positive cable to it. Between the negative terminal of the battery and the system ground cable clamp hook up a test light. If an abnormal drain exists in the system, the test light will be on. At the fuse panel, pull and reinstall each fuse individually one-by-one until the light goes out. If the drain exists on one of these fused circuits, the light will go out once its fuse is pulled. Then, whatever is hooked into that circuit needs to be looked at as a possible culprit. If no pulled fuses are found to extinguish the test light, then a system short-circuit is indicated; and, one of the primary candidates is the alternator. If disconnecting this puts the light out, you've got the answer. Once the problem has been found, the light will go out; and, once the offender is replaced, the light should not light up when things are re-tested. Then, a good, charged battery should hold a charge normally. It is, therefore, always a good idea to have the electrical system checked whenever a new battery is installed.

The 2008 Dodge Avenger has a 2.4 L base engine size.

The 2014 Dodge Avenger is a gas-powered vehicle.

push the plastic clips, disconnect the hoses then pull out the filter. you don't need to top the new filter with diesel, just turn on the ignition until you hear a click then it is ready to go.