0
Jeep Grand Cherokee
The Jeep Grand Cherokee is a mid-size SUV produced by Chrysler from 1992 to the present. For the 2011 model year, it is available in five trim levels: Laredo, Laredo X, Limited, Overland and Overland Summit.
2,519 Questions
Does an 1987 Ford Ranger 4x4 have fuses for the 4x4 just stopped working and can't find out why?
Make sure the hubs are locked in, if they are manual hubs, be sure they are fully locked, if your transfer case is electronic I would check the fuse for it. Make sure you are getting power through the wires at the transfer case.
How do you replace the top brake light for a 2004 Jeep Grand Cherokee?
Rear: Brake, Back-up, Tail, Turn signal (3 bulbs, all # 3157)
To access the rear bulbs, open the liftgate and remove the two Phillips head screws from the side of the housing as shown in the center photo above. Slowly and firmly rotate the assembly away from the vehicle until it disengages from the ball pin socket that secures it in back.
Each of the three light sockets, all containing the same exact bulb type, can be removed by turning them counter-clockwise 1/4 turn.
Taillight harness connector
To remove the taillight harness, slide the red lock tab up and pull connector off.
That sounds a lot more like the maf sensor, if disconnected or failing it will allow a start, but once no air input is detected it will shut down the fuel.
There's only two things it could be--assuming the fuse is good (you checked this before you dropped the fuel tank to change the fuel pump), there's something wrong on the main relay board. Pull it (not sure where it is because I'm not a Jeep guy, but it's usually very close to the fusebox), resolder all the connections and reinstall it. These relays get very hot on all cars, and the solder connections fail. Resoldering usually fixes it. easier than that .... is your security system enabled... what I mean is .. when you try to start it are you getting a flashing security light on the dash, if it is, cycle your keyless entry and try again, part of the security system is to cut the power to the fuel pump.
Can you drive your 1996 Jeep Grand Cherokee Limited with Quadratrac without the front driveshaft?
Yes
AnswerYou can for a little while but it is not good for the t-case. I did it with mine and it when i'd step on the gas i could feel that it wasnt putting all of the power to the rear wheels but kept trying to spin the front but with no driveshaft it didnt do anything. This will wear out the clutches and stuff on the inside. I also talked to a Jeep mechanic who said its no good. Its probably similar to how you can't tow a quadratrac jeep with a car dolly. It has to be towed with all the tires on the ground or off the ground otherwise it wears out the t-case. I just installed a new t-case to get the 2-wheel drive and can definitely tell the difference between the quadratrac with no front driveshaft and real 2-wheel drive.What type of oil is needed for a Jeep Grand Cherokee?
4.0L uses 10w30 6 quarts
4.7L uses 5w30 6 quarts
5.7L uses 5w20 7 quarts
6.1L uses 5w40 full synthetic 7 quarts
Try autozone.com they have a online service manual for many popular vehicals it helped me to find all the faseners to remove the plastic bumper cover on my 1979 mustang when I was getting it ready for paint.
One can purchase a copy of the Jeep factory work manual for any model from eBay , costs vary from $5 to 35 they can be worth a great deal more to someone hunting down a problem.
What color is an R12 port on a 1995 jeep grand Cherokee?
A 1995 Jeep uses R134a, not R12. The caps are grey or black.
What kind of oil are you supposed to use for a 2006 jeep grand Cherokee?
3.7L, and 4.7L use 5w30
5.7L uses 5w20
6.1L uses 5w40 full synthetic
How many quarts of oil for a 2008 jeep grand Cherokee 4.7 v8?
five It may very well be five, but to be sure. Park vehicle on level surface. Drain oil and change filter. Add 4.5 quarts, start engine and run for 45 seconds. Shut down and wait 45 minutes. Check oil level and add as necessary. You now know the capacity. Do not overfill.
What kind of transmission does the 2004 Jeep Grand-Cherokee have?
The 2004 Jeep Grand-Cherokee has a 4-speed automatic.
What is the gross vehicle weight of the 2002 Jeep Grand-Cherokee?
The gross weight of the 2002 Jeep Grand-Cherokee is 5150 lbs..
u joint on drive shafts
How does the emergency brake work on a 2003 Jeep Grand Cherokee?
The emergency or parking brake on 2003 Jeep Grand Cherokee operates a set of brake shoes inside a hub on the rear axles, this is incorporated into the disc brake setup.
Does a 2006 Jeep Grand Cherokee have grease fittings?
A 2006 Jeep Grand Cherokee did not have any grease fittings from the factory.
First do a transmission filter and fluid change. Be sure you use the proper fluid to refill the trans. It seems to call for ATF+3 for the fluid type. If this does not fix it, then you will need to have it checked at a trans shop. They can look to see if it is only a sticky solonoid or needs replacement.
How many oxygen sensors does a 2003 jeep grand Cherokee have?
It depends if it is a California emissions model. If it is not there should be 2 O2 sensors. One before and one after the cat. converted. If it is a Cali emissions model then there are most likely 4 O2 sensors. Two before the 2 mini cat. converters and 2 downstream of the cat converters. The check engine error codes will tell you which bank and sensor number.
I have a Grand Cherokee limited 2004 Cali model and there are 4 O2 sensors.
The link (in realted links sections) will show you where the o2 sensors are located and how to change them.
Where is the radiator fan relay on a 2001 Jeep Grand Cherokee?
On my 2000 grand cherokee, It was in front of the battery on the fender wall. Remove battery and you should find it. It is under the bumper cover, under the passenger head light. You either have to remove the front bumper, or you remove the headlight and cut an access hole.
Why does the ABS warning light stay on in a 1998 Grand Cherokee?
The computer has detected a problem with the Anti-Lock Brake System, (ABS). Your ABS may or may not be functional. Have this looked at by a professional.
maybe, your brake calliper isn't releasing all the way. if your not mechanically inclined don't let it go, can be very costly.
How do you replace the rear windshield wiper and wiper arm on a 2005 jeep grand Cherokee?
I do not have the answer for the wiper arm, however I have an answer for the wiper blade:
1. Be sure you get the right replacement wiper blade. The 2005 Jeep Cherokee has a special 14" rear wiper blade that fits the special rear arm. You can go to your dealer (which may be expensive) or you can look into 'Trico Exact Fit Rear Integral Blades' that snap right onto the special arm and look just like the factory original. They're available online.
Note that just because its a special arm, does not mean its hard to change.
Important: When buying windshield wiper blades be sure to always look up your make, model and year in the application guide book at the store
There are two screws holding it in. It is located underneath the glove box. Now Depending on if you have manual controls or auto controls will determine what you have to do.
For auto controls the blower motor resistor gets plugged in with 3 wires (i believe its red black and orange) and then has two wires coming out of it that plug directly into the blower motor(red and black).
For manual controls it is just plugged in and mounted. The purpose of the resistor is to eat up the juice of the battery to control the speed of the blower motor.
