Jeep

A 1993 Jeep does not have a reset switch.

there are short torx bolts and flat nuts made specifically for mounting the frame to the body.

The windshield rail is held on with screws.

no and it's better than a jeep in off road and luxury

The Land Rover is a British designed vehicle that has nothing whatsoever to do with Jeep. Land Rover is now owned by Tata Motors of India.

The governor pressure sensor is on the passenger side of the valve body inside the transmission.

The seventeen digit VIN was not used until 1981. The serial number is all there is on a 1958.

Was built for R12, should be converted to R134a.

it is in KPA, It is probably a Canadian made Jeep. Only Americans and i think China use PSI.

All engines have just one thermostat.

It depends on which 2.4l. The PT Cruiser has one. The Sebring has two thermostats.

Did you clean the tank? There could be a bunch of crap down there clogging up the pickup for the pump.

Better check your fan clutch, then maybe your water pump.

heck the fuse first, then the switch.

On the passengers side of the trans about even with the front of the door fan shaped switch held on by two bolts.

I suggest taking it apart and cleaning it before you think about replacing.

The switch is nearly $300

To remove, flatten out the retaining washer side under nut, remove large nut, remove smaller ( 14mm ) bolt on the adjustment side. Connector for the wires is top left of engine at the firewall, black connector with about 8 wires, you will need to snip 3 or so zip ties to get it free.

cleaning is easy, 6 screws in back, pull apart, clean out all that old grease, pay special attention to the two contacts on the sweeper arm, they should move in and out easily as they have springs underneath and are the man contacts, apply new di-electric grease and reassemble.

reassemble and align before tightening, easiest way is to put trans selector in R and move switch until reverse lights come on.

Yes

Surprisingly it was neither American Bantam nor Overland Willys, but Minneapolis-Moline that had the first vehicle dubbed "jeep". August 1940 at Camp Ripley, Minnesota, Seargent James T. O'Brien of the 109th Ordinance Company of the Minnesota National Guard noted the overall proficiency of the M-M UTX (a high speed 4 wheel drive tractor). Inspired by the "Eugene the Jeep" character in the Popeye comic strip, O'Brien first hung from the tractors radiator cap a sign painted with the word "Jeep", then painted the word "Jeep" itself on the flanks of the tractor. M-M lodged a formal complaint with the FTC but in May 1943 the FTC ruled in favor of American Bantam.

It will depend on the year, could be one, two, or four.

There was no AMC in '89

The rear brakes on a 1989 jeep should be self adjusting.

Tear the drums off and fix the seized or broken hardware.

Most likely the problem is the sending unit. A good way to verify it is to run an actuator test on the scan tool for the fuel gauge. If the gage goes through its full range then the sending unit is most likely the culprit.

In 80s jeep used some GM parts.

a company called Ididit makes columns.

What color do you need? I have a spare Tan one from a Grand Wagoneer

Not if your transfer case is a "Quadratrac". Use only Quadratrac fluid, otherwise the clutch packs will bind.

There are a couple basic types

The people who like the look of the jeep

and

People that actually buy them to go off road, the second group is easy to spot as there trucks are usually dirty.

Transport and guns are mounted on top of it and a man fires from the back.

The firing order is 1-5-3-6-2-4.

o believe mine has 3/8

www.4wd.com