How do you line up the timing mark on 1973 dodge dart 318?
crankshaft gear mark is set at 12:00 and the gear mark on the camshaft is set at 6:00. Correct, and what confused me and many people is that the #1 cylinder is not at TDC there. #6 should be at TDC on the compression stroke as I recall.
Are the doors and front fenders the same for a 1970 dart and demon?
The Demon wasn't actually made until 1971, but theoretically, yes, they would be interchangeable.
Installation 1972 dodge dart speedometer cable?
hook it to the speedometer behind the dash and route it through the firewall down to the transmission and hook it up to the tranny.
How do hook a timing light to a 1970 slant six dodge?
hot wire on the timing light goes to pos. side of the battery and the neg. side of timing light goes to ground on the engine someplace and then the plug clip goes on the #1 spark plug wire.
1969 dart front end alinement specs?
you will have to get a chiltons manual for 69 dodges from the library and look it up to find out the answer to your question.
Where do you place a jack to jack up the back end of a 1972 Dodge Dart Swinger special?
the bumper jack goes under the back bumper, there might be slots on each side of the rear bumper to put the jack into.
A few extra bells and whistles with the interior, hubcaps, & body trim , but no performace parts
Production total of 68 dodge darts gts?
8,745 Dodge Dart GTS 340 / 383 engine
Darts with 440 engine 68
Darts with Hemi 80
We have a 1968 Dodge Dart GTS 340 with 6 pack. My husband has had it since high school. It is still all original. It's triple black with white bumble bee stripe.
Here's a good site with the numbers.
http://www.musclecarclub.com/musclecars/dodge-dart/dodge-dart-history-2.shtml
How do you remove a front bench seat from a 1972 2 door Dodge Dart Swinger?
Just unbolt the seat from the floor and pull it out.
What is the gap points dwell and spark plug gap of a 1966 dodge dart 6-cylinder?
The gap is .017" to .023"
Dwell angle is 41° to 46°
Spark plug gap is .035"
You pulled a 225 dodge 6-cylinder out will a 318 bolt in without modifing the motor mounts?
No. But there are companies that make adapter mounts which will allow it to bolt-in without modifications. (Not cheap.)
Is type F automatic transmission fluid the correct fluid to use in a 1973 Dodge Dart 318?
You can use type F. I have seen that in writing several authoritative places (check www.allpar.com). I use it in my '65 Newport, which is the same transmission design as yours. Some people think "F" stands for "Ford", but I understand it means "Friction". It should give firmer shifts and less clutch wear. I don't notice a difference from Dexron III, but I also installed a shift kit for firmer shifts. ATF+4 should also work since recommended for my '96 Voyager 3-spd which is the same basic Torqueflite design.
Will a 1967-69 dart fender fit a 1968 valiant?
With different fender contours it would not be an exact fit