0
Geo Metro
The Geo Metro was a small economy car produced between 1989 and 2001. The first generation model was available as 3-door and 5-door hatchback, as well as 4-door notchback sedan. It came in three trim levels: XFi, Base and LSi.
1,033 Questions
Geo Metro crank sensor location?
LOL, some dont have crank sensors my friend! if you dont have a crank sensor by your oil pan then you have a bad distributor sensor!
I have same problem. I put new blower and new resister, but did not solve the problem. The only part left to replace is the Fun control switch located on the dash. The blower resistor is locates on the blower case under the glove box. good luck.
How do you tighten the tensioner pulley on 96 Geo Metro?
the only belt with a tensioner is the timing belt, to tighten the alt belt loosen the adjustment bolt then tap the alt back then retighten the bolt
Why is my Geo Metro is stuck in park and how do you fix it?
put your foot on the brake.... if that doesn't work you have to fix the wiring for the brake/transmission interlock
How do you remove a drive axle on a 1992 Geo Metro?
Pull off the wheel, pop the lower balljoint and pull the axel nut off and push the axel out of the hub assembly so its free and laying stick a pry bar between the axel and the transmission and it should pop right out.
i came across the answer for this problem, unfortunetly, by trying to remove my Delco radio from my own '95 Geo Metro LSi hatchback (another problem...ugh); the fuse type is correct, the little brown plastic covered one that's 70A located in the fuse box 2nd awat from the battery, but i haven't been able to find one that will fit properly like the factory fuse did. i haven't tried going to the Chevorlet dealership yet in my search, so you may have luck there in finding a replacement (i hope i will!)
Where are the fuel filters for a 97 Geo Metro?
On a 96 it is just in front of the drivers rear tire, in front of the gas tank along the side of the unibody frame
What would cause a 1991 Geo Metro to have no power when the battery and connections are good?
check to see if you have a wire, smaller gage from positive terminal, some have a separate hot wire to the acc. key, mine corroded lossing connection and some have fusable links in them.
How do you remove the crank shaft pulley on 1996 Geo metro 1.3l?
How do I remove a pully from the drive shaft. The snap ring that holds pully on has been taken off.Itried a gear puller but it bends the pully.
He likes Sonia better than Prez, he finds Prez more like
a friend instead of a girlfriend.
Which fuse is for the tail lights in a 1993 Geo Metro?
First you need to locate the fuse box. Many are under the dash near or to the left of the steering wheel. Some are under the hood in the engine compartment. The fuse box cover will often show the size (AMPS) of fuse in each slot as well as what it operates. If you have further questions about the fuses, check the owners manual which should define it in more detail.
How much can you get if you scrap your Geo Metro?
the weight of the vehicle times the amount of scrap metal per 100 lbs
Lack of power can be caused by many problems. If the motor is revving up but it won't shift, it may be the transmission. If it won't rev, it may be the convertor. It may also be a plugged fuel filter, air filter, bad plugs or wires or even a bad injector. Check the filters and maybe a tune up before going further. Also check all the fuses.
On almost all Geos its one of 2 reasons. #1 the aluminum block cracked and the car now overheats and cannot be driven very far #2 the u joints and rocker panels on Geos become very rusty over time and eventually rust through and fall out, making the geo un-driveable. My old Geos engine block gave out.
Where are the engine drain plugs on duramax diesel 6.6L?
The drain plug for the engine oil on a duramax should be on the back of the oil pan at the very bottom.
How many valves does a 95 geo prizm lsi 1.8 have?
Give your VIN to the dealership and they will tell you. Have a nice day.
When do you change the timing belt on a 2000 Chevy Metro LSi with 6500 miles?
The recommended service is to inspect it at 60,000 miles, replace it at 100,000 miles. Considering that you drive very little, I would recommend you just replace it at 60,000 miles. The belt will be very old at that time and age is a factor. Disregard this if you mis-spoke on the mileage and meant 65,000 miles, which I suspect is the case. In that case use the recommended service interval.
General Motors A Geo Metro is a Cheverolet
geo and Chevy metro are both made by suzuki in Canada
Will a 1992 geo metro 1.0 fit into a 1994 geo metro 1.0?
Yes it will. from 1989 - 1995 all geo metros (as well as Suzuki Swift) had the same engines. As long as they both have the same type of transmission and the same size (1.0) it will fit. Hope this helps.
Where is the crank sensor on a 1993 Chevrolet Geo Metro?
on your oil pan, close to the crankshaft pully. mine had one bolt (1996) Dont worry, no oil will come out. These ussually get dirty and not work well. I would suggest removing and cleaning up and make sure the magnet is clean, and reinstall before buying a new one.
sorry but this is wrong you do not have a crank positioning sensor on a 93 geo metro and if they do i have not found one on mine yet 96 was the first year for them to put a crank sensor on the oil pan
What are the symptoms of a bent valve?
A popping sound (when running if it will run), backfiring, and low compression on one cylinder when testing with a compression guage.
