Where is the transfer case control module on a 04 Tahoe?
Under left side of dash, small black box 3 x 5 with 3 electrical connections.
What type of transmission fluid goes into a Kia Sorento?
the type of fluid required varies by model year....check the fluid specifications section of the owners manual
How in the 2011 kia sorento is the ignition put into ACC mode for push button start vehicles?
Press the ENGINE START/STOP button once without depressing the brake pedal
What is the curb weight of the 2011 Kia Sorento?
The curb weight of the 2011 Kia Sorento is 3763 lbs..
How do you remove dashboard Kia Sorento?
This can take a lot of effort. With the users manual, you can take it off with the proper tools.
What is the angle of departure of the 2003 Kia Sorento?
The 2003 Kia Sorento has a 26.7 degrees angle of departure.
What is the curb weight of the 2013 Kia Sorento?
The curb weight of the 2013 Kia Sorento is 3845 lbs..
How do you adjust the brake caliper on a 2006 Kia serento?
you don't brake calipers are hydraulic & cannot be adjusted
Where is the camshaft position sensor on a 2005 Kia Sorento?
under upper timing belt cover, driver side 3.5 eng
How do you replace 2003 Kia Sorento camshaft position sensor?
disconnect the negative battery cable, as your looking at the motor from the front, the driver's side will be on the right. remove the top cover of the engine,6 10 mm bolts. you will see 2 almost identical plugs one on top of the other, one will have a notation or same part code as your new one ,ck sensor is crank sensor and cam sensor is a diff number. if you follow the wire from the cam sensor it will lead to just under the upper black plastic timing cover which has 2 0r 3 ten mm bolts,once you remove those you can wiggle that cover off and see the cam sensor behind the timing belt. you should be able to remove the two ten mm bolts holding it in and replace the sensor, good luck.I am not as fortunate ,I had to replace the crank sensor which was more extensive as it is behind the lower timing cover and one bolt is behind the hydraulic belt tensionerpulley and had to be released and move out of the way successfully without removing the radiator or timing belt.
What happens if a fuel injected car runs out of gas?
Well first of all it stops. However you may be more concerned about whether or not it will start when refilled with fuel. From my experience the fuel injection system is self priming and needs no further intervention once the gas tank is refilled. This may not be true of diesel powered vehicles of which I know very little.
Where is the oil filter and drain plug in a 2006 Kia Sorento?
The drain plug is located somewhere on the bottom of the engine. Usually on the rear or side of the oil pan. Filter is screwed on to the engine block. No offense, but if you cannot find the drain plug & filter, you have no business trying to change your own oil. AT LEAST YOUR TRYING, FILTER AND PLUG WILL BE VISIBLE ONCE YOU REMOVE PLASTIC COVER UNDER VEHICLE. IT HAS 5 BOLTS AND IS IN FRONT OF ENGINE CROSSMEMBER. FILTER IS UP FRONT ON LEFT HAND SIDE COMING STRAIGHT DOWN FROM ENGINE.
How much hp does a KIA Sorento have?
The 2014 came with either a...
2.4L Inline 4 - 191 hp @ 6,300 rpm / 181 lb-ft or torque @ 4,250rpms
3.3L V6 - 290 hp @ 6,400 rpm / 252 lb-ft @ 5,200 rpms
How wide is the 2012 Kia Sorento?
The 2012 Kia Sorento is 6 ft. 2.2 in. (74.2 in.)1 one-touch power windows wide.
What ground clearance does the 2006 Kia Sorento have?
The ground clearance of the 2006 Kia Sorento is 0 ft. 8.2 in. (8.2 in.).
What is the gross vehicle weight of the 2012 Kia Sorento?
The gross weight of the 2012 Kia Sorento is 4828 lbs..
What is the gross vehicle weight of the 2014 Kia Sorento?
The gross weight of the 2014 Kia Sorento is 4807 lbs..
Crankshaft sensor for a 2003 Kia Sorento?
The crank sensor is behind the lower timing cover just above the center of the harmonic balancer.You must move the ac pulley the power steering pulley,the water pump pulleythe upper timing cover,the lower timing cover and you will follow the pig tail (wire) of the ck sensor to it's resting place on top of a brass looking blade just above the harmonic balancer.Two bolts which are 10mm hold it in place. you might have trouble getting the left one out,as it is behind the hydraulic timing belt tensioner and you don't want to take that off.I depressed the piston on the hydrolic tensioner enogh to move the pulley and belt just slightly enough to access that left bolt and then fished it out very slowly.Good luck. Don't forget to disconnect the battery before starting the job and you might have to get some radiator hoses out of the way and put some drain pans under to catch it,watch out for bees they might be attracted to the coolant and watch out for animals as it is harmful to them filter and recycle coolant.
How do you program a keyless entry remote for 03 Kia Sorento?
Steps:
How do you unstuck the center tray above the ashtray in a 2006 kia sorento?
Open the tray below and you can pry the two vertical side pieces of trim off. This will give you access to the screws holding the trays in place. Remove the screws, then the stuck tray, this should allow you to remove whatever is jambing the tray.