0
Plymouth Acclaim
The Plymouth Acclaim was a mid-size four-door sedan manufactured by Chrysler Corporation from 1989 to 1995. The car was the upgraded replacement of the E-body Caravelle. It was also offered in high-end LX and mid-range LE trims.
361 Questions
What are the valve timing mark's for a 1994 Plymouth Acclaim?
what are the vavle timing mark's for a 1994 Plymouth acclaim
In a 1993 Plymouth Acclaim, the relay switch for the headlights is typically located in the engine compartment fuse box. You can identify the relay by referring to the fuse box cover, which usually has a diagram indicating the location of various relays and fuses. If the headlights do not turn off, the relay may be stuck in the "on" position, and replacing it could resolve the issue. Additionally, you should check the headlight switch and associated wiring for any faults.
Where is the starter located on a 1990 Plymouth Acclaim?
The starter on a 1990 Plymouth Acclaim is located on the lower side of the engine, near the transmission. It is positioned towards the rear of the engine bay, mounted to the engine block. To access it, you may need to lift the vehicle and remove any components obstructing the starter, such as the battery or heat shield.
Where do you put the power stirring fluid in your 1990 Plymouth Acclaim?
To add power steering fluid to your 1990 Plymouth Acclaim, locate the power steering reservoir, which is typically found near the front of the engine compartment, on the driver's side. The reservoir cap usually has a steering wheel icon or is labeled "Power Steering." Remove the cap, check the fluid level with the dipstick attached to the cap, and add the appropriate power steering fluid as needed. Be sure to replace the cap securely after adding fluid.
How do you remove the radio of a 1992 plymouth acclaim?
To remove the radio from a 1992 Plymouth Acclaim, first, disconnect the negative battery cable to ensure safety. Then, carefully remove the dashboard trim panel surrounding the radio by prying it off with a flathead screwdriver or trim tool. Once the trim is removed, unscrew the radio mounting screws, disconnect the wiring harness and antenna cable, and gently pull the radio out. Make sure to keep all screws and clips in a safe place for reinstallation.
What is trouble code 52 on 1995 Plymouth acclaim?
Trouble code 52 on a 1995 Plymouth Acclaim indicates a problem with the fuel pump relay circuit. This code typically suggests that the engine control module (ECM) has detected an issue with the fuel pump's operation, which could be due to a faulty relay, wiring issues, or a malfunctioning fuel pump itself. It's important to diagnose the specific component causing the issue to ensure proper fuel delivery to the engine. Checking the relay and associated wiring would be a good starting point for troubleshooting.
How Replace oil pan in 89 Plymouth acclaim?
To replace the oil pan on a 1989 Plymouth Acclaim, start by draining the engine oil and removing the oil filter. Next, lift the vehicle and support it securely, then remove any components obstructing the oil pan, such as the exhaust or crossmember. Unscrew the oil pan bolts and gently pry the pan off, cleaning the mating surfaces. Install the new oil pan with a new gasket, torque the bolts to the specified settings, and refill the engine with oil.
