0
Kia Sedona
The Kia Sedona is a rebadged variant of the four-door minivan Kia Carnival. Manufactured from 1998 to 2006, the Sedona comes with a 3.5 L V6 engine and a 4-speed automatic transmission.
894 Questions
Can you bypass the ac compressor on a Kia Sedona?
You will need to buy a replacement free-wheeling pulley that goes in place of the seized a/c compressor......
How many gallons are in a 2017 Sedona?
Assuming we are talking about the fuel tank, a 2017 Kia Sedona Minivan holds 21.1 US Gallons of fuel.
Why does a garage door opener not open?
Remote is not transmitting, codes are not set the same, receiver is not working, motor burnt out, no power to motor, drive chain jammed or broken, counterbalance spring broken, etc. No way to tell at long distance.
How do you find the low side service port on a 2002 kia sedona?
it is right next to the alternator an that is located on the passenger side under the hood behind the head light and has blue are turqusie cap that has l are c its the size of a nickel
How do you change the map light on a Kia Sedona?
The entire overhead console unit clips into a socket. The entire overhead console unit must be pulled down from the ceiling of the car. There is a single phillips-head screw towards the windshield that attaches the console to the ceiling. Once this screw is removed, use a small pry bar to pull down on the console on the opposite end. The console is held in with two or more metal clips that will disengage when you pull down with the pry bar. When I did this the other week, I was afraid I would break the console by pulling too hard, but it un-clipped an came right down. You will see the light bulbs clipped into the sockets. The sockets must be retracted from the console, then the light bulbs can be replaced. Do not squeeze the bulbs too forcefully, or they may shatter between your fingers!! Installation is the reverse of the above procedure.
How do you change the alternater on a 2002 Kia Sedona?
Disconnect the battery and wait for at least 30 minutes for the airbag system to go offline. (I actually think it takes less time, but better safe than sorry).
Simpler, less costly method than the original below:
1. Disconnect the battery.
2. Do not mess with the A/C connections this method has enough flexibility to maneuver the alternator without disturbing the connections too much.
3. Remove air intake housing, air hose, air filter housing, battery, and battery carrier. 4. Disconnect upper coolant hose bracket from the engine and it push up on top of the engine.
5. No need to disconnect the the A/C coolant lines. Just remove the brackets that mount them to the car body opposite the alternator. This will give you flexibility to move the radiator and mounting bolts.
6. Remove each of the fan housings; it is a tight fit to get them out. This should give you sufficient space to work on the alternator itself and remove it.
7. loosen the tension pulley, the one toward the firewall, no need to remove it but no big deal. Then loosen the bolt below it to help put the belt back on later.
8. Remove the alternator, disconnect the electrical and remove the mounting bracket that mounts to the engine. The long bolt on the bottom does not come all the way out but you can still remove the alternator with it wedged in the hole. Remember to put this one in first when you reinstall the new on;
9. Work the alternator carefully around the front of the engine and remove from the right side.
10. Installation is the reverse of these instructions.
Should take about 3-4 hours depending on how difficult it is to remove the fans (Recommend a nut driver with a flexible extension, especially for the bottom left bolt).
Disconnect the sensor and horns.
Remove the front, top support (the one above the radiator).
Remove the air conditioning system components in front of the radiator and alternator and cap them.
Drain the cooling system and remove the radiator.
Remove the alternator.
Reassemble with new alternator. (Add compressor oil to AC system and use new seals. Refill cooling system.)
Have AC system evacuated and recharged by a service professional.
(Optional but recommended) Drive to the nearest auto lot and trade the Sedona in for something not made by Kia or Hyundai... {;o)
.
Bell Rock in Sedona, Arizona, stands at an elevation of approximately 4,919 feet (1,491 meters) above sea level. The rock formation itself rises about 400 feet (122 meters) above the surrounding terrain. It is known for its distinctive bell shape and is a popular hiking and sightseeing destination in the area.
How do you fix a jammed seat belt on a Kia Sedona?
I have yet to read a good solution to this seemingly frequent problem with the back seat seat belt on many KIAs.
We have a 2007 KIA Rondo and the backseat middle seat belt has gotten stuck several times already. The first time we took it to the dealer, this time we (my wife and I) took it apart ourselves. My wife is very mechanically inclined and she was able to take the right side panel off the retractor
(the locking mechanism) first. Then you can see the small black release lever inside (you might have to search a little until you find it). Once you push back the release lever (be careful because it is small and plastic and
easily broken) the belt will disengage and you can pull it freely. In our situation, once I put everything back together, the seat belt was working properly again. I left the side panel off the retractor
just in case we have to do this again in the future.
Hope this helps someone out.
Why is the key stuck in the ignition switch in the ACC position?
if your pushing in the button to release the key the tumblers in ignition switch bad If you have an A/T, the shift linkage might be off alittle not letting the shifter go all the way into park. Your wheel lock could be keeping the key from turning. If your tires are turned, turn them further from straight while turning the key. I had the same problem and this fixed it.
The trim around the entire console can be pulled out by hand - CAREFULLY so you don't break the plastic clips that hold it in. Just pry it out at the bottom with your fingers, and work your way around until the whole thing pops out. Once you get the trim section loose, all of the controls except for the radio should come out with it, and you'll have enough room to access the plugs behind your A/C controls, as well as the cigarette lighter and the electric socket. When you're finished, press the whole thing back into place. Hope that helps.
What type of automatic transmission fluid does a 2002 Kia sedona van take?
Most of the Hyundai, Kia Mitsubishi are using SP-III, don't use Dex, it won't work.
How long will it take to drive from victorville to Sedona?
The approximate driving time and mileage information -
Between: Sedona, AZ
and: Victorville, CA
Driving miles: 410
Driving time: 6 hrs
- is based on traveling non-stop in good driving conditions. Driving time does not take into consideration conditions which may extend travel time such as weather, road work, border crossings, and rush hour traffic in urban areas. Mileage denotes actual road miles covered as opposed to Point A to Point B linear distances on a map.
Where is the windshield wiper delay relay on a Kia Sedona?
Down on the steering column behind a plastic shroud
What are car stereo wiring color codes for 2006 Kia Sedona?
Shown below are the pins wires coming out of the factory stereo head unit of a 2004 Kia Sedona.Pin 1Yellow Wire Fused Voltage SupplyPin 2Brown wire Interior Light SystemPin 3white Green Wire Right Rear Side speakerPin 4white Red Wire Right Front Door SpeakerPin 5Green Yellow Wire Left Front Door SpeakerPin 6Green Wire Left Rear Side SpeakerPin 7No connectionPin 8Yellow Black Wire Left Rear Side SpeakerPin 9Red Black Wire Interior lightsPin 10Blue Wire Right Rear Side SpeakerPin 11Yellow Black Wire Right Front Door SpeakerPin 12No connectionPin 13No connectionPin 14Green Black Wire Left Front Door SpeakerPin 15Pink Wire Left Rear Side SpeakerPin 16Black wire GROUND
OR
Battery Constant 12v+ Wire:Light GreenAccessory Switched 12v+ Wire:Black/YellowGround Wire:BlackIllumination Wire:Blue/YellowLeft Front Speaker Positive Wire (+):GreenLeft Front Speaker Negative Wire (-):Blue/RedRight Front Speaker Positive Wire (+):Light Green/YellowRight Front Speaker Negative Wire (-):Black/GreenLeft Rear Speaker Positive Wire (+):Green/YellowLeft Rear Speaker Negative Wire (-):Blue/OrangeRight Rear Speaker Positive Wire (+):Green/WhiteRight Rear Speaker Negative Wire (-):Green/Blue
What is it you want to know about the radio?
answer
I assume , you want to replace the radio in your sedona. follow the steps below.
Lift the Kia's hood and loosen the bolt holding the negative battery cable to the battery terminal with the wrench. Lift the cable from the battery and set it away from the terminals. Move to the inside of the car.
Pry the dash panel surrounding the gear selector lever away from the dashboard with the trim panel removal tool. Set the panel aside. Remove the two screws at the bottom of the stereo assembly dash panel with the Phillips-head screwdriver.
Remove the trim panel surrounding the stereo assembly from the dashboard by hand. Set the panel aside. Remove the four screws around the perimeter of the factory stereo with the screwdriver.
Slide the stereo from the dashboard stereo dock. Unplug the stereo wiring and antenna cable from the back of the unit. Plug the stereo wiring connectors into the plastic end connectors of the wiring harness adapter.
Insert the installation cage into the Kia's stereo dock. Fold the cage's metal tabs outward with the flat screwdriver. Pull the wiring harness adapter and antenna cable from the back of the dock, through the cage to the front of the dash.
Plug the wiring harness adapter leads into the outlets on the rear panel of the new stereo. Plug the antenna cable lead into the antenna input on the back of the aftermarket unit. Slide the stereo into the cage until it snaps into place within the stereo dock.
Place the larger of the two removed dash panels onto the dashboard around the stereo assembly. Press against the panel to snap it into place. Replace the two screws at the bottom of the panel with the Phillips-head screwdriver.
Place the remaining dash panel onto the dashboard below the stereo. Press against the panel to snap it back into place on the dashboard. Return to the Kia's engine compartment.
Place the battery cable's clamp back onto the negative battery terminal. Tighten the bolt on the cable's clamp with the wrench. Close the hood.
How do you change 3rd brake light bulb on 04 kia sedona?
Pull the cover towards you (away from the glass). Then just twist the bulb sockets counter-clockwise about 45 degrees and pull down.
What is the maximum towing capacity of the 2003 Kia Sedona?
The maximum tosing capacity of the 2003 Kia Sedona is 3500 lbs..
How do you program a Kia Sedona remote?
You can program your Kia Sedona remote, by holding the lock and unlock keys at the same time. The red light will flash until the remote is program. When the remote is program. The red light will stay constant.
