0
Mitsubishi Galant
The Galant is a car built by Japanese automaker Mitsubishi. The car was launched in December 1969 as “Colt Galant.” It is available as a two- and four-door sedan and features a choice of 1.3 or 1.5 L four-cylinder engines.
1,291 Questions
Why does your gas heater make a clicking noise every 60 seconds?
I personally am not sure either why mine might be making that exact noise itself.
However futile this response may be, I had to response in order to delete that immature "xcxcx" that some proud imbecile left in order to probably look "cool" or giggle himself to sleep.
Ahem,
with that said, I would advise you to personally ask at Yahoo!Answers, Other online services, or go to your local maintainance section.. (trying to be creative here :P)
And above all, if you have discovered the reason to it... (don't forget to tell ME! lol)
(Feel free to post here...) >>>> If your furnace does not have a standing pilot and this occurs at exact 60 second intervals it sounds to me as if the flame sensor has lost it`s signal and the ignition module is trying to relight the furnace. 60 seconds is the typical waiting period before a retrial for ignition following a flame failure.
How do i change the spark plugs in a 1995 mitsubushi galant?
IF YOU HAVE A 4G64/G OR /L, THE SPARK PLUGS ARE CONTAINED UNDER THE VALVE COVER. YOU WILL SEE THE PLUG WIRES TERMINATING WITH A LARGE(1" TOP & 1-5/8" BOTTOM) ROUND CONNECTOR "TUBE". THIS DEVICE IS SOMETIMES VERY DIFFICULT TO REMOVE. THE BEST METHOD IS TO REMOVE THE PROPER WIRE FROM THE WIRE LOOMS (FOR WIRE SLACK) AND FIRMLY GRASP THE UPPER PORTION OF THE TUBE "NOB" AND WORK BACK-FORTH WHILE PULLING UPWARD. A "PRYING" DEVICE MAY BE USED IF EXTREME CARE IS TAKEN NOT TO DAMAGE THE RUBBER "NOB". ONCE LOOSE, PULL THE TUBE UPWARD AND OUT OF THE OPENING. IT MAY REQUIRE SOME "WORKING" TO GET THE TUBE COMPLETELY OUT, IF THE PLUG WIRES ARE SOMEWHAT SHORT-REMOVING THE WIRE @ THE DIST. WILL FACILITATE THE EASE OF REMOVAL.
YOU WILL NEED AN EXTENSION AT LEAST 6" LONG WITH A "LOCKING" MECHANISM TO HOLD THE SPECIAL "SPARKPLUG" SOCKET (5/8" DEEP). THE SPECIAL S-P SOCKET WILL HAVE A RUBBER INNER CORE TO GRASP THE PLUG TO PREVENT IT FROM FALLING FROM THE SOCKET-IF YOU LOSE A PLUG INSIDE, YOU WILL BE FORCED TO REMOVE THE VALVE COVER!!
ONE HINT HERE: YOU DON'T NEED TO "BUY" A SPECIAL 5/8" S-P SOCKET. WHAT I DID WAS
TO REMOVE THE SHORTER WIRE FROM THE DIST., LOOSEN THE PLUG TUBE, LOOSEN THE PLUGS CAREFULLY, PULL OUT THE SOCKET, INSERT THE TUBE ONTO THE LOOSENED PLUG AND SLOWLY/CAREFULLY REMOVE THE PLUG. INSERTING THE NEW PLUG INTO THE TUBE AND CAREFULLY INSERTING IT INTO THE OPENING AND TURNING TH TUBE UNTIL IT TIGHTENS (PULLING UPWARD EASILY WILL SHOW IF THE PLUG HAS STARTED THREADING). I HAVE USED THIS METHOD TWICE WITH GREAT RESULTS.
How do you disable the anti theft on a 2002 Mitsubishi galant?
take the anti- theft fuse out located under the hood in the fuse box
How do you replace the front headlight bulb on a Mitsubishi galant es?
This question did not specify a year, as for the 2000 Galant ES it's fairly simple. You will need a flat head screw driver to remove the light bulb connector from the light bulb. The light bulb is held to the connector with a locking tab, you will need to use the screw driver to free the bulb from the locking tab on connector. Once free you can just pull the light bulb from the rubber housing. Replace with new bulb making sure you do not touch light bulb glass with hands (the grease of your hands sometimes shortens the lifespan of the bulb) snap in connector and you're done.
Your 2006 galant has an error code on the radio saying e dc?
my 2006 galant is doing the same thing did you find out what was causing this?
Do you need a mechanic to replace an egr valve on a 2004 Mitsubishi galant?
No you do not! th egr valve is located just under the throttle body. there are 2 10mm bolts holding it in, you just need to remove air intake to the throttle body! it is directly under it!
Answer You might want to ask your question under the heading of Arts and Entertainment. This section is related to dating questions only, not who's dating who.
What is the biggest rim that will fit a 1999 Mitsubishi galant?
20's will fit fine 18 looks good but with light mods I've heard of people putting 22s on it.
Have your timing belt condition checked IMMEDIATELY. My Galant was doing the same thing and I wasted $hundreds replacing motor mounts with no improvement. What happens is, the timing belt gets old and starts losing teeth, allowing the harmonic balancer to go gradually more and more out of correct position, which causes the car to shake like an off-balance washing machine. Make sure that the mechanics put your balancer back in correct position when they replace your timing belt (unlike the idiots who did mine)...
Which fuse controls the lights behind the speedometer and gauges on a 1999 Mitsubishi Galant?
I also have this problem. The fuse is in the fuse box under the hood. For sum reason mine keeps blowing out thouge. Check ur fuses under the hood. one of em is blown.
Does the 2003 galant have a chip in the key?
yes,im not sure if model matters but the chip is in the rubber part of the key,there should be a black and a grey key(valet key) for the 1999 and up models.dont set your keys on any magnets
Diagram for oxygen sensor location 2003 Galant?
there are 2 oxygen sensors on this car. the first is on the front of engine where it is mounted in the exhaust monifold. the second one is on the exhuast pipe right next to the cat. converter. you can't miss em, they stick out about 2 inches, and there is a wire connected.
Where is the Anti Theft code on the 1997 Mitsubishi Galant radio system?
Hi,
Look for the serial number on the radio, it starts with a number total of 8 numbers including one letter and call Mitsubishi Motors of north America at 1 888 648 7820. They will give you your unlock code for free. DO NOT PAY ANYONE FOR THIS CODE IT IS A FREE SERVICE!!!!
Where do you install a blowoff valve on a 1998 galant vr4?
At the front of the car by the front left wheel, if you can get under there you should see it, you don't even have to pop the bonnet
How do you turn off the auto lights on an 07 Mitsubishi Galant?
i have found the answer in the owners manual on some galants and others the dealer had to do it hooked up to a computer.
What is the oil capacity of a 1996 Mitsubishi galant 2L?
i do not have a listing for a '96 2.0 L. the '96 1.8 L is 4.0 qts. w/filter and the '93 2.0 L is 4.1 qts.
i have always used the "rule of thumb" with all my engines (426 hemi, 340 dodge, 327 Chevy, 454 Chevy, 283 Chevy, 4.3 Chevy and 2.4 galant) drain oil, remove filter, install filter.
put in 4 qts. oil, check oil level via dipstick. if it shows about 1 qt. low, add 1 qt. oil, start engine, run about one minute to circulate oil. stop engine, wait 2-3 minutes for oil return.
check dipstick and add oil to the full mark.
if it were me, i would drain oil, remove filter. replace filter, add 4 qts. oil and check oil level. it won't be too full as to cause any harm.
What kind of oil does 2003 Mitsubishi Galant take?
2003 Mitsubishi Galant 2.4L four cyllinder or 3.0L V6 sold in Canada and US comes with 5W30 engine oil from the factory.
Full synthetic is strongly recommended if car is used for city driving or prolonged idling.
Why won't the wipers work on a 1999 Escort after they iced up once?
Check the fuse in that circuit. If they are ok, then check to see if the motor is working. If the motor is working, then the agitator/gearbox is damaged, and need replacement. Get a new motor assembly from a salvage yard. Tim has covered the solution to the problem. As for the answer to the question: When the wiper motor was turned on while the wipers were covered with ice, the fuse probably blew because the motor shaft was locked, resulting in high current.
Check the condition of your window and door seals, look for cracks and hardness, also if this occcurs even when it doesn't rain you might want to check your heater coil
