Electronics Engineering

It depends on the value of the three resistors. If they are equal, then each resistor has 5 volts across it.

It depends on what vehicle it was orriginally installed into, And the intake, Carb, Heads, The factory had a couple of different power ratings for the motors. Most likely around 200 hP.

There is really no amplifier on the market which has an output impedance of 4 ohms or 8 ohms. The impedance of an amplifier is always less than 0.5 ohms. We do not use matching, we use bridging when we connect the amplifier to the loudspeaker. Scroll down to related links and look at "Interconnection of two audio units".

I have do admit that I don't know.

The diffusion current in a metal-semiconductor diode is derived based on the assumption that the depletion layer is large compared to the mean free path, so that the concepts of drift and diffusion are valid.

[object Object]

RF = Radio Frequency

Vp=2

Vdc=50

r=Vrms/Vdc

Vrms=Vp/1.121

so r=0.028

It is not 330 ohms it is a value that must be installed in series to insure a 20ma or so of current limiting. This value of 330 ohms can change greatly if the source voltage changes greatly. It also has to be noted that the LEDS are not created equally So each LED voltage drop can be added to the equation.

will this cause your pick up not to run

A flow of 7400 coulombs in 85 seconds represents a current of 87 amperes.

One ampere is one coulomb per second, so divide 7400 by 85.

To measure the value of a resistor, apply a voltage and measure the voltage across the resistor and the current through the resistor. Use Ohm's law: Resistance equals Voltage divided by Current. Start with a small voltage and increase gradually until a reading is obtained, but be careful that the power dissipation (watts = volts times amperes) of the resistor is not exceeded.

Simpler solution: Use an ohmeter.

ung pinakafefeng bagay sabi ng teacher nmin

by proper placement of the Antenna and also by maintaining the proper configuration

flip flop

because they have more harmonics

Saturation can mean that something is something is soaked thoroughly with a liquid such as water.

In scientific use, saturation is the amount of solute in a solution as a percentage of the maximum at that temperature and pressure. "Supersaturation" refers to situations where the solution is more concentrated than the normal maximum, due to temperature or pressure changes.

alternating current (AC)

Transforming analog signals to digital is known simply as analog to digital conversion, sometimes shortened to A-D conversion.

To find the voltage across a resistor, you can use Ohm's Law, which states that ( V = I \times R ). Here, ( I = 10 , \text{mA} = 0.010 , \text{A} ) and ( R = 1.0 , \text{k}\Omega = 1000 , \Omega ). Thus, the voltage is ( V = 0.010 , \text{A} \times 1000 , \Omega = 10 , \text{V} ). Therefore, the voltage across the resistor is 10 volts.

There are two types of AM transmitters, High-level and low-level. Low-level transmitters don't have to go through quite as many amplifiers as high-level AM transmitters, as well as consuming less power than the high-level counterparts, but aren't as efficient.

what is the number of turns in the primary and secondary coil for 12 volt battery charger with 220 volt power supply> what is the number of turns in the primary and secondary coil for 12 volt battery charger with 220 volt power supply>

A monolithic metal is a single metal mass of any shape or form. It is not comprised of multiple metal types, or even multiple spatially distinct quantities of the same metal. An example would be a single cube of iron, or a sheet of aluminum. That is the basic premise.