Dodge

The 2003 Dodge Dakota offered several axle gear ratios depending on the engine and drivetrain configuration. Common ratios included 3.55, 3.92, and 4.10. The specific ratio would vary based on whether the truck had a V6 or V8 engine and whether it was equipped with a 4x2 or 4x4 drivetrain. For precise information, it's best to consult the vehicle's specifications or the owner's manual.

For a 2017 Dodge Journey with a 3.6L engine, it's recommended to use synthetic oil with a viscosity of 5W-20. This type of oil helps ensure optimal performance, fuel efficiency, and engine protection. Always check the owner’s manual for any specific requirements or recommendations.

The 2002 Dodge Cummins diesel engine, specifically the 5.9L inline-six turbocharged version, produces around 305 horsepower. However, the torque is a standout feature, generating approximately 555 lb-ft. This combination of power and torque makes it well-suited for heavy-duty towing and hauling tasks.

The 2015 Dodge EcoDiesel is designed to run on ultra-low sulfur diesel (ULSD) fuel, which contains a maximum of 15 parts per million (ppm) of sulfur. Using this type of diesel fuel helps ensure optimal engine performance and compliance with emissions standards. It's also advisable to avoid biodiesel blends exceeding 20% (B20) to maintain engine integrity and warranty compliance. Always refer to the owner's manual for specific fuel recommendations.

Yes, you can get replacement keys for a 1997 Dodge 1500 using the Vehicle Identification Number (VIN). Many locksmiths and dealerships can use the VIN to determine the correct key cuts and programming required. However, if the key has a transponder chip, additional programming may be necessary, which typically requires specialized equipment. Always check with a certified locksmith or dealership for the best options.

To replace the fuel sending unit on a 1988 Dodge Raider, first, disconnect the battery and relieve fuel system pressure by removing the fuel cap and the fuel pump relay. Then, lift the vehicle and remove the fuel tank by disconnecting the fuel lines and support straps. Once the tank is down, access the fuel sending unit by removing the retaining ring and lifting it out of the tank. Install the new sending unit by reversing these steps, ensuring all connections are secure before reassembling everything.

To remove the front half shafts on a 1997 Dodge FWD, first, ensure the vehicle is safely lifted and supported. Begin by removing the wheel and tire, then detach the brake caliper and rotor for better access. Next, remove the axle nut and any mounting bolts securing the half shaft to the transmission and wheel hub. Finally, carefully pull out the half shaft from the hub and transmission, allowing for the replacement of the small U-joints.

The length of a Dodge Caravan varies slightly by model year, but it typically measures around 202 inches (approximately 17 feet). This dimension may differ based on specific configurations and trim levels. Always check the specifications for the exact model year you're interested in for precise measurements.

The lug pattern for a 2006 Dodge Caravan SE is 5 bolts with a spacing of 114.3 mm (4.5 inches) in diameter. The lug nut size is typically M12x1.5. This configuration is common among many Chrysler and Dodge vehicles, making it easier to find compatible wheels. Always verify with your vehicle’s manual or a professional before making any changes to your wheels.

The Dodge 727 transmission first featured an overdrive option in 1978. This was part of a shift towards improving fuel efficiency and performance in vehicles. The overdrive gear allowed for lower engine RPMs at highway speeds, contributing to better fuel economy.

The rear differential of a 2007 Dodge 2500 4x4 typically holds about 10 to 11 pints of gear oil, which is approximately 5 to 6 quarts. However, the exact capacity can vary depending on the specific axle type and configuration, so it's always best to consult the owner's manual or a service manual for precise information. Ensure you use the correct type of gear oil, usually an SAE 75W-85 or 75W-90, as recommended by the manufacturer.

In Dodge City, entertainment in the late 19th century primarily revolved around saloons, dance halls, and theaters. The town was famous for its lively nightlife, featuring live music, gambling, and performances by traveling shows and vaudevillians. Additionally, rodeos and cattle drives attracted spectators, while the wild-west atmosphere offered a unique blend of excitement and adventure for visitors and residents alike.

Dodge vehicles are primarily manufactured in the United States, with key production facilities located in states like Michigan and Ohio. However, some components and models may be sourced from international locations. Overall, the brand emphasizes its American roots, with a significant portion of its assembly and production occurring domestically.

The Dodge 6.4L HEMI engine has a displacement of approximately 392 cubic inches. This is calculated by converting liters to cubic inches, where 1 liter is equivalent to about 61.024 cubic inches. Therefore, 6.4 liters multiplied by 61.024 gives you roughly 390.6 cubic inches, which is commonly rounded to 392 cubic inches.

The Bicentennial Spirit of '76 dart sports were produced in a limited edition, with only 5,000 sets made. This special edition was created to commemorate the 200th anniversary of the United States. Each set features unique designs and was highly sought after by collectors.

On the 2010 Dodge Avenger R/T with a 2.4L engine, the fuel filter is integrated into the fuel pump assembly, which is located inside the fuel tank. To access the fuel filter, you typically need to remove the fuel tank, as it is not a standalone component. It's advisable to consult a repair manual or a professional mechanic for detailed instructions on replacing it.

To replace the original ignition system in a 1984 Dodge D-100 with a 3.7L Slant Six engine, you will need a few key components: an electronic ignition conversion kit (which typically includes an ignition module, pickup coil, and necessary wiring), a compatible distributor, and possibly a new ignition coil. Additionally, ensure you have the appropriate tools for installation, such as wrenches and screwdrivers, along with a multimeter for testing connections. It's also advisable to refer to the vehicle's service manual for specific instructions and wiring diagrams.

To bleed the brakes on a Dodge Caliber, start by ensuring the vehicle is on a level surface and secure it with wheel chocks. Begin at the brake farthest from the master cylinder, usually the right rear, and have an assistant pump the brake pedal several times before holding it down. Open the bleeder valve on the brake caliper to release air and fluid, then close it before your assistant releases the pedal. Repeat this process for the left rear, right front, and finally the left front brakes, checking the brake fluid level in the master cylinder throughout.

On a 1978 Dodge 440, the oil dipstick is typically located on the driver's side of the engine, near the front. It is usually a long, thin tube with a handle on the top, making it easy to pull out for checking oil levels. Be sure to check the owner's manual for specific details related to your vehicle, as variations may exist.

In Dodge County, Minnesota, there is no specific legal age at which children can be left home alone. However, the Minnesota Department of Human Services suggests that children under the age of 12 should not be left home alone for extended periods. Parents are encouraged to use their judgment based on the child's maturity and ability to handle emergencies. Ultimately, the responsibility lies with the parents to ensure their child's safety and well-being.

The gross vehicle weight rating (GVWR) of a 2008 Dodge Caravan typically ranges from approximately 5,600 to 6,000 pounds, depending on the specific model and options. This rating includes the vehicle's weight along with the maximum allowable weight of passengers and cargo. Always refer to the vehicle's owner manual or the manufacturer's specifications for the exact GVWR.

The Gross Vehicle Weight (GVW) of a 1-ton Dodge dually truck typically ranges from about 10,000 to 14,000 pounds, depending on the specific model and configuration. Dually trucks have dual rear wheels, which can support a higher weight capacity compared to single-rear-wheel trucks. Always check the specific manufacturer's specifications for the exact GVW of the model in question.

A Dodge Caravan transmission typically weighs between 120 to 150 pounds (54 to 68 kg), depending on the specific model year and type of transmission. Variations in weight can occur based on features and design changes over different generations. If you need precise weight for a specific model, it's best to consult the manufacturer's specifications or a repair manual.

The main difference between a DODGE W-100 and a W-150 lies in their payload capacities. The W-100 typically has a lower payload capacity compared to the W-150 due to differences in suspension and axle configurations. Additionally, the W-150 may have a more robust drivetrain and braking system to accommodate heavier loads. Overall, the W-150 is designed to handle heavier payloads and may have more towing capacity compared to the W-100.

.035